Larson Electronics EXP-MS-N4X-AT-HV Bedienungsanleitung

Part # EXP-MS-N4X-AT-HV

Larson Electronics, LLCPhone: (800) 369-6671 Fax: (903) 498-3364www.larsonelectronics.com

1of 3

EXP-MS-N4X-AT-HV

Explosion Proof Motion Sensor

Instruction Manual

Thank you for your purchase of the EXP-MS-N4X-AT-HV Motion Sensor, the following instructions are intended for this

part number only.

Installation

This unit is easily wall mounted via integral mounting bracket, which can be adjusted -90° to +30° vertically after

installation. The explosion proof housing provides two 1/2" or 3/4" hub openings located on either side of the housing for

running electrical conductors in a feed through configuration. A bushing seal at each conductor opening prevents

damage to wiring insulation.

This unit is designed to operate on 120V, 208V, 220V, 240V, or 277V AC electrical circuits. We also carry low voltage

12-24V AC or DC electrical systems. This motion sensor is suitable for use in environments where combustible dusts

and particulates may be present. 1/2" or 3/4" NPT tapped conduit openings are provided on either of the unit in feed

through versions while dead end versions have a single conduit hub, providing easy and secure connection to main

power line supplies.

The EXP-MS-N4X-AT-HV operates like a standard on/off light switch. The circuit is normally open when no motion is

present. Once motion is detected, the internal switch changes to a closed circuit, allowing voltage to pass through the

sensor and power the device(s) at the other end.

The sensor is an active motion detector; it emits high-frequency electro-magnetic waves (5.8GHz) and receives their

echo. The sensor detects the change in echo from even the slightest movement in its detection zone. A microprocessor

then triggers the “switch light ON” command. Detection is possible through doors, panes of glass or thin walls.

IMPORTANT: persons or objects moving towards the sensor are detected best.

NOTE: the high frequency of the output of this sensor is <10Mw – that is just one 100th of the transmission

power of a mobile phone or the output of a microwave oven.

Part # EXP-MS-N4X-AT-HV

Larson Electronics, LLCPhone: (800) 369-6671 Fax: (903) 498-3364www.larsonelectronics.com

2of 3

MOTION SENSOR

Operating voltage

Rated load

HF system 5.8GHz±75MHz, ISM wave band

Transmitting power <0.5mW

Power consumption ≤0.5W(standby)

Detection zone Max.(D x H): 16m x 15m

Detection sensitivity 25% / 50% / 75% / 100%

Hold time 5s / 30s / 90s / 3min / 20min / 30min

Daylight sensor 5Lux/15Lux/30Lux/50Lux/100Lux/Disable

Mounting height 15m Max.

Motion detection 0.5~3m/s

Detection angle 150°(wall installation)

360°(ceiling installation)

Operating temperature -20℃~60℃

IP rating IP20

Setting

ON ON

ON ON ON

ON ON

ON ON ON

III

1 2

100%

75%

50%

25%

III

3 4 5

30s

90s

3min

20min

30min

6 7 8

Disable

50lux

15lux

5lux

30lux

III

Detection area can be reduced by selecting the combination on the

DIP switches to fit precisely each application.

Refers to the time period the lamp remains at 100% illumination after

no motion detected.

The sensor can be set to only allow the lamp to illuminate below a

defined ambient brightness threshold.

When set to Disable mode, the daylight sensor will switch on the lamp

when motion is detected regardless of ambient light level.

30lux, 50lux,100lux,:twilight operation, 5lux, 15lux: darkness operation only.

By selecting the combination on the DIP switch, sensor data can be precisely set for each specific application.

100lux

ON ON

When set to Disable, the microwave sensor function is inactive, lights turns on or off

by switch.

When set to Sensor, the microwave sensor function is active.

Detection area

Hold time

Daylight sensor

Mode

Part # EXP-MS-N4X-AT-HV

Larson Electronics, LLCPhone: (800) 369-6671 Fax: (903) 498-3364www.larsonelectronics.com

3of 3

Certifications - Compliance

- Class I, Divisions 1 & 2, Groups B, C, D

- Class I, Zones 1 & 2, Groups IIB+H2, IIA

- Class II, Divisions 1&2, Groups E,F,G

- Class III, Divisions 1&2

- Ex db IIC Gb

- Ex tb IIC Gb Db IP66

- NEMA 3,4,4X,7 (B,C,D), 9 (E,F,G)

Malfunction

Cause

Remedy

The load will not work - wrong light control setting selected

- load faulty

- mains switch OFF

- adjust setting

- change load

- switch ON

The load is always working - continuous movement in the

detection zone

- check zone setting

Load works without and identifiable

movement

- sensor is not mounted for detecting

movement reliably

- movement occurred, but not

identified by the sensor (movement

behind a wall, movement of small

object in immediate vicinity etc.)

- securely mount enclosure

- check zone setting

The load will not work despite

movement

-rapid movements are being

suppressed to minimize

malfunctioning or the detection zone

you have set is too small

-check zone setting

THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS. SHOULD FURTHER

INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT SALES@LARSONELECTRONICS.COM OR BY PHONE AT

1-800-369-6671 FOR FURTHER ASSISTANCE.

PLEASE VISIT LARSONELECTRONICS.COM FOR WARRANTY AND RETURNINFORMATION.

Andere Larson Electronics Zubehör Handbücher

Larson Electronics

Larson Electronics EXP-MS-30W-N4X Bedienungsanleitung

Larson Electronics

Larson Electronics SLEDB-110V-30C-XMS Bedienungsanleitung

Larson Electronics

Larson Electronics EXP-DNMS-N4X-AT-HV Bedienungsanleitung

Larson Electronics

Larson Electronics EXP-MS-N4X-AT-LV Bedienungsanleitung

Larson Electronics

Larson Electronics ATEX-EXP-DNS-400W-M20-HV Bedienungsanleitung

Larson Electronics

Larson Electronics EXP-MS-N4X-AT-HV-V6 Bedienungsanleitung

Larson Electronics

Larson Electronics EPLTS-T8 Bedienungsanleitung

Larson Electronics

Larson Electronics IND-TBL-BX-R13-UVC-120V Bedienungsanleitung

Larson Electronics

Larson Electronics IND-HL-HDB-FUVC-EX-1L-120V-15C Bedienungsanleitung

Larson Electronics

Larson Electronics XLE-PA-IP20-CS.50-50A-3PH-250V-3P4W-B Bedienungsanleitung

Larson Electronics

Larson Electronics EXP-MS-30W-N4X-SFC Bedienungsanleitung

Larson Electronics

Larson Electronics EXP-MS-N4X-AT-HV-V5 Bedienungsanleitung

Larson Electronics

Larson Electronics SLEDB-277V-30C-XMS Bedienungsanleitung

Larson Electronics

Larson Electronics EXP-AKC-MS-N4X-AT-LV-12V Bedienungsanleitung

Larson Electronics

Larson Electronics MDSEN-IR-277V-R2 Bedienungsanleitung

Beliebte Zubehör Handbücher anderer Marken

Hillco

Hillco 2810 Bedienungsanleitung

Siemens

Siemens QSA2700D Bedienerhandbuch

Contours

Contours ZY024 Bedienungsanleitung

Saivod

Saivod VS621 Bedienungsanleitung

Virtuox

Virtuox VirtuCLEAN 2.0 Bedienungsanleitung

SCE

SCE ENVIRO-THERM SCE-TE170B24VSS Bedienungsanleitung

Z-Wave

Z-Wave HSD-200Z Bedienungsanleitung

turck

turck FMX-IM-2UPLI63FX Bedienungsanleitung

Decagon Devices

Decagon Devices 10HS Bedienungsanleitung

UPPAbaby

UPPAbaby Cup Holder Bedienungsanleitung

Elko

Elko SmartSensor Leakage Wireless Bedienungsanleitung

Grizzly

Grizzly H8371 Bedienungsanleitung

Panasonic

Panasonic HG-T Series Bedienungsanleitung

IFM Electronic

IFM Electronic Efector 250 Series Referenzhandbuch

DigiDesign

DigiDesign 888/24 I/O Bedienungsanleitung

PROZIS

PROZIS QUAY Bedienungsanleitung

patagonia

patagonia PSI Vest Bedienungsanleitung

SFC Energy

SFC Energy EFOY GO! Bedienungsanleitung