Linear Multi-Code 3089 Bedienungsanleitung

OPERATIONAL CHECK

To check operation, move back a reasonable distance (about 50 ft.) and press the

transmitter button. Operation should be reliable at this distance but

environment and location of both the transmitter and receiver will affect the

range. If the transmitter is stowed well out of sight, it may be necessary to

remove it from its mounting and hold near the windshield. Try different locations

and positions. If operation is still unsatisfactory, the problem may be isolated by:

Checking the door operator.

If the door will not open when the wall button is

pressed, the problem is likely to be the operator. If the door will open by pressing

the wall button, but not when the radio control button is pressed, the problem is

probably in the radios.

Replacing the transmitter battery.

If after performing the above operational

checks, the controls still do not function, they should be returned to your dealer for

repair or replacement.

CAUTION:

Any changes or modifications in intentional or unintentional

radiators which are not expressly approved by LINEAR CORPORATION could

void the user’s authority to operate this equipment. This applies to intentional

and unintentional radiators certified per part 15 of the F.C.C. rules and

regulations.

LINEAR CORPORATION

2055 Corte del Nogal •Carlsbad, CA 92009

(760) 438-7000

INSTALLATION INSTRUCTIONS

DIGITAL TRANSMITTER MODEL 3089

Congratulations! You have just purchased a MULTI-CODE Digital Transmitter,

which we believe to be the finest product of its kind on the market. With a little

care this transmitter should provide you with many years of excellent service.

Please take a moment to read the following instructions and you will find that setting

your new transmitter will be quite an easy matter.

ACCESSING THE CODE SWITCH

On the model 3089 the entire front lower half of the transmitter is removable.

Grasp the front lower half of the case near the bottom on both sides and pull

upward away from the transmitter, this will disengage the lower end. Then pull

downward to remove the lower cover, this will expose both the code switch and

battery compartment.

INSTR,INSTL,MC3089,1CH,TX

LINEAR P/N: 215641 A

INK: BLACK

MATERIAL: 20 LB. MEAD BOND

SIZE: 9.000" x 3.500"

SCALE: 1-1

SIDE 1 OF 2

SELECTING A CODE

You may set your transmitter to any code you desire but be sure that the code you

set matches the code that has been set on your radio receiver. The digital code is

determined by the positions of the 10 small switches numbered 1 through 10

located in the receiver and transmitter. Any combination of ON (CLOSED) or OFF

(OPEN) positions can be selected by using a small screwdriver or ball point pen.

(NOTE: The switches are in the “On” position when the side next to the number

is pressed in.) In setting your own personal code we strongly urge that several

coding schemes be avoided: ALL ON; ALL OFF; 2,4,6,8,10 ON; 1,3,5,7,9 ON.

These positions are similar to our or other manufacturer’s test positions, or are

frequently used. Once the code has been set, check the operation and replace

the hatches.

TRANSMITTER INSTALLATION

The transmitter is completely self contained, including battery, and can be

operated while mounted in the car. It is supplied with a clip for attaching to the

sun visor, if desired. If the clip is used attach to the case by sliding it into the

recess provided on the back of the transmitter until the small dimples fit into the

holes in the clip.

TRANSMITTER BATTERY REPLACEMENT

Replacement battery - 9 volt NEDA 1604 (Eveready 216 or equivalent).

The battery in the transmitter can be checked or changed by removing the front

lower half of the transmitter. Refer to the directions under “accessing the code

switch” for battery replacement.

TO REPLACE OR ADD A SET

A replacement or new transmitter or receiver may be purchased by specifying

the Model Number and the RF frequency designated on the identification label.

The RF frequency is set at the factory and must not be adjusted in the field. The

digital code can be matched to the companion receiver or transmitter by

following the above procedure.

INSTR,INSTL,MC3089,1CH,TX

LINEAR P/N: 215641 A

INK: BLACK

MATERIAL: 20 LB. MEAD BOND

SIZE: 9.000" x 3.500"

SCALE: 1-1

SIDE 2 OF 2

12345678910

OPEN

Andere Handbücher für Multi-Code 3089

Andere Linear Sender Handbücher

Linear

Linear XT-1H Bedienungsanleitung

Linear

Linear Delta-3 Series Administratorhandbuch

Linear

Linear XT-4 Bedienungsanleitung

Linear

Linear MegaCode MCT-11 Bedienungsanleitung

Linear

Linear 2 GIG 2GIG-Z-BRDG-433 Konfigurationshandbuch

Linear

Linear DIGITAL TRANSMITTER GT-30 Bedienungsanleitung

Linear

Linear 1094 Bedienungsanleitung

Linear

Linear Multi-Code MCS307010 Bedienungsanleitung

Linear

Linear Multi-Code MCS1082 Bedienungsanleitung

Linear

Linear miniTransmitter Delta-3 Series Administratorhandbuch

Linear

Linear MULTI-CODE 3083 Bedienungsanleitung

Linear

Linear DXS-32 Bedienungsanleitung

Linear

Linear 3022 Bedienungsanleitung

Linear

Linear DX DXT-41 Bedienungsanleitung

Linear

Linear DXS-21 Bedienungsanleitung

Linear

Linear WT00Z-1 Bedienungsanleitung

Linear

Linear DX DXT-61 Technisches Handbuch

Linear

Linear AT7400 Bedienungsanleitung

Linear

Linear MegaCode MCT-3 Bedienungsanleitung

Linear

Linear Multi-Code 1051 Bedienungsanleitung

Linear

Linear Mini-Code 3060 Bedienungsanleitung

Linear

Linear DX DXS-65 Bedienungsanleitung

Linear

Linear Multi-Code 4120 Bedienungsanleitung

Linear

Linear Multi-code 4140 Bedienungsanleitung

Beliebte Sender Handbücher anderer Marken

NIVELCO

NIVELCO EasyTREK SCA-300 Series Betriebsanleitung

Honeywell

Honeywell 5816WMBR Bedienungsanleitung

Kamstrup

Kamstrup READy MTU Betriebsanleitung

Omega

Omega ZW Series Bedienungsanleitung

ABB

ABB Field 264H Leitfaden

Alinco

Alinco DJ-V17T Bedienungsanleitung

Dejero

Dejero EnGo 3x Bedienungsanleitung

Rosemount

Rosemount 4600 Bedienungsanleitung

Speaka Professional

Speaka Professional 2342740 Bedienungsanleitung

trubomat

trubomat GAB 1000 Bedienungsanleitung

Teledyne Analytical Instruments

Teledyne Analytical Instruments LXT-380 Bedienungsanleitung

Rondish

Rondish UT-11 Bedienungsanleitung

MG 10JRE Bedienungsanleitung

Burkert

Burkert 8177 Bedienungsanleitung

Firetide

Firetide HotPort 3203 Handbuch

Tele Radio

Tele Radio T9-02 Bedienungsanleitung

Rotronic

Rotronic HygroFlex HF3 Series Bedienungsanleitung

Jamara

Jamara FCX6 Pro Tel Bedienungsanleitung