Lifetime POWER LIFT 90600 Bedienungsanleitung

POWER LIFT®

BASKETBALL SYSTEM

(x1)

3/16"

(x2, included)

(375 lb)

Icon Legend................................2

Warnings & Notices....................3

Pole Assembly............................4

Pole-to-Base Assembly................8

Backboard-to-Rim Assembly......12

Backboard-to-Pole Assembly.....17

Parts Identiﬁer.........................i-iv

Handle Assembly......................24

Final Assembly.........................29

Maintenance.........................33

Registration........................33

Warning Sticker........................34

Warranty................................35

(x1)

1/2", 3/4"

11/16"

(x2)

1/2", 9/16", 3/4"

(x1) (x1)

(x1)

TOOLS REQUIRED TABLE OF CONTENTS

BEFORE ASSEMBLY:

• Decide with what to ﬁll the base

(sand is recommended)

• At least 2 adults recommended for setup

ASSEMBLY INSTRUCTIONS

MODEL 90600

CONTACT LIFETIME®CUSTOMER SERVICE:

QUESTIONS? Model Number: 90600

Product ID:

For Customer Service in Mainland

Europe and the United Kingdom,

E-mail:[email protected]

Live Chat:

www.lifetime.com/customerservice

(click on “Live Chat” tab)

(x1)

Save this instruction in the event that the manufacturer must be contacted for replacement parts.

IMPORTANT, RETAIN FOR FUTURE REFERENCE: READ CAREFULLY

(x1)

Dial 1-800-225-3865

7:00 am–5:00 pm (M–F) MST

and 9:00 am–1:00 pm (Sat) MST

(English, Français, Español)

3D ANIMATION

OF THE FULL ASSEMBLY

WATCH

SCAN THE

CODE OR SEARCH

1215666

• Indicates the parts to be used for a section.

• Indicates special heed should be taken when reading.

• Indicates the hardware to be used for a section.

• Indicates the tools to be used for a section.

• Indicates no hardware required for a speciﬁc page.

• Indicates no parts required for a speciﬁc section.

• Indicates to use/not to use an electric drill for a speciﬁc step.

ICON LEGEND

• Indicates the use of a centerlock nut. A nut with this marking will require some effort to tighten.

This hardware was designed with this feature in order to prevent loosening later.

1222024 11/19/2021

WARNINGS & NOTICES

Most injuries are caused by misuse and/or not following instructions. Use caution when using this product.

To ensure safety, do not attempt to assemble this product without following the instructions carefully. Check entire box and inside all packing

material for parts and/or additional instruction material. Before beginning assembly, read the instructions and identify parts using the hardware

identiﬁer and parts list in this document. Proper and complete assembly, use and supervision are essential for proper operation and to reduce the

risk of accident or injury. A high probability of serious injury exists if this product is not installed, maintained, and operated properly.

FAILURE TO FOLLOW THESE WARNINGS MAY RESULT IN SERIOUS INJURY OR PROPERTY DAMAGE AND WILL VOID WARRANTY.

Owner must ensure that all players know and follow these rules for safe operation of the system.

• If using a ladder during assembly, use extreme caution.

• Two capable adults are recommended for this operation.

• Check base daily for leakage. Leaks will cause system to fall.

• Assemble the pole sections properly. Failure to do so could cause the pole sections to separate during play or transport.

• Minimum operational height is 6 ft 6 in (1.98m) to the bottom of the backboard.

SAFETY INSTRUCTIONS

43 3/8” (110 cm)

BCO

Metal Parts

Hardware Bag

TOOLS REQUIRED

PARTS REQUIRED

HARDWARE REQUIRED

POLE ASSEMBLY

ADS (x2)

ABZ (x2) ABB (x2)

AAF (x2)

ABE (x2)

ABR (x2)

ALH (x1)

Warning Sticker ALL (x1)

9/16” (≈14 mm)

CIH (x2)

(x2) (x1) (x1) (x1)

ALF (x1)

ALE (x1)

27 5/8” (70.2 cm)

43 3/8” (110 cm)

!• The Bottom Pole (ALE) has

been designed with an indent

at one end.

TOOLS AND HARDWARE REQUIRED

SECTION 1 (CONTINUED)

• Insert the Hex Bolts (ABE) with the Washers (AAF) into the

Top Pole (ALH) as shown. Then slide the Spacers (ABR)

onto the Hex Bolts.

1.1

ALH

ABE ABR

AAF

Large Holes

Small Holes

AAF (x2)

ABE (x2)

ABR (x2)

9/16" (≈14 mm)

ABB (x2)

• Secure the Pole Bracket (ALL) to the Top Pole with

the hardware as shown.

ALL

ABB

ABE

1.2

(x2)

TOOLS AND HARDWARE REQUIRED

• Align the hole in the bottom of the Top Pole (ALH)

with the slot in the top of the Middle Pole (ALF). Insert

a Screw (ADS) through the Countersink Washer (CIH)

and into the small hole in the Top Pole.

• Secure the Middle Pole to the Bottom Pole (ALE) using

the same method as step 1.3.

1.3

SECTION 1 (CONTINUED)

ADS (x2)

1.4

!• The Screw should be ﬂush

with the Pole, but will spin

freely once inserted.

ALH

ALF

Warning

Sticker

ADS

ALF

ALH

CIH

ALH

ALF

ALE

ADS

ALE

ALF

CIH

ALL

!• Make sure the indented lip on the Bottom

Pole and the Pole Bracket (ALL) are on

opposite sides of the pole assembly.

!• The Screw should be ﬂush with

the Pole, but will spin freely once

inserted.

CIH (x2)

(x1)

TOOLS AND HARDWARE REQUIRED

• Strike the end of the Pole Assembly on a piece of scrap wood or

cardboard 5–6 times.

1.5

SECTION 1 (CONTINUED)

• Do not strike your feet with the Pole sections, as

serious injury may occur.

ABZ (x2)

• For ease of installation, chuck the head of

the Self-Tapping Screws directly into the

drill, or use a 3/8” Hex Driver

• Using a Power Drill, secure the Poles together with Self-Tapping Screws (ABZ).

1.7

ALH

ALF

ALE

ABZ

WARNING

The Poles must be seated together! Even if the Poles cover

the slots before seating, they must be struck on a hard

surface ﬁve to six times! Failure to seat the Poles correctly

could allow the Poles to separate during use, which could

lead to serious personal injuries or property damage.

• Flip the Pole over and repeat

step 1.5 for the opposite end

of the Pole Assembly.

1.6

(x1) (x1)

BCQ

Metal Parts

Hardware Bag

TOOLS REQUIRED

PARTS REQUIRED

HARDWARE REQUIRED

AAE (x2)

BTS (x1)

ABD (x4) AAO (x2)

CCL (x2)

AMU (x2)

AJM (x1)

Plastic Parts

(x2) (x1)

1/2" (13 mm) CCL-3/16" (5 mm)

(x2)

21 3/4 ”

AJD (x1)

ALI (x2)

AJN (x1)

38" (≈96,5 cm)

DRZ (x1)

POLE-TO-BASE ASSEMBLY

TOOLS AND HARDWARE REQUIRED

SECTION 2 (CONTINUED)

2.1

• It may be necessary to use a Rubber Mallet to tap the Axle into place.

• Make sure the Rubber

Gasket is inside the Base

Cap.

AJM

AJN

Rubber Gasket

• Screw the Base Cap (AJN) onto the Base (AJM) as shown.

AJM

AJD

AMU

ALE

2.2 • Slide the Axle (AJD) through one of the Wheels (AMU) and into the Base (AJM) as shown. Then have one adult position the

Bottom Pole (ALE) within the Base as shown with the lip at the bottom of the pole facing outward. Insert the Axle through the

Bottom Pole and into the other side of the Base and through the other Wheel.

• Lip faces away from the Base.

(x1)

TOOLS AND HARDWARE REQUIRED

SECTION 2 (CONTINUED)

2.3

2.4

• Attach the ﬂattened end of the Pole Brace (ALI) to the Base (AJM) with the hardware shown. Only ﬁnger tighten the

hardware.

• Repeat step 2.3 to install the remaining Pole Brace to the other side of the base. Make sure the unattached

ends of the Pole Braces line up as shown.

ALI

AAE

ABD

AJM

ABD

AAO

AAE (x2) ABD (x4) AAO (x2)

1/2" (13 mm)

(x2)

Inhaltsverzeichnis

Andere Lifetime Sport & Outdoor Handbücher

Lifetime

Lifetime POWER LIFT 71281 Bedienungsanleitung

Lifetime

Lifetime 0040 Bedienungsanleitung

Lifetime

Lifetime 90010 Bedienungsanleitung

Lifetime

Lifetime 90466 Bedienungsanleitung

Lifetime

Lifetime MAMMOTH 90965 Bedienungsanleitung

Lifetime

Lifetime 71546 Bedienungsanleitung

Lifetime

Lifetime 90227 Bedienungsanleitung

Lifetime

Lifetime 1111 Bedienungsanleitung

Lifetime

Lifetime 90046 Bedienungsanleitung

Lifetime

Lifetime QUICK ADJUST 1044 Bedienungsanleitung

Lifetime

Lifetime POWER LIFT 90682 Bedienungsanleitung

Lifetime

Lifetime 51550 Bedienungsanleitung

Lifetime

Lifetime SLAM-IT PRO 5000 Bedienungsanleitung

Lifetime

Lifetime 12347 Bedienungsanleitung

Lifetime

Lifetime POWER LIFT 71281 Datenblatt

Lifetime

Lifetime COMPETITION Series XL POWER LIFT 71525 Bedienungsanleitung

Lifetime

Lifetime 1306 Datenblatt

Lifetime

Lifetime 71524 Bedienungsanleitung

Lifetime

Lifetime FRONT ADJUST 90167 Bedienungsanleitung

Lifetime

Lifetime POWER LIFT 90231 Bedienungsanleitung

Lifetime

Lifetime 90644 Bedienungsanleitung

Lifetime

Lifetime 60045 Bedienungsanleitung

Lifetime

Lifetime PROCOURT 91329 Bedienungsanleitung

Lifetime

Lifetime QUICK ADJUST 90584 Bedienungsanleitung

Beliebte Sport & Outdoor Handbücher anderer Marken

Flybar

Flybar POGO TRICK BOARD Bedienungsanleitung

Crivit

Crivit 93713 Bedienungsanleitung

Hudora

Hudora 76171 Montageanleitung

Axler

Axler GSU-1 Bedienungsanleitung

Aquaglide

Aquaglide FREEFALL 6 LANDING PAD Bedienungsanleitung

Cap Strength

Cap Strength POWER RACK FM-CS7000F Bedienungsanleitung

La Sportiva

La Sportiva RACE BORG Bedienungsanleitung

Crivit

Crivit 302640 Bedienungsanleitung

Sportime

Sportime Equalizer Bedienungsanleitung

T&R Sports

T&R Sports 5FT FOOSBALL TABLE Bedienungsanleitung

Salewa

Salewa VERT Bedienungsanleitung

KICK

KICK Decagon Bedienungsanleitung

byox

byox FJ-4.5FT Bedienungsanleitung

CHINESPORT Spa

CHINESPORT Spa 01325 Bedienungsanleitung

AXI.COM

AXI.COM ConesPro101 Bedienungsanleitung

Insportline

Insportline IN 2052 Bedienungsanleitung

Rugged Interactive

Rugged Interactive CardioWall Compact Kurzanleitung

N-FLATABLES

N-FLATABLES Belly Bouncer Fire Dog Bedienungsanleitung