Marshall Amplification ORIGIN 20 Bedienungsanleitung
ORIGIN 20
ORIGIN 50
USER MANUAL
CONGRATULATIONS ON
PURCHASING YOUR MARSHALL
ORIGIN AMPLIFIER.
ENGLISH
THE ORIGIN PROVIDES USEFUL MODERN FEATURES INCLUDING: TILT TONE
CONTROL, TO BLEND BETWEEN TWO DISTINCTLY DIFFERENT VOICES,
AND AN EMULATED OUTPUT FOR THOSE LOOKING TO RECORD DIRECTLY.
WE HOPE YOU ENJOY YOUR NEW ORIGIN AS MUCH AS WE HAVE ENJOYED
DESIGNING AND BUILDING IT FOR YOU.
THE MARSHALL TEAM
IMPORTANT SET UP INFORMATION:
1. When using your Origin with an
extension speaker cabinet(s), make
sure that the speaker cabinet(s) is
connected to the correct loudspeaker
jack socket(s). See section 4.1, 4.2 and
4.3 for specic information.
Warning: failure to do the above
may damage your amplier. When
connecting a speaker cabinet make
sure that you use a proper speaker
cable. Never use a screened (shielded)
guitar cable for this purpose.
2. Ensure that the power switch is set
to the off position (front panel
function 3.1).
3. Connect the supplied mains (power)
lead into the mains input on the rear
panel rst and then into an electricity
outlet.
Warning: Before going any further, make
sure that your amplier is compatible
with your mains electricity supply. If you
have any doubt, please seek help from a
qualied technician – your Marshall dealer
can help you with this.
MAINS INPUT & FUSE:
The specic mains input voltage
rating that your amplier has been
manufactured for is indicated on the rear
panel. Your amplier is provided with a
detachable mains (power) lead, which
should be connected to the mains input
socket on the rear panel. The correct
value and type of mains fuse is specied
on the rear panel.
Never attempt to bypass the fuse or t
one of the incorrect value or type.
4. Ensure that the volume controls on the
front panel are set to zero.
5. Plug your guitar into the input jack
socket on the front panel.
6. Select either high, mid or low power
(front panel function 3.2).
7. Turn the front panel switch on and wait
a couple of minutes.
8. Turn the volume up to your preferred
level and your amplier is ready to play.
TRANSPORTING YOUR EQUIPMENT:
Please ensure that your amplier is
switched off, unplugged from the mains
electricity supply and all removable
cables have been disconnected from your
equipment before attempting to move it.
1.0
WARNING! SAFETY INSTRUCTIONS
PLEASE READ THIS MANUAL CAREFULLY BEFORE PLUGGING IN. FOLLOW ALL INSTRUCTIONS AND HEED ALL WARNINGS.
The combo enclosures and speaker
choices have been carefully selected to
bring out the natural valve tone with the
20W combo being loaded with a Celestion
V Type 10” speaker and the 50W Combo
using a Celestion Midnight 60 12”
speaker.
Additional functionality such as the foot
switch gain boost, effects loop, and ability to
run the ampliers without a speaker load,
make the Origin range exceptional for the
modern player.
Available in both 20W and 50W power
outputs and as either a head or combo,
every Origin has been designed to offer
the perfect solution for players looking
to create great music.
The tone of the Origin amplier is
unmistakeably Marshall using 3x ECC83
preamp valves and 2x EL34 power
valves to generate rich harmonics and
exceptional tone. While the amplier is a
single channel unit, the design of the tone
circuit means it offers two very distinctive
voices. Accessing your preferred sound
can be easily achieved using the inbuilt tilt
control which when turned fully counter
clockwise will access a subtler tonal
structure. Dialling the tilt control fully
clockwise will increase the brightness of
sound for a more cutting tone. A presence
control also allows ne tuning of your tone
in the power stage for even greater tonal
detailing.
ORIGIN 20
VALVES
3x ECC83 + 2x EL34
SPEAKER
Celestion V Type 10”
(Combo only)
POWER CONTROL
3 way switchable
High, mid and low
TILT CONTROL
Single channel control
Adjust between normal and high treble
EQUALISATION
Treble, middle and bass
FOOTSWITCHABLE FEATURES
Effects loop
Gain boost
ORIGIN 50
VALVES
3x ECC83 + 2x EL34
SPEAKER
Celestion Midnight 60 12”
(Combo only)
POWER CONTROL
3 way switchable
High, mid and low
TILT CONTROL
Single channel control
Adjust between normal and high treble
EQUALISATION
Treble, middle and bass
FOOTSWITCHABLE FEATURES
Effects loop
Gain boost
2.0
OVERVIEW AND SPECIFICATION
1. POWER SWITCH
Turns your amplier on and off.
2. OUTPUT LEVEL
Adjusts the output power level. At high
power the output will be the maximum
available power level. At mid power the
output of the amplier is set for quieter
performance use and recording (ORI20:
approx. 3W / ORI50: approx. 10W). At
low power the output will be reduced for
home practice (ORI20: approx. 0.5W /
ORI50: approx. 0.5).
Note: reducing the power output allows
you to drive the power stage harder at
low volumes. This provides the ability to
benet from the rich tonal qualities that a
valve power amp can create without the
need to operate at loud volume levels.
3. POWER LIGHT
When the unit is switched on this light
will illuminate.
4. PRESENCE
Adjusts the response of the power
amplier increasing the higher
frequencies of your sound.
5. MASTER VOLUME
Adjusts output volume. At higher settings,
the power amplier can be overdriven,
giving a classic overdrive sound.
EQ Settings: your Origin amplier has
4 equalisation controls (presence, treble,
middle and bass) plus an amplier channel
voice control (tilt). All these controls allow
you to adjust the frequency and voicing.
Each control is highly effective and
interactive.
6. TREBLE
Controls the higher frequency of
your sound.
7. MIDDLE
Controls the middle frequency of
your sound.
8. BASS
Controls the lower frequency of
your sound.
ORIGIN HEAD (COMBO SHOWN ON NEXT PAGE)
14
32 5 67 8 9 10 11
ENGLISH
3.0
FRONT PANEL FUNCTIONS
THE INFORMATION SHOWN APPLY TO BOTH 20 AND 50, HEAD AND COMBO FORMATS.
9. TILT
Adjusts the voice of your Origin from
normal to high treble at the input stage.
Tilt: this control provides a blend between
normal and high treble pre-amplier
channels on a classic Marshall. Dialled all
the way to the left the sound is warm and
full, providing a thick overall tone. When
dialled all the way to the right the overall
tone is brighter for players looking for
more cut through and bite. When set at 12
o’clock the tilt control provides an equal
blend of both pre-amp voicings.
10. GAIN
Controls the amount of pre-amp gain
applied to your sound, the more gain
the more distortion. Pulling the control
knob activates a gain boost increasing the
level of drive in the pre-amp. This can be
operated using a 2-way foot switch
(PEDL-90016).
Note: when a foot switch is connected
it will override the front panel control
meaning the gain boost can only be turned
on and off using the foot switch.
ENGLISH
11. INPUT
Connect your guitar to the amplier using
a ¼” instrument cable.
ORIGIN COMBO (HEAD SHOWN ON PREVOUS PAGE)
3.0
FRONT PANEL FUNCTIONS CONTINUED
THE INFORMATION SHOWN APPLY TO BOTH 20 AND 50, HEAD AND COMBO FORMATS.
GAININPUT TREBLEMIDDLEBASS MASTER POWEROUTPUT
HIGH ON
MID
LOWOFF
TILT PRESENCE
PULL BOOST EQUALISATION OUTPUT
11 89
10 7 65 4 3 2 1
1. 16 OHM OUTPUT
ORI20 and ORI50 head
Connect a single 16 OHM speaker cabinet
using this socket.
ORI20 combo
Your Celestion V type 10” speaker is
connected here.
ORI50 combo
Your Celestion Midnight 60 12” speaker is
connected here.
2 & 3. 8 OHM OUTPUT
Connect an 8 OHM cabinet using socket
#3, or connect a pair of 16 OHM speaker
cabinets to sockets #2 and #3.
Note: before connecting and
disconnecting speaker loads, always
ensure that the amplier is switched off.
4. DI-OUTPUT
Connect your amplier to an external
recording device or sound desk using this
output socket with added loudspeaker
emulation.
5. FOOT SWITCH
Connect a 2-way foot switch
(PEDL-90016) to control the gain boost
and turn the effects loop on and off.
6. EFFECTS LOOP SEND
Sends your signal to your effects or
outboard processor.
7. EFFECTS LOOP RETURN
Returns your signal from your effects or
outboard processor.
8. MAINS INLET
Connect your amplier to the supplied
mains lead using this socket.
4.0
REAR PANEL FUNCTIONS
ENGLISH
7
654321 8
WHILST THE INFORMATION CONTAINED HEREIN IS CORRECT AT THE TIME
OF PUBLICATION, DUE TO ITS POLICY OF CONSTANT IMPROVEMENT AND
DEVELOPMENT, MARSHALL AMPLIFICATION PLC RESERVES THE RIGHT TO
ALTER SPECIFICATIONS WITHOUT PRIOR NOTICE.
MARSHALL AMPLIFICATION PLC,
DENBIGH ROAD,
BLETCHLEY, MILTON KEYNES,
MK1 1DQ, ENGLAND.
T: +44 (0) 1908 375411
F: +44 (0) 1908 376118
MARSHALL AMPLIFICATION PLC
REGISTERED IN ENGLAND
REGISTERED NUMBER: 805676
BOOK-91024-V.01-20 NOVEMBER 2017
Andere Handbücher für ORIGIN 20
1
Inhaltsverzeichnis
Andere Marshall Amplification Verstärker Handbücher
Marshall Amplification
Marshall Amplification BASS STATE B 150 Bedienungsanleitung
Marshall Amplification
Marshall Amplification CODE25 Bedienungsanleitung
Marshall Amplification
Marshall Amplification EL84 20/20 Bedienungsanleitung
Marshall Amplification
Marshall Amplification CODE Bedienungsanleitung
Marshall Amplification
Marshall Amplification JVM410C Bedienungsanleitung
Marshall Amplification
Marshall Amplification VALVETEST AVT100X Bedienungsanleitung
Marshall Amplification
Marshall Amplification MGP 9001 Bedienungsanleitung
Marshall Amplification
Marshall Amplification JCM 2000 DSL 100 Bedienungsanleitung
Marshall Amplification
Marshall Amplification JVM2 Series Bedienungsanleitung
Marshall Amplification
Marshall Amplification VDA-108-3GS Bedienungsanleitung
Marshall Amplification
Marshall Amplification MEGASTACK MG15FXMSDM Bedienungsanleitung
Marshall Amplification
Marshall Amplification STUDIO VINTAGE SV20H Bedienungsanleitung
Marshall Amplification
Marshall Amplification MG250DFX Bedienungsanleitung
Marshall Amplification
Marshall Amplification MG10KK SERIES Bedienungsanleitung
Marshall Amplification
Marshall Amplification JCM800 Bedienungsanleitung
Marshall Amplification
Marshall Amplification STUDIO JTM ST20H Bedienungsanleitung
Marshall Amplification
Marshall Amplification VS65R Bedienungsanleitung
Marshall Amplification
Marshall Amplification Jubillee Bass 3530 Bedienungsanleitung
Marshall Amplification
Marshall Amplification MINI JUBILEE 2525H Bedienungsanleitung
Marshall Amplification
Marshall Amplification AFD100 Slash Signature Series Bedienungsanleitung
Marshall Amplification
Marshall Amplification PA400 Bedienungsanleitung
Marshall Amplification
Marshall Amplification Acoustic Soloist AS100D Bedienungsanleitung
Marshall Amplification
Marshall Amplification DSL20CR Bedienungsanleitung
Marshall Amplification
Marshall Amplification 1959SLP Bedienungsanleitung
