Larson Electronics EPL-FL26-LED Series Bedienungsanleitung

MAINTENANCE:

WARNING: It is very important that only qualied per-

sonnel perform maintenance and repair operaons in a

NON-HAZARDOUS area. The integrity of the component

assembly and ame-path must be maintained in order

to provide adequate protecon for personnel using this

light. Comply with all NEC Rules and Regulaons when

performing maintenance operaons. Failure to comply

with these could result in an explosion, electrical shock,

or personal injury.

WARNING: When performing maintenance operaons

disconnect power. Failure to do so could result in electri-

cal shock.

Make a thorough visual inspecon of the work light for any

chips, cracks, or burns within the glass, aluminum handle,

and cage. Check the enre length of the cord for any frays

or visible wires that could aect the performance of the

light. Check that all the rubber bumpers are integral with

the aluminum. If there are any frays in the cord, cracks in

the glass or disturbances in the aluminum outside of nor-

mal wear, remove the light from service immediately and

contact Larson Electronics for replacement.

CAUTION: Clean external parts of work light only; inter-

nal parts do not require cleaning. Applying solvent could

result in damage to the electrical equipment.

The EPL-FL26-LED can be cleaned applying Simple Green®

or an equivalent cleanser and wiping any dust or grease off

with a rag. After cleaning process is performed, allow

adequate time for light to completely dry before placing in

operation.

INTRODUCTION

This document covers the operation, maintenance, and

re-lamping procedures for an EPL-FL26-LED hazardous

locations work light. This light is suitable for the

following hazardous locations only:

Class I, Divisions 1 & 2, Groups C & D

Class II, Divisions 1 & 2, Groups E, F, and G

Class III, Divisions 1 & 2

Refer to the National Electric Code (NEC) NFPA 70 for

more information on hazardous locations.

OPERATIONS AND USE

WARNING:

FOR FLYING LEADS:

This light is not supplied with a plug. If the light is used

in a hazardous location environment, it must be

terminated with a suitable plug or hard wired into an

appropriate junction box rated for the environment it

is to be used in. Comply with all NEC Rules and Regu-

lations when terminating light with a plug. Failure to

comply with this could result in an explosion, electri-cal

shock, or personal injury.

CAUTION:

Follow manufacturer’s instructions for attaching plug

to light ensuring all wires are properly terminated and

grounded.

CAUTION:

When hanging the light using the hook, use an ap-

propriate entity capable of holding at least 6 lbs. (2.72

kg).

EPL-FL26-LED Series

Explosion Proof Compact LED Handlamp

Instruction Manual

Larson Electronics, LLC Phone: (877) 348-9680 Fax: (903) 498-3364 www.larsonelectronics.com 1 of 2

PLUG OPERATION (for units pre-wired with explosion proof cord cap)

Electrical connection between plug and compatible receptacle is accomplished after plug fully inserts into receptacle and is rotated

clockwise.

1. Lift receptacle door and locate polarization on mating plug pin and receptacle face. Insert plug straight all the

way into receptacle until it cannot go further.

2. Rotate plug clockwise limit (37º), this closes internal contacts and completes circuit. This also mechanically locks

plug into receptacle so it cannot be pulled out.

3. To remove plug, push plug inward and turn to counterclockwise, pull plug straight out.

Relamping Instructions for EPL-FL26-LED

FIG. 1 EXPLODED VIEW EPL-FL26-LED WORK LIGHT

WARNING: When relamping work light, disconnect

power. Failure to do so could result in electrical

shock.

1. Loosen strain relief from handle end of light and

slide down the cord.

2. Loosen and remove the four brass Allen Head

screws using the appropriate tool.

3. Slide handle cap doughnut off the end of the

handle to gain access to the handle cap. With a

slow rocking motion, slide the handle cap and

lamp-head assembly from the handle and cage

casing assembly.

4. Remove the shock from the end of the lamp and

set aside. Grasping lamp holder in one hand and

lamp in other hand, remove the lamp with a slow

rocking motion and discard.

5. Replace lamp with same type and rating lamp or

equivalent. Slide shock on the end of the lamp.

Slide lamp into lamp holder assembly until a click

is heard.

6. Make a visual inspection of the “O” Ring. If “O”

Ring has any sign of wear contact Larson

Electronics for replacement part. Check the black

shrink-wrap fitting for any signs of damage.

7. Slide the lamp assembly back into handle and

cage assembly, aligning the four screw holds.

Tighten brass screws and torque to 35lbf-ft

(47.5N-m). Slide handle cap doughnut onto handle

cap, align holes with screws. Slide strain-relief into

place and tighten to a snug fit.

8. Test light in a non-hazardous location before using

in a hazardous location to ensure proper opera-

tion of lamp.

Larson Electronics, LLC Phone: (877) 348-9680 Fax: (903) 498-3364 www.larsonelectronics.com 2 of 2

EPL-FL26-LED Series

THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS.

SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT

SAL[email protected] OR BY PHONE AT 1-877-348-9680 FOR FURTHER ASSISTANCE.

PLEASE VISIT LARSONELECTRONICS.COM FOR WARRANTY AND RETURN INFORMATION.

Inhaltsverzeichnis

Andere Larson Electronics Beleuchtungsausrüstung Handbücher

Larson Electronics

Larson Electronics LED10W-1X4LT Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-HB-100LED-RT-CM Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-BS-70-100 Handbuch

Larson Electronics

Larson Electronics IND-HVAC-DTW-XX-SP0108-120W Bedienungsanleitung

Larson Electronics

Larson Electronics GAU-PT-150LTL-LED-480V Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-HB-150LED-RT-140DB-JB3 Bedienungsanleitung

Larson Electronics

Larson Electronics RL-15-LED-CPR Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-PM-1X30LED-6XMB-10 Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-SL-2-LED-ITG-M2 Bedienungsanleitung

Larson Electronics

Larson Electronics PML-15 Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-SBDL-150RT-48 Bedienungsanleitung

Larson Electronics

Larson Electronics FRL-4P-S1-60-1X-T5HO-130W-UVC Bedienungsanleitung

Larson Electronics

Larson Electronics WCDE-11-6HPS-MR Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-16C-2X150LED-RT Bedienungsanleitung

Larson Electronics

Larson Electronics FRL-EMX-18-90W-FUVC-KT Bedienungsanleitung

Larson Electronics

Larson Electronics IIND-DBL-36-1L-R1-120V Bedienungsanleitung

Larson Electronics

Larson Electronics WAL-C-4XM Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-TL-2X10W-C-PA Series Bedienungsanleitung

Larson Electronics

Larson Electronics XLE-UVC-XX-SGKT-2X Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-FL1524-LED Series Bedienungsanleitung

Larson Electronics

Larson Electronics LED18W-PAR36 Bedienungsanleitung

Larson Electronics

Larson Electronics GL-9051-F-M Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-HB-150LED-RT-100-EPP Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-DL-12-25-1523 Bedienungsanleitung

Beliebte Beleuchtungsausrüstung Handbücher anderer Marken

Brizo

Brizo 8SP-MU-4 Bedienungsanleitung

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Bedienungsanleitung

IKEA

IKEA BJÖRKSPIREA Bedienungsanleitung

Laserworld

Laserworld Evolution Series ES-400RGB Bedienungsanleitung

Alien

Alien RG STAR Bedienungsanleitung

EuroLite

EuroLite LED B-40 Bedienungsanleitung

Qazqa

Qazqa Suplux SL 3 Black 103062 Bedienungsanleitung

Commercial Electric

Commercial Electric 54568141 Bedienungsanleitung

CREE LIGHTING

CREE LIGHTING 304 Series Bedienungsanleitung

Goobay

Goobay 49867 Bedienungsanleitung

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Bedienungsanleitung

Alkalite

Alkalite Krypton KT-81 Bedienungsanleitung

Clas Ohlson

Clas Ohlson GU10 Bedienungsanleitung

DTS

DTS DELTA 10 F Bedienungsanleitung

ring

ring Solar Steplight Bedienungsanleitung

One Stop Gardens

One Stop Gardens 57696 Montageanleitung

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Bedienungsanleitung

SIREM

SIREM Swimeo A2 Bedienungsanleitung