Lifetime FRONT ADJUST 90599 Bedienungsanleitung

TOOLS REQUIRED TABLE OF CONTENTS

• Requires at least 493 lb (224 kg) of cement mix to ﬁll a

volume of 3.7 ft3(0.105 m3).

• Requires 3+ days for concrete to cure, plus 3-4 hours

to complete assembly steps.

• 2+ people recommended for setup.

Pour le français, voir la page 2. Para el español, ver la página 3.

ASSEMBLY INSTRUCTIONS

MODEL 90599

Save this instruction in the event that the manufacturer has

to be contacted for replacement parts.

BEFORE ASSEMBLY:

CONTACT LIFETIME CUSTOMER SERVICE:

Call: 1-800-225-3865

7:00 am–5:00 pm (Monday–Friday) MST

and 9:00 am–1:00 pm Saturday MST

QUESTIONS? Model Number: 90599

Product ID:

For Customer Service in Mainland

Europe and the United Kingdom,

E-mail:[email protected]

Live Chat:

www.lifetime.com

Video Instructions:

www.youtube.com/lifetimeproducts

7/16" (11 mm)

(x2)

(x1)

(x1) (x1)

1/2" (13 mm)

(x2)

(x1)

9/16" (14 mm)

(x2)

3/4" (19 mm)

(x2)

(x1)

Cement Mix

493 lb (224 kg)

(3’)

Rebar

(x1)

(x1) (x1)

Icon Legend................................4

Notices....................................5

Initial Set Up..............................6

Pole Assembly..........................12

Backboard to Rim Assembly.......17

Backboard to Pole Assembly.......21

PartsIdentiﬁer..........................i-iv

Handle Assembly.......................26

Final Assembly..........................33

Maintenance Instructions..........39

Warning Sticker.......................40

Registration........................44

Warranty................................45

FRONT ADJUST®

BASKETBALL SYSTEM

(x1)

COPY

• Indicates the parts to be used for a section.

• Indicates special heed should be taken when reading.

• Indicates the hardware to be used for a section.

• Indicates the tools to be used for a section.

• Indicates no hardware required for a speciﬁc page.

• Indicates no parts required for a speciﬁc section.

• Indicates to use/not to use an electric drill for a speciﬁc step.

ICON LEGEND

• Indicates the use of a centerlock nut. A nut with this marking will require some effort to tighten.

This hardware was designed with this feature in order to prevent loosening later.

1197626 2/6/2019

COPY

WARNINGS & NOTICES

Most injuries are caused by misuse and/or not following instructions. Use caution when using this product.

To ensure safety, do not attempt to assemble this product without following the instructions carefully. Check entire box and inside all packing

material for parts and/or additional instruction material. Before beginning assembly, read the instructions and identify parts using the hardware

identiﬁer and parts list in this document. Proper and complete assembly, use and supervision are essential for proper operation and to reduce the

risk of accident or injury. A high probability of serious injury exists if this product is not installed, maintained, and operated properly.

FAILURE TO FOLLOW THESE WARNINGS MAY RESULT IN SERIOUS INJURY OR PROPERTY DAMAGE AND WILL VOID WARRANTY.

Owner must ensure that all players know and follow these rules for safe operation of the system.

• If using a ladder during assembly, use extreme caution.

• Two capable adults are recommended for this operation.

• Check base daily for leakage. Leaks will cause system to fall.

• Assemble the pole sections properly. Failure to do so could cause the pole sections to separate during play or transport.

• Minimum operational height is 6 ft 6 in (1.98m) to the bottom of the backboard.

SAFETY INSTRUCTIONS

COPY

1GROUND PREPARATION

Metal Parts

Hardware Bag

TOOLS REQUIRED

PARTS REQUIRED

HARDWARE REQUIRED

(1)

3 ft. Rebar Cement Mix

Level

ALE (x1)

(1)

493 lb

/224 kg

COPY

TOOLS AND HARDWARE REQUIRED

XSECTION 1 (CONTINUED)

• Dig a round hole 24” deep and 18” in diameter. If you live in an area where frost heaves may pose a problem,

consult your local building inspector to determine the proper hole depth. The edge of the hole should be ﬂush with

the edge of the playing surface.

1.1

• A Ground Sleeve is available

as an alternative to cementing

the Pole into the ground. Please

contact Customer Service for more

information.

• Make a mark 14.5 inches from the dimpled end of the Bottom Pole (ALE) (do not scratch the powder coating).

1.2

14.5”

ALE

18’’

(1)

TOOLS AND HARDWARE REQUIRED

XSECTION 1 (CONTINUED)

• Mix the concrete. Save 1/2 bag of concrete mix to use later in the assembly. Pour the mixed concrete into the

hole until it is ﬁlled to the level of the playing surface.

• Insert the dimpled end of the Bottom Pole (ALE) into the center of the cement up to the 14.5” mark.

1.3

1.4

493 lb

/224 kg

• If the pole is buried too deep or too

shallow, the rim will not to be at the

correct height.

ALE

TOOLS AND HARDWARE REQUIRED

XSECTION 1 (CONTINUED)

• DO NOT CONTINUE the assembly

until the concrete has been

allowed to set for 1-4 hours.

• The slots in the Bottom Pole must be parallel to the playing surface. If necessary, insert a straight object (a ruler,

wire, etc.) through the slots in the Bottom Pole and rotate the pole until the object is parallel to the playing surface.

1.5

Playing Surface

• Use a Level to make sure the Bottom Pole

is standing vertical. Form the cement into a

downward slope away from the pole to allow

water runoff. Failure to do so may result in

premature rusting of the Pole.

• Insert the 1/2” x 3’ rebar (not included) inside the Bottom Pole (ALE). Check the pole several times within the ﬁrst

hour to make sure that all sides are vertical and that the 14.5-inch mark remains level with the playing surface.

1.6

Rebar

3 ft. Rebar

TOOLS AND HARDWARE REQUIRED

XSECTION 1 (CONTINUED)

• STOP ASSEMBLY NOW. Do not continue the assembly until the concrete

has been allowed to set for at least 72 hours (3 days). In humid climates

or wet weather, allow more time for the concrete to cure. Do not proceed

until the curing process is complete.

• Mix the remaining 1/2 bag of concrete and pour the concrete into the Bottom Pole (ALE) until it is just below the slots

in the top of the pole. Then tamp the concrete down in the Bottom Pole (ALE) with a broom handle to remove any air

pockets. Remember to clean all excess concrete off the outside surface and inside surface of the pole.

1.7

(1/2 Bag)

• Do not overﬁll the Pole or you may not be

able to assemble the rest of the pole sections.

POLE ASSEMBLY

BCO

Metal Part

Hardware Bag

TOOLS REQUIRED

PARTS REQUIRED

HARDWARE REQUIRED

(2) (1)

9/16”

ADS (x2)*

ABZ (x2)*

ABB (x2)

AAF (x2)

ABE (x2)

ABR (x2) CIH (x2)*

*Note: Only one #14 x 1” Self-Tapping Screw (ABZ), one Domed Counter-

sink Washer (CIH) and one 1/4” x 3/4” Pan Head Screw (ADS) will be used

for this section. Save the remaining hardware for later in the assembly.

43 3/8” (110 cm)

Scrap Wood

ALH (x1)

ALF (x1)

43 3/8” (110 cm)

Warning Sticker

ALL (x1)

(1) (1)

TOOLS AND HARDWARE REQUIRED

XSECTION 2 (CONTINUED)

2.1 • Insert the 3/8” x 4” Hex Bolts (ABE) with the 3/8” Washers (AAF) into the Middle Pole (ALF) as shown. Then slide the 1/2” x

3.41” Spacers (ABR) onto the Hex Bolts.

ALF

ABE

ABR

Warning

Sticker

AAF

Large Holes

Small Holes

AAF (x2)

ABE (x2)

ABR (x2)

Inhaltsverzeichnis

Andere Lifetime Sport & Outdoor Handbücher

Lifetime

Lifetime 90541 Bedienungsanleitung

Lifetime

Lifetime 71286 Bedienungsanleitung

Lifetime

Lifetime 60348 Bedienungsanleitung

Lifetime

Lifetime STREAMLINE 90670 Bedienungsanleitung

Lifetime

Lifetime 71281 Bedienungsanleitung

Lifetime

Lifetime POOLSIDE 91213 Bedienungsanleitung

Lifetime

Lifetime PROCOURT 91329 Bedienungsanleitung

Lifetime

Lifetime OD148560 Bedienungsanleitung

Lifetime

Lifetime KAYAK Bedienungsanleitung

Lifetime

Lifetime 90029 Bedienungsanleitung

Lifetime

Lifetime PORTABLE PROCOURT 90688 Bedienungsanleitung

Lifetime

Lifetime 90227 Bedienungsanleitung

Lifetime

Lifetime 90046 Bedienungsanleitung

Lifetime

Lifetime 90183 Bedienungsanleitung

Lifetime

Lifetime POWER LIFT 90682 Bedienungsanleitung

Lifetime

Lifetime 90819 Bedienungsanleitung

Lifetime

Lifetime POOLSIDE 1301 Bedienungsanleitung

Lifetime

Lifetime PROCOURT 90073 Bedienungsanleitung

Lifetime

Lifetime MAMMOTH 90965 Bedienungsanleitung

Lifetime

Lifetime CRANK ADJUST 90569 Bedienungsanleitung

Lifetime

Lifetime SPEED SHIFT Bedienungsanleitung

Lifetime

Lifetime SPEED SHIFT 90680 Bedienungsanleitung

Lifetime

Lifetime ACTION GRIP 71546 Bedienungsanleitung

Lifetime

Lifetime MAMMOTH 90181 Bedienungsanleitung

Beliebte Sport & Outdoor Handbücher anderer Marken

Flybar

Flybar POGO TRICK BOARD Bedienungsanleitung

Crivit

Crivit 93713 Bedienungsanleitung

Hudora

Hudora 76171 Montageanleitung

Axler

Axler GSU-1 Bedienungsanleitung

Aquaglide

Aquaglide FREEFALL 6 LANDING PAD Bedienungsanleitung

Cap Strength

Cap Strength POWER RACK FM-CS7000F Bedienungsanleitung

La Sportiva

La Sportiva RACE BORG Bedienungsanleitung

Crivit

Crivit 302640 Bedienungsanleitung

Sportime

Sportime Equalizer Bedienungsanleitung

T&R Sports

T&R Sports 5FT FOOSBALL TABLE Bedienungsanleitung

Salewa

Salewa VERT Bedienungsanleitung

KICK

KICK Decagon Bedienungsanleitung

byox

byox FJ-4.5FT Bedienungsanleitung

CHINESPORT Spa

CHINESPORT Spa 01325 Bedienungsanleitung

AXI.COM

AXI.COM ConesPro101 Bedienungsanleitung

Insportline

Insportline IN 2052 Bedienungsanleitung

Rugged Interactive

Rugged Interactive CardioWall Compact Kurzanleitung

N-FLATABLES

N-FLATABLES Belly Bouncer Fire Dog Bedienungsanleitung