Larson Electronics EPL-48-2L-LED-BLC Bedienungsanleitung

EPL-48-2L-LED-BLC

Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com

1of 2

Explosion Proof LED Paint Spray Booth light

C1D1 - C1D2 - T6 - 7,000 Lumens - Overspray Cover

Instruction Manual

WARNING: Do not attempt installation until you are familiar with all warnings, precautions, and procedures

outlined within this instruction sheet.

INSTALLATIONPRECAUTIONS

•Do not install fixture in any classified location where the marked operating temperature exceeds the ignition

temperature of the hazardous atmospheres.

•Consult fixture nameplate for the suitability ambient temperature shown on the nameplate.

•Refer to fixture nameplate for minimum supply wire temperature rating.

•Verify that the supply voltage agrees with fixture rating as indicated on nameplate.

•All local and national electrical/building codes must be followed when installing this lighting fixture. For

code interpretation, consult your local authority.

•Product must be used only with glass tubes intact and all cap threads fully engaged. Do not use if glass tubes

are cracked or damaged.

Caution: Only use lamp size, type and /or wattage as shown on fixture nameplate.

INSTRUCTIONS FOR INSTALLING

We strongly recommend that only a licensed electrician install this product.

WARNING: Make sure that the power is disconnected before installing. This fixture is extremely heavy and must be

mounted to a surface that can structurally support the load.

NOTE: This fixture requires a minimum of 50 inches of clearance from re-lamp end for lamp replacement. An optional

drop mounting kit that will allow for end to end row mounting is available, please consult factory.

WARNING: Do not let fixture hang on one bracket at any time. Failing to comply can result in breakage of

end casting or mounting bracket, allowing the fixture to fall, which can cause serious injury or death.

•The mounting brackets are shipped installed on the

fixture.

•Install the brackets to wall or ceiling with two 3/8" bolts

(not supplied) at center measurements.

•Fixture is now ready for mounting.

•For pendant mounts, see reference image.

It is strongly suggested to use two licensed electricians to

proceed with the final mounting of the fixture to avoid any possible personnel injury or damage to the fixture as the unit

weights up to 46lbs (21.0 kg) and will be slightly awkward to hold in position and attach to brackets mounted on wall or

ceiling. Depending on mounting height and scaffolding, a hydraulic man–lift or two good quality ladders should be used.

INSTRUCTIONS FOR WIRING LAMP

•Remove the upper center screw cap on the re-lamp end (field wiring compartment).

•Install approved cable connector or conduit fitting into ½" NPT hub on field wiring compartment.

•Install a three conductor cable into the connector, allowing 3 inches of wire inside compartment for connection.

•Using approved wire connectors, splice wires as per color codes: black to black (line) white to white

(common) and green to green (ground).

•Replace end-cap, making sure there are no wires protruding that may be pinched causing a possible short

circuit.

WARNING: Fixture must be grounded as required per paragraph 410-21 and article 250 of the National Electric Code

and/or rule 30-500. Failure to properly ground this fixture will create an electrical shock, which can cause serious injury

or death.

PENDANT (-PND)

SURFACE (-SFC)

EPL-48-2L-LED-BLC

Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com

2of 2

INSTRUCTIONS FOR RELAMP

Caution: Only use lamp size, type and/or wattage as shown on fixture nameplate.

1. Disconnect power to the fixture prior to servicing. FIGURE 1

2. With a wrench, remove end-cap (lamp access cover) for the lamp you wish to replace.

Rotate counter-clockwise. FIGURE 2

3. Loosen the two lamp holder bracket screws holding the old lamp.FIGURE 3 Twist and

remove the lamp holder bracket. FIGURE 4

4. Remove the old lamp and install the new lamp, seating lamp in opposite lamp holder.

FIGURE 5

5. Replace lamp holder into position on the lamp. Twist slightly to place the lamp holder

bracket under screw heads and tighten the screws. FIGURE 3

6. Reattach end-cap. Rotate clockwise. FIGURE 6

WARNING

To avoid risk of fire, explosion or electric shock, this product should be maintained by a qualified electrician only, in

accordance with all applicable codes and regulations.

To avoid electric shock: Be certain electrical power is OFF before and during maintenance.

FIGURE 1

FIGURE 2

FIGURE 3

FIGURE 4

FIGURE 5

FIGURE 6

EPL-48-2L-LED-BLC

Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com

1of 1

REPLACING POLYCARBONATE LENS

FOR EPL MODEL COVERS

The polycarbonate lens cover is intended to protect the lamps from paint overspray. Simply replace

the polycarbonate lens cover when dirty instead of the glass pyrex lens tubes. Replacement

overspray covers may be purchased from Larson Electronics, Part Number: EPL-48-2L-187-RL

Follow the basic steps below.

1. Replacing lens: Grasp one side and pull away from lamp to remove old lens.

2. Install polycarbonate lens: Start with one side and insert lens under the lip of lamp.

3. Attach polycarbonate lens to the other side under the opposite lip.

A mild soap and water can be used keep the lens clean and clear. If the lens becomes dirty beyond

cleaning, the polycarbonate lens can be removed as easily as it was installed.

THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS.

SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT

SALES@LARSONELECTRONICS.COM OR BY PHONE AT 1-800-369-6671 FOR FURTHER ASSISTANCE.

PLEASE VISIT LARSONELECTRONICS.COM FOR WARRANTY AND RETURN INFORMATION.

Inhaltsverzeichnis

Andere Larson Electronics Beleuchtungsausrüstung Handbücher

Larson Electronics

Larson Electronics WDL-12-70W-LED-SFC-WCM Bedienungsanleitung

Larson Electronics

Larson Electronics LEDB-4-IR Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-TL-1X10W-C-DF-PA Bedienungsanleitung

Larson Electronics

Larson Electronics IND-LP-SS-24-2X2-2L-UVC Bedienungsanleitung

Larson Electronics

Larson Electronics LEDWP-600E-M-E2E-20C Bedienungsanleitung

Larson Electronics

Larson Electronics SPLED-QP-1X10WRE Bedienungsanleitung

Larson Electronics

Larson Electronics TPM-2XWP60E-25C Bedienungsanleitung

Larson Electronics

Larson Electronics PML-15 Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-SL-5-FL26 Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-16C-1MLED-50 Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-HB-150LED-RT-JB2-25-BCE Bedienungsanleitung

Larson Electronics

Larson Electronics EXHL-TRN-LE4-FKWL Series Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-PM-150LED Handbuch

Larson Electronics

Larson Electronics EPLC2-EMG-HB-150LED-RT Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-PT-150LED Bedienungsanleitung

Larson Electronics

Larson Electronics PTB-1-75FT Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-LQP-2X150RT Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-HB-150LED-RT Bedienungsanleitung

Larson Electronics

Larson Electronics EPLC2-HB-150LED-RT-CM Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-FL1524-100 Bedienungsanleitung

Larson Electronics

Larson Electronics C1D2 Bedienungsanleitung

Larson Electronics

Larson Electronics WAL-ML-2XM-3G Bedienungsanleitung

Larson Electronics

Larson Electronics HALD-48-1X4-2X50LED-DIMM Bedienungsanleitung

Larson Electronics

Larson Electronics GL-2051-F-M Bedienungsanleitung

Beliebte Beleuchtungsausrüstung Handbücher anderer Marken

Brizo

Brizo 8SP-MU-4 Bedienungsanleitung

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Bedienungsanleitung

IKEA

IKEA BJÖRKSPIREA Bedienungsanleitung

Laserworld

Laserworld Evolution Series ES-400RGB Bedienungsanleitung

Alien

Alien RG STAR Bedienungsanleitung

EuroLite

EuroLite LED B-40 Bedienungsanleitung

Qazqa

Qazqa Suplux SL 3 Black 103062 Bedienungsanleitung

Commercial Electric

Commercial Electric 54568141 Bedienungsanleitung

CREE LIGHTING

CREE LIGHTING 304 Series Bedienungsanleitung

Goobay

Goobay 49867 Bedienungsanleitung

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Bedienungsanleitung

Alkalite

Alkalite Krypton KT-81 Bedienungsanleitung

Clas Ohlson

Clas Ohlson GU10 Bedienungsanleitung

DTS

DTS DELTA 10 F Bedienungsanleitung

ring

ring Solar Steplight Bedienungsanleitung

One Stop Gardens

One Stop Gardens 57696 Montageanleitung

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Bedienungsanleitung

SIREM

SIREM Swimeo A2 Bedienungsanleitung