●
●
●
●
How to Start - For your safety, you must read and follow all the instructions in this part.
Please wear a helmet and knee pads in case of falls and injuries when operating the scooter.
1.
2.
3.
4.
NOTE: The electric scooter must be moving at 3 miles per hour before the motor will engage.
Cruise Control
Step 1.
Step 2.
Step 3.
5.2
Practice until you are comfortable with using all of the scooter’s functions. See the following tips below.
●
●
●
●
●
MAINTENANCE
●
●
1.
2.
6.1
The Macwheel MX1 may need cleaning after riding for extended periods of time. See the following tips
below.
●
●
●
●
WARNING
Whenever you ride the Macwheel electric scooter you risk serious injury from collisions, falls or loss of
control. To ride safely, YOU MUST READ AND FOLLOW ALL INSTRICTIONS AND WARNINGS IN
THIS MANUAL.
Check local laws and regulations to see where and how you may use your Macwheel scooter legally.
Obey to all applicable laws for vehicles and pedestrians.
If you have any questions regarding the Macwheel MX1, feel free to contact us for further assistance.
Happy Riding!
The MACWHEEL® Team
SAFETY WARNINGS
1.1
Riding the electric scooter can be a hazardous activity. Certain conditions may cause the manufacturer.
Like other electric vehicles, the scooter can and is intended to move, and it is therefore possible to lose
control, fall off and/or get into dangerous situations that no amount of care, instruction or expertise can
eliminate. If such things occur you can be seriously injured or die, even when using safety equipment
and other precautions. RIDE AT YOUR RISK AND USE COMMON SENSE.
Please read and understand all warnings, cautions, instructions and safety topics as follows:
The recommended rider age is 8 and up. Any rider unable to fit comfortably on the scooter should not
attempt to ride it.A parent’s decision to allow his or her child to ride this product should be based on the
child’s maturity, skill and ability to follow rules.
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
WARNING - Failure to use common sense and heed the above warnings increases risk of serious
injury. Use with appropriate caution and serious attention to safe operation.
1.2
This product must not be disposed of by incineration, landfill or mixing with household trash. Improper
disposal of the battery contained within this product may result in the battery heating up, rupturing, or
igniting which may cause serious injury. The substances contained inside the battery present chemical
risks to the environment. The recommended disposal for any MACWHEEL Electric Scooter at its
Warning
Always wear proper protective equipment such as an approved safety helmet(with chin strap
securely buckled), elbow pads and knee pads. A helmets may be legally required by local law or
regulation in your area.
Do not place the battery in fire or direct contact with heat or sunlight.
Do not touch the brakes or motor on your scooter when in use as these parts can become very hot.
Do not attempt or do stunts or tricks on your electric scooter. The scooter is not made to withstand
abuse from misuse such as jumping, curb grinding or any other type of stunts.
Do not ride your scooter in wet or icy weather and never immerse the scooter in water, as the electri-
cal and drive components could be damaged by water or create other possibly unsafe conditions.
Do not ride at night or when visibility is limited.
Never allow more than one person at a time to ride the scooter.
Never use near steps or swimming pools.
Never use headphones or a cell phone when riding.
The charger supplied with the electric scooter should be regularly examined for damage to the
cord, plug, enclosure and other parts, and in the event of such damage, the scooter must not be
charged until the charger had been repaired or replaced.
Use only with the recommended charger.
Use caution when charging.
The charger is not a toy. Charger should be operated by an adult.
Do not operate charger near flammable materials.
Unplug charger and disconnect from scooter when not in use.
Do not exceed charging time.
Always disconnect from the charger prior to wiping down and cleaning your scooter with liquid.
Disposal at End-of-Life
end-of-life is to dispose of the entire unit at or through a MACWHEEL recycling center, program, or
facility. Local regulations and laws pertaining to the recycling and disposal of lithium-ion batteries and/or
products containing them will vary according to country, state, and local governments.
You must check laws and regulations corresponding to where you live in order to dispose of the battery
and/or unit properly. It is the user’s responsibility to dispose of their waste equipment properly in
accordance with local regulations and laws.
For additional information about where you should drop off your batteries and electrical or electronic
waste, please contact your local or regional waste management office, your household waste disposal
service, or your point-of-sale.
1.3
DECLARATION OF CONFORMITY
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may cause
undesired operation.
FCC RELATED INFORMATION
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequen-
cy energy and, if not installed and used in accordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
●
●
●
●
FCC Information
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
PARTS & FEATURES
Please read the user manual in its entirety before using the MACWHEEL MX1 so that you may fully
understand its parts and functions and be able to operate it safely.
2.1
2.2
Main Parts
Diagram
2.3
The Macwheel MX1 display features several different elements. Be sure you understand these before
attempting to ride. Press and hold the power button approx. 3~5 seconds to turn the scooter on/off.
1.
2.
ASSEMBLY & FOLDING
Ensure the MACWHEEL MX1 is off before working with any of its parts. The scooter comes mostly
assembled within the package. Some minor assembly is required before riding. All parts and tools are
included.
3.1
3.2
Standing
Folding
Unfolding
Display Information
Battery Level Indicator - This icon indicates how much
battery life you have left. As power goes down, the icon will
indicate different levels.
Speedometer - These numbers indicate the current speed
and will change when the Macwheel MX1 is in use.
Readings are measured in mph.
When the battery level is low, stop riding, turn off the
scooter, and fully recharge it before riding again.
Assembling the Handlebars
Standing, Folding & Unfolding the Scooter
First, thread the section with the brake and bell onto the left
side of the handlebars, then use an Allen key to tighten the
screw underneath it. Next, screw the handles in. Lastly, make
sure everything is securely attached.
Before using the kickstand, bring the scooter to a complete
stop and turn it off. Before riding the scooter again, lean the
scooter off the kickstand and fold the kickstand up.
Step 1. Locate the kickstand on the side of the scooter’s deck.
Step 2. Push the kickstand down and away from the scooter
then carefully lean the weight of the scooter onto the
kickstand.
Step 1. Turn the collar counter clockwise to unlock the latch.
Step 2. Fold the latch down then pull the stem down towards
the deck.
Step 3. Line up the handlebars with the rear bumper so that
the lock connects to the hook.
Step 1. Move the lock so that it detaches from the hook.
Step 2. Pull the stem up away from the deck.
Step 3. Fold the latch up towards the stem and turn the collar
clockwise to lock it.
Before moving, lifting, or otherwise transporting the scooter,
ensure it is turned off.
3.3
1.
2.
3.
4.
5.
6.
CHARGING
Charge the Macwheel MX1 before using it.
The charge cycle is complete when the battery indicator on display is full. Each charge cycle from zero
to full charge will take approximately 5 hrs. When the backlit display on the handlebars indicates that
battery power is low, recharge the MX1. To recharge the MX1, use the included charger.
Step 1.
Step 2.
Step 3.
Step 4.
DO NOT(under any circumstances)use the scooter while it is charging or connected to the charger.
The charging time is approximately 5 hours. Charging longer than that may affect battery life and/or
performance. If the charger’s light doesn’t turn on, it may not be fully connected. Check that it is securely
connected to the wall and to the scooter.
RIDING OPERATION
We sincerely hope every operator can ride the Macwheel MX1 safely. Note the following information before
attempting to ride your Macwheel MX1.
●
●
●
●
●
5.1
First, choose a suitable venue for riding. Next, unfold the scooter in accordance with the instructions. Last,
adjust the T-pipe to the suitable height according to your height.
●
●
●
●
●
●
●
1
2
Locked Unlocked
Latch
Collar
Non-Pneumatic Tires
Inflation-free, maintenance-free, explosion-proof, anti-tie.
The wheel hub is fitted with the inner tube tire tightly, and the steel wire protection is more safe.
Excellent flexibility. The foamed inner tube adopts microwave closed-cell foaming to make the
performance of comfortability close to the traditional inflation tire.
Foamed inner tube adopts improved rubber and improved polymer environmental protection materi-
als, and the products are environmentally friendly and non-toxic.
Wear-resistant and anti-skidding. The shell uses a traditional rubber tire which has good perfor-
mance, and passed the market testing.
Weather resistance. It features with high temperature resistance, low temperature resistance and
aging resistance.
An ASTM F1492 approved helmet as well as other protective gear must be worn at all times.
The MX1 supports up to 256 lbs (120 kg).
Before each ride, especially if you may travel a long distance, check the front tire for proper inflation,
check all cables for damage, and test the brakes. Do not ride if any part of the scooter is damaged or
malfunctioning.
Only operate the Macwheel MX1 where permitted. Local laws may restrict where you may ride.
In compliance with UL2272 standards, power to the Macwheel MX1 motorized wheel may cut off during
continuous uphill travel and/or other cases which cause the motor to overheat. If the motor overheats,
this safety feature will trigger automatically. Stop riding and allow ~15 minutes before using the motor
again. In general, continuous uphill travel at 14° slopes for long periods of time is not recommended.
Getting Ready
Start your scooter by pressing and holding the power button for 3~5 seconds.
Moving forward with your scooter is as easy as pressing the throttle.
Cruising is as simple as maintaining speed for at least 5 seconds.
Use the bell to alert pedestrians and other riders of your presence.
Turn the headlight on/off by quick-pressing the power button twice.
Switch gears between 1, 2, and 3 by quick-pressing the power button once. Each gear has different
speed. Gear 1’s max. is 5 mph, Gear 2’s is 10 mph, and Gear 3’s is 18 mph.
The display shows how much battery power is left.
To slow down, gradually ease off the throttle and apply pressure to the brake.
To stop, apply full pressure to the brake until the scooter stops completely.
When the headlight is turned on, the taillight will also blink for increased visibility.
Gear speeds are approximate. Actual speed may vary due to terrain, rider weight, and/or other factors.
Practicing Guidelines
Wear casual clothing and flat, closed-toe shoes to maintain your flexibility and stability.
Practice until you can easily get on, move forward, turn, stop, and dismount with ease.
Make sure the pavement is even. Do not operate on a slope until you are experienced.
The Macwheel MX1 is designed for relatively smooth, flat terrain. When driving on uneven terrain, slow
down.
Until you are comfortable using the scooter, avoid operating in places with pedestrians or obstacles.
Do not perform any maintenance when the power is on, or the battery is charging. Do not let water
or liquids get into the scooter as this will cause permanent damage to the electronic components.
After each ride, especially if you have traveled a long distance, inspect your scooter.
Inspect the brake to make sure it’s working properly.
Make sure all screws and bolts are taut and properly fastened to prevent injury and unnecessary wear
and tear.
For questions, concerns, or part replacement, please contact customer service.
Cleaning
Completely power off the scooter before cleaning.
Use dry, non-abrasive cloth to gently remove debris or dust.
If needed, dampen cloth with water or a mild cleaner and wipe off the scooter.
Never use alcohol or ammonia-based cleaning solutions.
●
●
6.2
●
●
●
6.3
Before moving, lifting, or otherwise transporting the scooter, turn it off. Fold the scooter (see Section 3.3 for
instructions) and pull the scooter along as you move it if needed.
SPECIFICATIONS
Never spray liquid directly onto any part of the scooter.
Do not allow any type of liquid to come in contact with the scooter’s electronic parts.
Storage
Before storing the scooter, fully charge it to prevent battery over-discharge due to non-use.
Do not expose the scooter under the sun or wet places for too long time. Please store the scooter in a
dry and warm environment, away from draft and moist, where the temperature is constant and at least
15 degrees. Please keep the scooter clean and dry.
For cleaning use a damp cloth and a mild detergent.
Transportation
When lifting the entire scooter, please note that the Macwheel MX1 weighs approximately 28.35
lbs (12.86kg). If you are unsure of your ability to lift this weight, please use both hands or have
a second person help.
WARRANTY
The manufacturer warranties this product to be free of manufacturing defects for a period of 1 year
from date of purchase. This Limited Warranty does not cover normal wear and tear, tires, tubes or
cables, or any damage, failure or loss caused by improper assembly, maintenance, or storage or use
of the Macwheel MX1.
This Limited Warranty will be void if the product is ever
•
•
•
•
The manufacturer is not liable for incidental or consequential loss or damage due directly or indirectly
to the use of this product.
Used in a manner other than for recreation or transportation
Modified in any way
Failure to follow the instructions or to perform any preventive maintenance
External causes such as accidents, abuse, or other actions or events beyond our reasonable
control
- 04 -
