Carefully select the installation location of the MAKS WDC mini
detector.
The device should not be placed:
1. Outdoors or in areas with unacceptable humidity and tempera-
ture
2. In places with a high level of radio interference
3. Near objects that can cause radio signal attenuation or shielding
(metal, mirrors, etc.)
4. At a distance of less than 1 m from the security center
Excellent connection - LED indicator flashes green
Satisfactory connection - LED indicator flashes yellow
Poor connection - LED indicator flashes red
No connection - LED indicator flashes red quickly
In test mode, the unit's radio transmitter operates at medium power.
Functional parts of the device
Selecting the installation location
Installation and connection
Registration and setup Switching on and off
Press button 9to turn on the device - the indicator will be on. If the
device is registered in the MAKS PRO, it switches to standby mode.
If the sensor is not registered, it will switch to sleep mode after 30
seconds.
To turn off the device, press and hold button 9for 5 seconds.
2
1
3
1. Bottom plate of magnet case
2. Magnet case cover
3. Neodymium magnet
4. Bottom plate of the detector case
5. Detector case top cover and capsule with the device
6. Magnet position marks
7. LED indicator
8. Tamper contact
9. On/off button
10. Battery CR2
4
9
10
8
+
-
4 5 4
66
7
1 2 3
1 2 3
Indication in communication test mode
1. Place the detector at a distance of no more than 2 m from the
MAKS PRO security center. The registration runs at the lowest
possible power to avoid the influence of neighboring systems
which can be being set up nearby.
2. Start the MAKS Setup application
3. Follow the instructions of the application to connect to the
MAKS PRO and start the registration of MAKS wireless devices
4. Turn on the MAKS WDC mini, after 10-20 seconds it will be
registered
5. Set up a new device in your mobile application
The sensor can be placed vertically or horizontally. Install magnet
near mark 6on the detector case.
We recommend to install the device in the following order:
1. Selecting the installation location with the best signal using the
MAKS Setup application
2. Mounting the magnet (step 1)
3. Installation of the detector bottom plate (step 2),
4. Installation of the device (step 3)
When the capsule is inserted correctly, the tamper must be clamped
(locked).
