Maxkin DWS-300PLUS Bedienungsanleitung
User Manual
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
Printed in China
2019 V 1.0
RF exposure warning :
This equipment complies with FCC radiation exposure limits set forth
for an uncontrolled environment. This equipment shall be installed and
operated with minimum distance 20cm between the radiator & body.
The sensor transmits signal to control panel when the
The tamper protection ensures that sabotage attempts
to move the sensor will result in an alarm activation.
2
34
5
7
6
2.LED Indicator
3.Magnet
Installation:
1
Door or window is opened, and the transmitter
sends signal to the control panel.
55
<1cm
It will cause on immediate alarm if the magnet
depart from the transmitter more than 2cm in
arming state.
1. Open the back cover of the sensor, pull out the battery tab and
check the battery is fitted properly.
2. Ensure the area that the sensor will be located is clean and free
from dust and moisture. Avoid mounting the sensor in areas with
lots of metal or electrical wiring.
3. Use the adhesive strip to carefully mount the sensor on to the
door/window frame.
4. Mount the magnet on to the door/ window, no more than 1cm
from the sensor.
Please follow manual of alarm system for zone setup. Zone Jumper:
The door sensor is set in normal zone1 as default.
Dimensions (L x W x H): 48 x 71 x 18mm
Temperature:
Humidity:
The new-bought door sensors should be enrolled to the control
panel before use.
Press enroll button of control panel, trigger the sensor by moving the
magnet away from the sensor. The enrolled sensors will automatically
appear in the Accessories Menu in the app. You can customize the
accessory name, select the zone type and also delete the accessory
from the app, if required. For specified operation, please refer to the
manual of alarm system.
Wireless RF Frequency: FHSS 433MHz
70mA
Transmit Current:
Andere Maxkin Zubehör Handbücher
