Routine Cleaning and Maintenance
Regular Inspection and Maintenance
Cleaning：Please use clean water and neutral detergent to clean it, and use soft cloths and sponges to clean the surface;
It is prohibited to use metal brushes, sandpaper or the like to clean it, in order not to scratch the parts surface. After cleaning, dry it with soft cloths.
The scooter has no electricity,
and the READY lamp does not
shine.
When turning the speed
regulating steering handle-bar,
the motor does not turn after
being powered.
Speed is slow or mileage is
short.
Battery can not be charged.
Battery is poorly connected.
Air switch is not turned on.
Low battery volume.
Side stand is not retracted.
Brake handle does not reach the right position.
Steering handlebar failure.
The controller plug is loose.
Controller failure.
Low battery.
Under-inflated tire.
Heavily overloaded.
Brake pads interference.
Battery aging or normal scrap.
Poor contact of the main plug of the charger.
Do not use the wrong charger.
Battery aging or normal scrap.
Battery low-voltage protection.
Charge the battery.
Inflate the tire, and check the tire pressure before riding.
Foster a good habit, and keep the appropriate load Change
the brake pads and check the brake system before riding.
Change battery.
Check whether the main plug is in a right place Use the
special charger.
Contact of the main plug again.
Contact with local service office of battery.
Charge the battery.
Put away the side stand.
Close the parking key.
Place the brake handle at the right position.
Change handlebar.
Re-plug controller.
Change controller.
Connect the battery properly at its main plug.
Turn on the air switch.
TIPS:
TIPS:
Please disconnect the air switch before cleaning.
Do not use strong water jet to directly wash it, so as to avoid the default of mechanical parts caused by water invasion.
Storage: try to park it in a dry and cool room to reduce the exposure to sun and rain and avoid the reduction of service life due to corrosion of parts.
When left unused for a long time, please turn off the air switch and disconnect the power supply circuitto prevent over discharging.
After long-term storage, please fully charge it before use.
The new scooter must be subject to the first inspection and maintenance in the Service Center when it reaches 1,000 km or two months (whichever comes first).
The scooter is recommended to be subject to regular inspection and maintenance in the Service Center at every 3,000 km or six months (whichever comes first).
Please disconnect the air switch before cleaning.
Do not use strong water jet to directly wash it, so as to avoid the fault of mechanical parts caused by being damped.
Regular maintenance can improve the service life and driving safety of the electric scooters.
Please refer to the fol-lowing suggestions and take care of your scooter.
15 16
ROUTINE CLEANING AND MAINTENANCE ROUTINE CLEANING AND MAINTENANCE
Failure Causes Solutions
