Lightolier 1084CD Bedienungsanleitung

1 FRAME-IN KIT INSTALLATION: See Frame-In Kit Instruction Sheet for installation procedure.

2 GASKET INSTALLATION:

A. Align open side of gasket towards socket cup (figure A).

B. Pinch gasket and insert both edges under the reflector spring clip. (figure B).

C. Push center of gasket back into socket cup until inner diameter fits over the lamp socket

and smaller thru hole in gasket sits on top of socket (figure C).

Figure A Figure B Figure C

CAUTION – DO NOT STRETCH SMALL HOLE OF GASKET OVER LAMP SOCKET.

THE GASKET MUST SIT ON TOP OF SOCKET TO PROVIDE SEAL TO LAMP.

3 ROTATE ROTO-CLIPS:

Rotate (4) ROTO-CLIPS so that the short legs extend inwardly toward center

opening (figure D).

Note: The short leg of the ROTO-CLIP has no return on top.

Figure D

4 SNAP ON:

Insert gasketed socket cup into neck of reflector trim making sure spring clips of

socket cup snap into slots of reflector (figure E). If reflector trim has 2 sets of slots,

the upper slot is used for IC frame-in kits, the lower slot for non-IC frame-in kits.

Note: At no time should the lamp extend outside the reflector trim. Figure E

5 PUSH UP:

Align Reflector Trim so that ROTO-CLIPS will not interfere with socket cup spring

clips and push reflector trim straight up into fixture housing until it is tight against

ceiling (figure F). Figure F

Note: To remove reflector trim, turn reflector trim counterclockwise while pulling

downward. Once trim is out of the ceiling, squeeze reflector spring clips until the

trim disengages from socket cup. (figure G).

Replacement Gasket Available: Lightolier Catalog No. LFG356 Figure G

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE

This fixture is intended for installation in accordance with the National Electrical Code and local regulations. To

assure full compliance with local codes and regulations, check with your local electrical inspector before

installation. To prevent electric shock, turn off electricity at fuse box before proceeding.

Retain these instructions for maintenance reference.

INSTALLATION PROCEDURE FOR: 1184WH, 1184CD, 1084WH, 1084CD, 2084WH, 2084CD

1184WH and 1184CD for use with 1104ICX, 1103R, 1100IC, 1100AICM and 1102P1 only.

1084WH and 1084CD for use with 1004ICX, 1003R, 1000IC, 1000AICM and 1002P1 only.

2084WH and 2084CD for use with 2000IC

2000AIC

2003R and 2002P1 onl

CAUTION: (RISK OF FIRE) FOR NON-IC RATED INSTALLATIONS, DO NOT INSTALL INSULATION ABOVE

OR WITHIN 3 INCHES OF ANY PART OF FIXTURE.

CAUTION: USE ONLY REFLECTOR TRIMS PROVIDED BY LIGHTOLIER. USE OF OTHER MANUFACTURER’S REFLECTOR

TRIMS MAY VOID THE UNDERWRITERS LABORATORIES LISTING AND COULD CONSTITUTE A FIRE HAZARD.

INSTRUCTION SHEET NO.

IS:1184

B1104 Page 1 of 1

A COMPANY

631 Airport Road, Fall River, MA 02720

CAUTION: BEFORE INSTALLING REFLECTOR TO FRAME-IN-KIT, READ MARKINGS IN REFLECTOR AND IN SOCKET CUP

OF FRAME-IN-KIT TO DETERMINE LAMP WATTAGE AND TYPE APPLICABLE FOR YOUR INSTALLATION.

TECHNICAL BULLETIN

WET LOCATION RATING OF RECESSED LUMINAIRES

The 2002 National Electric Code ®(NEC) 1contains requirements addressing environmental ratings applicable to

luminaires. The following sections define requirements for luminaires installed in wet locations:

410.4 (A) Wet and Damp Locations. Luminaires (fixtures) installed in wet or damp locations shall be installed so that water

cannot enter or accumulate in wiring compartments, lampholders, or other electrical parts. All luminaires (fixtures) installed

in wet locations shall be marked, “Suitable for Wet Locations”. All luminaires (fixtures) installed in damp locations shall be

marked, “Suitable for Wet Locations” or “Suitable for Damp Locations”.

Article 100, Definitions

Location, Damp. Locations protected from weather and not subject to saturation with water or other liquids but subject to

moderate degrees of moisture. Examples of such locations include partially protected locations under canopies, marquees,

roofed open porches, and like locations, and interior locations subject to moderate degrees of moisture, such as some

basements, some barns, and some cold storage warehouses.

Location, Wet. Installations under ground or in concrete slabs or masonry in direct contact with earth; in locations subject

to saturation with water or other liquids, such as vehicle washing areas; and in unprotected locations exposed to weather. 2

Because of the multiple variables involved, location type must be determined on a case-by-case basis. Mounting

height, protective cover, the likelihood of water spray and other factors must be considered. Article 100

(Definitions) gives parameters and examples that can assist in these determinations. The local Authority Having

Jurisdiction should be consulted.

UL LISTING: To correlate with the NEC requirements regarding location, Underwriters Laboratories, Inc. (UL)

assigns location ratings to luminaires based on their compliance with standards and testing. Luminaires (fixtures)

suitable for installation in wet locations as defined in the NEC must comply with the appropriate construction and

test requirements of UL 1598 in order to be marked “Suitable for Wet Locations”.

RECESSED: Select Lightolier recessed luminaire (fixture) finishing sections (trims) are rated “Suitable for Wet

Locations - Covered Ceiling Mount Only”. Lightolier rough-in sections are rated “Suitable for Damp Locations”.

This combination allows installation where the area below the ceiling is a wet location and the area above the

ceiling is not exposed to saturation with liquids, but may be subject to moderate degrees of moisture. It should be

noted that a luminaire (fixture) that complies with the UL requirements for wet locations, and is labeled as such,

may or may not have a lens or gasket.

LIGHTOLIER OPEN WET LOCATION FINISHING SECTIONS (TRIMS) 1081, 1181, 1084,

1184 AND 2084:

Each of these finishing sections bear a UL Marking signifying that they are “Suitable for Wet

Locations – For Covered Ceiling Mount Only” when installed per the supplied instructions

and with the specified frame-in kits and lamps.

The use of lamps identified as outdoor wet location rated, specific to the finishing

section model number, is required to provide necessary shielding of the electrical

components from liquid saturation and a lamp envelope suitable for contact with water. Each of these

finishing sections is also provided with a high temperature silicone gasket which, when properly installed,

seals the lamp base, lamp holder and electrical parts and complies with UL 1598.

All Lightolier recessed fixtures are Listed by UL, as evidenced by the UL Listing Mark on the products. All Lightolier

fixtures are intended for installation in accordance with The National Electric Code and instructions provided with

the product. In order to comply with applicable codes & regulations, Lightolier recommends that the local Authority

Having Jurisdiction (building/electrical inspector) be consulted prior to installation and all necessary permits and

inspections be obtained.

1 - Because National Electric Code requirements change from time to time, the current version accepted by the Authority Having Jurisdiction should be

UL is a Registered Trademark of Underwriters Laboratories Inc. The National Electrical Code & NEC are Registered Trademarks of The National Fire

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Lightolier Leuchte Handbücher

Lightolier

Lightolier Lytecaster 1024 Bedienungsanleitung

Lightolier

Lightolier ProSpec 26800 Bedienungsanleitung

Lightolier

Lightolier Lytecaster 1001FR Series Bedienungsanleitung

Lightolier

Lightolier Lytecaster 1304 Bedienungsanleitung

Lightolier

Lightolier Calculite Matrix 4X9 Bedienungsanleitung

Lightolier

Lightolier Lytecaster 1004ICR Bedienungsanleitung

Lightolier

Lightolier Calculite ProSpec PA3H3870 Bedienungsanleitung

Lightolier

Lightolier Calculite C6T6A-MHT6RF Bedienungsanleitung

Lightolier

Lightolier Lytespan 6279 Bedienungsanleitung

Lightolier

Lightolier 1050SQDL_3D Bedienungsanleitung

Lightolier

Lightolier Lytespan 8701 Bedienungsanleitung

Lightolier

Lightolier GUARDSMAN GV4WB332 Bedienungsanleitung

Lightolier

Lightolier Lytespan 8266 Bedienungsanleitung

Lightolier

Lightolier Lytecaster 1135 Bedienungsanleitung

Lightolier

Lightolier 22SS2 Bedienungsanleitung

Lightolier

Lightolier Lytecaster 1035 Bedienungsanleitung

Lightolier

Lightolier Calculite ProSpec PA4H3870 Bedienungsanleitung

Lightolier

Lightolier PristineHW Series Bedienungsanleitung

Lightolier

Lightolier Lytecaster 1000LVR Bedienungsanleitung

Lightolier

Lightolier Lytecaster 1134 Bedienungsanleitung

Lightolier

Lightolier Lytecaster 1113CFL Bedienungsanleitung

Lightolier

Lightolier DSS01 Bedienungsanleitung

Lightolier

Lightolier Calculite AF2PF Bedienungsanleitung

Lightolier

Lightolier Calculite DP Bedienungsanleitung

Beliebte Leuchte Handbücher anderer Marken

Emos

Emos CLASSIC ZY1431T Bedienungsanleitung

Westinghouse

Westinghouse Outdoor Lighting Fixture Bedienungsanleitung

Hedler

Hedler C 12 silent Bedienungsanleitung

Blizzard Lighting

Blizzard Lighting Puck: CSI Bedienungsanleitung

Energetic Lighting

Energetic Lighting ELYSL-5004 Series Bedienungsanleitung

Lightmaxx

Lightmaxx Shaft 5R Bedienungsanleitung

Triarch

Triarch 31083 Bedienungsanleitung

Philips

Philips 32614 Series Bedienungsanleitung

IKEA

IKEA TIVED Bedienungsanleitung

Chauvet Professional

Chauvet Professional ROGUE R1 BEAM WASH Bedienungsanleitung

Martin

Martin MAC 250 Krypton Bedienungsanleitung

Cooper Lighting

Cooper Lighting Halo L3232E Bedienungsanleitung

Stageline

Stageline ODW-2410RGBW Bedienungsanleitung

Light Sky

Light Sky Tornado Series Bedienungsanleitung

ArtFox

ArtFox Beam 15R extreme Bedienungsanleitung

GLG

GLG multispot 330 Bedienungsanleitung

Home Accents Holiday

Home Accents Holiday TY052-1924-1 Bedienungsanleitung

SELF Electronics

SELF Electronics FLEX Bedienungsanleitung