Larson Electronics Golight Stryker GL-30064ST Bedienungsanleitung

GL-30064ST

Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com 1of 2

LED Golight Stryker GL-30064ST Wireless Remote Control Spotlight w/

Handheld Remote - Permanent Mount

INSTRUCTION MANUAL

Thank you for your purchase of the Larson Electronics GL-30064ST.

WARNING:

READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.

CRITICAL SAFETY INSTRUCTIONS:

•INSTALLATION SHOULD ONLY BECONDUCTED BY A QUALIFIED ELECTRICIAN IN ACCORDANCE WITH NEC AND ANY

RELEVANT LOCAL BUILDING CODES.

•RISK OFFIRE OR ELECTRIC SHOCK. FIXTURE INSTALLATION REQUIRES KNOWLEDGE OF FIXTURE'S ELECTRICAL

SYSTEMS. IFNOTQUALIFIED, CONTACT A QUALIFIED ELECTRICIAN.

•BE CERTAIN ELECTRICAL POWER IS OFF BEFORE AND DURING INSTALLATION AND MAINTENANCE.

•MAKE SURE THE SUPPLY VOLTAGE IS THE SAME AS THE FIXTURE'S RATED VOLTAGE.

•TO PREVENT WIRING DAMAGE OR ABRASION, DO NOT EXPOSE WIRING TO EDGES OF SHEET METAL OR SHARP

OBJECTS. SUITABLE FOR DAMP LOCATIONS.

IMPORTANT

READ CAREFULLY BEFORE INSTALLING THIS FIXTURE. SAVE THESE INSTRUCTIONS FOR FUTURE

REFERENCE. THE GL-30064ST MUST BE WIRED IN ACCORDANCE WITH NATIONAL ELECTRICAL CODE AND

ALL APPLICABLE LOCAL CODES. PROPER GROUNDING IS REQUIRED FOR SAFETY.

WE STRONGLY ENCOURAGE ONLY A LICENSED ELECTRICIAN INSTALL, OPERATE AND MAINTAIN THIS

PRODUCT. IF YOU ARE NOT QUALIFIED OR UNFAMILIAR WITH ANY ASPECT OF THIS INSTRUCTION SHEET,

CONSULT AN ELECTRICIAN. THERE ARE NO SERVICEABLE PARTS INSIDE.

WARNING: MAKE SURE POWER IS TURNED OFF BEFORE STARTING THE

INSTALLATION OR PERFORMING ANY MAINTENANCE.

RISK OF FIRE/ELECTRIC SHOCK –DISCONNECT POWER AT BREAKER BEFORE INSTALLING OR SERVICING.

RISK OF PERSONAL INJURY –FIXTURE MAY BECOME UNSTABLE OR DAMAGED IF NOT INSTALLED PROPERLY.

RISK OF BURN –ALLOW FIXTURE TO COOL BEFORE SERVICING.

The Larson Electronics GL-30064ST Golight LED Stryker offers powerful illumination and wireless remote functionality in rugged work

sites. This 40-watt light features 10 high flux LEDs and a P-Vex lens. During use, the unit provides up to 544,000 candela output that is

capable of illuminating targets up to 4,839 feet away. Operators can mount the UV and saltwater resistant LED light using an included

stainless steel bracket.

LowVoltage DC

Connect power to power supply outputting low voltage between 9-42Volts DC.

This variable voltage allows greater versatility without affecting light output. Ensure

deutsch connectors are properly connected (If applicable)

REMOTE OPERATION

Remote control functions include on/off, home and 4 buttons which control up, down, left and right movement. The light will

continue movement as long as the buttons are pressed. Releasing the buttons stops movement and holds the Golight in

position. A fast and slow mode button (turtle/hare) controls the speed of the motor while the pan and tilt function buttons are

depressed. Holding the button for 12 seconds in fast mode results in a full 370 degree rotation, and 8 seconds for full tilt.

Slow mode is used for pinpoint accuracy at distance and is approximately 35 seconds for full rotation and 20 seconds for

one full range of tilt. Simultaneous pan + tilt is possible. An included on-command return function automatically brings the

unit to 0° home.

POWER

This light operates with 12 volts DC and draws 3.7 amps, making it ideal for vehicles, boats, ATVs, and similar sources of

12 volt direct current.

MOUNTING

The light is permanently mounted using an included stainless steel mounting bracket.

GL-30064ST

Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com 2of 2

MOUNTING INSTALLATION

Determine the location for the light on your vehicle or boat. Remove the mounting plate from the light. Center the

mounting plate with the vise screw on the mounting plate to the back. Mark the hole locations for the three mounting

screws and drill a pilot hole for each with a 1/8 inch bit. Fasten the stainless steel mounting plate with the 3 #10 – 16x ¾

type AB cross recessed pan head tapping screws. Drill a ¼” hole (wireless) or a 5/8” hole (hardwired) in the center of the

mounting plate opening to accommodate the power wire or wiring harness and connector. Attach the connector that is

affixed to the underside of the light to the corresponding connector on the wiring harness (hard-wired). Position the

connection point beneath the mounting surface, and apply silicone sealant around wire to seal the drilled opening. Wet

the mounting surface with a small amount of water or lubricant for easier installation, then place the light over the

mounting plate by sliding the front of the light over the front of the mounting plate, first pull the light backwards, then seat

the back of the light on the mounting plate. Displace the back of the gasket and install the vise screw (provided). Tighten

the vise screw using a Philips head screwdriver. Replace the gasket

MAINTENANCE

There are no serviceable parts inside the fixture. However, it is good practice to routinely clean and check the

fixture for proper function.

•Disconnect power running to the lamp and be sure the fixture is cool to the touch.

•Use a non-abrasive glass cleaning solution to clean the lens.

Note: It is not necessary to open the fixture and clean or touch the LED’s.

USE AND CARE

Unauthorized modification may impair the function and/or safety of this device and could affect the life of the equipment.

Always check for damaged or worn out parts before using the device. Store it in a secure place out of the reach of

children when not in use.Inspect for good working condition prior to storage and before re-use.

REPLACEMENT PARTS

The GL-30064ST is designed to provide years of reliable performance. Should the need for replacement parts arise,

please contact Larson Electronics.

THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS.

SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT

SALES@LARSONELECTRONICS.COM OR BY PHONE AT 1-800-369-6671 FOR FURTHER ASSISTANCE.

PLEASE VISIT LARSONELECTRONICS.COM FOR WARRANTY AND RETURN INFORMATION.

Inhaltsverzeichnis

Andere Larson Electronics Scheinwerfer Handbücher

Larson Electronics

Larson Electronics APM-GL20004 Bedienungsanleitung

Larson Electronics

Larson Electronics GL-3610-S-E Handbuch

Larson Electronics

Larson Electronics LEDWL 1227 Series Handbuch

Larson Electronics

Larson Electronics HUL-18 Bedienungsanleitung

Larson Electronics

Larson Electronics RCL700 Bedienungs- und Wartungshandbuch

Larson Electronics

Larson Electronics LE-4100-6-A Bedienungsanleitung

Larson Electronics

Larson Electronics 2000-M Handbuch

Larson Electronics

Larson Electronics HL.RL-85-LED-36W-CPR Bedienungsanleitung

Larson Electronics

Larson Electronics Golight GL-3000-24-M Bedienungsanleitung

Larson Electronics

Larson Electronics HL-85-LED-CPR Bedienungsanleitung

Larson Electronics

Larson Electronics HAL-RA-48-6L-LED Bedienungsanleitung

Larson Electronics

Larson Electronics GVP-48-2L-LED-D-V2 Bedienungsanleitung

Larson Electronics

Larson Electronics Golight 51494 Handbuch

Larson Electronics

Larson Electronics Golight Radioray GL-2081-M Handbuch

Larson Electronics

Larson Electronics GL-3100-S-12-E Handbuch

Larson Electronics

Larson Electronics Golight 51674 Handbuch

Larson Electronics

Larson Electronics Golight GL-2 GT Series Handbuch

Larson Electronics

Larson Electronics HUL-LED25WRE-CPR Bedienungsanleitung

Larson Electronics

Larson Electronics LE-224-LED Bedienungsanleitung

Larson Electronics

Larson Electronics MUL-30-LED Bedienungsanleitung

Larson Electronics

Larson Electronics HID-A1830-WA Bedienungsanleitung

Larson Electronics

Larson Electronics RL-20 Bedienungsanleitung

Larson Electronics

Larson Electronics RL-85-3W1 Bedienungsanleitung

Larson Electronics

Larson Electronics GL-30514-S-E Handbuch

Beliebte Scheinwerfer Handbücher anderer Marken

Guangzhou Yinhe Lighting&Sound Equipment Factory

Guangzhou Yinhe Lighting&Sound Equipment Factory NE-204 Bedienungsanleitung

LIVARNO home

LIVARNO home 375304 2101 Originalbetriebsanleitung

Cameo

Cameo CLQS40WW Bedienungsanleitung

Leviton

Leviton Ellipsoid 5/50 Bedienungsanleitung

Monacor

Monacor img Stage Line PARL-56PDX/CR Bedienungsanleitung

Vector

Vector SL3AKV Bedienungsanleitung

Quantum

Quantum Q262 Betriebshandbuch

Philips

Philips Vari-lite VL3015LT Bedienungsanleitung

EUROSPOT

EUROSPOT C51 Bedienungsanleitung

DTS

DTS MINI BRICK ARC Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation VISIBEAM II Handbuch

ACME

ACME LED-MS350B Bedienungsanleitung

EuroLite

EuroLite Akku flat light 1 Bedienungsanleitung

Commercial Electric

Commercial Electric SPTM-1401 Bedienungsanleitung

Vision & Control

Vision & Control SLB-500-W5K7-P-SL Bedienungsanleitung

Teknik

Teknik FLEXI Bedienungsanleitung

Craftsman

Craftsman CMXLSB10 Bedienungsanleitung

EuroLite

EuroLite LED SLS-144 UV Floor Spot Bedienungsanleitung