Meinberg XHE-Rubidium Bedienungsanleitung

MANUAL

XHE-Rubidium

Holdover Extension

28th July 2020

Meinberg Funkuhren GmbH & Co. KG

Front view (Frontansicht) XHE-Rubidium

DEUTSCH

1. LED Statusanzeige: Status

PPS Eingangssignal

PPS Ausgang zum Empfänger

Fehler / Alarm

ENGLISCH

1. LED status Indicators: State (normal operation: green)

PPS input Signal from Receiver

PPS output signal to receiver

Error / Alarm

XHERb

External Holdover Expansion

Status PPS In PPS Out Alarm

System A

System B

Rear view (Rückansicht) XHE-Rubidium

XHE-REL

CO NO NC CO NO NC CO NO NC

A B C

V1/2

POWER 1

POWER 2

POWER 1

XHE-REL

CO NO NC CO NO NC CO NO NC

A B C

V1/2

POWER 1

POWER 2

POWER 1

100-240 V AC (50-60 Hz) / 100-200 V DC

3. PSU 2: XHE-PWR-DC :: DC Netzteil

4. XHE-REL :: XHE Relaismodul

5. XHE-SPI RUBIDIUM :: XHE Rubidium-Modul

20-60 V DC

DEUTSCH

1. PSU 1: XHE-PWR-AC/DC :: AC/DC Netzteil,

2. XHE-CON AC/DC | DC :: Anschlussmodul für AC/DC Netzteile

20-60 V DC

1. PSU 1: XHE-PWR-AC/DC :: AC/DC Power Supply,

2. XHE-CON AC/DC | DC :: Connector Module for AC/DC Power

4. XHE-REL :: XHE Relais Module

5. XHE-SPI RUBIDIUM :: XHE Rubidium Module

ENGLISH

100-240 V AC (50-60 Hz) / 100-200 V DC

3. PSU 2: XHE-PWR-DC :: DC Power Supply,

1 2 3 4 5 12 3 4 5

Rubidium

Status

PPS _In

PPS _Out

Alarm

Rubidium

Status

PPS _In

PPS _Out

Alarm

Table of Contents

1 Imprint 1

2 Used Symbols 2

3 Safety instructions for building-in equipment 3

3.1 Additional Safety Hints ........................................... 4

3.2 Supply Voltage ................................................ 4

3.3 Cabling ..................................................... 5

3.4 XHE Air Cooling in the Server Rack ................................... 5

3.5 Grounding connection XHE ......................................... 6

4 External Holdover Expansion XHE - Rubidium 7

5 Initial Start of the System 8

6 Technical Speziﬁcations XHE 9

6.1 Chassis Architecture XHE .......................................... 10

6.2 AC/DC Power Connector .......................................... 12

6.3 DC Power Connector ............................................. 13

6.4 XHE-REL Error Relay ............................................ 14

6.5 XHE Connectors ............................................... 15

7 Declaration of Conformity 16

Date: 28th July 2020 XHE-Rubidium

1 Imprint

Meinberg Funkuhren GmbH & Co. KG

Lange Wand 9, 31812 Bad Pyrmont / Germany

Phone: + 49 (0) 52 81 / 93 09 - 0

Fax: + 49 (0) 52 81 / 93 09 - 230

Internet: https://www.meinbergglobal.com

Mail: [email protected]

Date: 28.07.2020

XHE-Rubidium Date: 28th July 2020 1

2 Used Symbols

Nr.

Symbol

Beschreibung / Description

IEC 60417-5031

Gleichstrom /

Direct current

IEC 60417-5032

Wechselstrom /

Alternating current

IEC 60417-5017

Erdungsanschluss /

Earth (ground) Terminal

IEC 60417-5019

Schutzleiterklemme /

Protective Conductor Terminal

Vorsicht, Risiko eines elektrischen Schlages /

Caution, possibility of electric shock

ISO 7000-0434

Vorsicht, Risiko einer Gefahr /

Caution, Danger

2012/19/EU

Dieses Produkt fällt unter die B2B Kategorie. Zur Entsorgung

muss es an den Hersteller übergeben werden.

This product is handled as a B2B category product. In order to

secure a WEEE compliant waste disposal it has to be returned

to the manufacturer.

CE label

This device follows the provisions

of the directives 93/68/EEC

2 Date: 28th July 2020 XHE-Rubidium

3 Safety instructions for building-in equipment

This building-in equipment has been designed and

tested in accordance with the requirements of Stan-

dard IEC60950-1 "Safety of Information Technology

Equipment, including Electrical Business Equipment".

During installation of the building-in equipment in

an end application (i.e. rack) additional requirements

in accordance with Standard IEC60950-1 have to be

taken into account.

NOTE: First attach the case to protective earth -

before you connect the XHE with the power line (see

chapter Grounding connection XHE).

General Safety instructions

•The building-in equipment has been evaluated for use in oﬃce environment (pollution degree 2) and

may be only used in this environment. For use in rooms with a higher pollution degree more stringent

requirements are applicable.

•The equipment/building-in equipment was evaluated for use in a maximum ambient temperature of 40◦C.

•The building-in equipment may not be opened.

•Protection against ﬁre must be assured in the end application.

•The ventilation opening may not be covered.

For AC Supply 100-240 V AC

•The building-in equipment is a class 1 - equipment and must be connected to an earthed outlet

(TN Power System).

•For safe operation the building-in equipment must be protected by max 16 A fuse in the power installation

system.

•Disconnection of the equipment from mains is done by pulling the mains plug at the outlet. Don’t use the

connector at the module for disconnection from mains.

For DC Supply 100-200 V DC

•The device can be disconnected outside the unit in accordance with the regulations as in EN 60950 (e.g.

through primary side line protection).

•Assembling and disassembling of the power connector is only allowed if the device is disconnected from

power supply (e.g. trough primary side line protection).

•All feed lines are suﬃciently protected and dimensioned.

XHE-Rubidium Date: 28th July 2020 3

3.1 Additional Safety Hints

This manual contains important information for the installation and operation of this device as well as for your

safety. Make sure to read carefully before installing and commissioning the device.

Certain operating conditions may require the observance of additional safety regulations not covered by this

manual. Nonobservance of this manual will lead to a signiﬁcant abatement of the security provided by this

device. Security of the facility where this product is integrated lies in the responsibility of the installer.

The device must be used only for purpose named in this manual, any other use especially opteration above the

limits speciﬁed in this document is considered as improper use.

Keep all documents provided with the device for later reference.

This manual is exclusively for qualiﬁed electricians or by a qualiﬁed electrician trained personnel who are

familiar with the applicable national standards and speciﬁcations, in particular for the construction of high

voltage devices.

3.2 Supply Voltage

WARNING!

This device is powered by a dangerous voltage. Nonobservance of the safety instructions of this manual may

lead to serious damage to persons and property and to danger to life! Installtion, commissioning, maintenance

and operation of this device are to be carried out by qualiﬁed personnel only.

The general safety instructions and standards ( e.g. IEC, DIN, VDE, EN ) for installation and work with

high voltage equipment as well as the respective national standards and laws must be observed.

NONOBSERVANCE MAY LEAD TO SERIOUS DAMAGE TO PERSONS AND PROPERTY AND TO DAN-

GER TO LIFE!

The device may not be opened. Repair services may only be carried out by the manufaturer.

Supply lines for this decice must be equipped via an appropriate switch that must be mounted close to the

device and must be marked as a mains switch for the device.

To ensure safe operation supply mains connected to this decice must be equipped with a fuse and a fault-

current circuit breaker according to the applicable national standards for safe operation.

The device must be connected to a protective earth with low grounding resistance according to the applicable

national rules.

4 Date: 28th July 2020 XHE-Rubidium

3 Safety instructions for building-in equipment

3.3 Cabling

WARNING!

DANGER TO LIFE BY ELECTRICAL SHOCK! NO LIVE WORKING!

Wiring or any other work done the connectors particularly when connectors are opened may never be carried out

when the installation is energized. All connectors must be covered to prevent from accidental contact to life parts.

ALWAYS ENSURE A PROPER INSTALLATION!

3.4 XHE Air Cooling in the Server Rack

Attention: To ensure suﬃcient cooling of the system,

free space of at least 1U above and below the XHE

must be maintained to the next installed chassis in the

rack (see ﬁgure right).

XHE-Rubidium Date: 28th July 2020 5

Andere Handbücher für XHE-Rubidium

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Meinberg Netzwerkzeitserver Handbücher

Meinberg

Meinberg LANTIME M300 Bedienungsanleitung

Meinberg

Meinberg LANTIME M300/MRS/AD10-AD10 Gebrauchs- und Pflegehandbuch

Meinberg

Meinberg LANTIME M100 GPS Gebrauchs- und Pflegehandbuch

Meinberg

Meinberg LANTIME M300/GNS/RPS Gebrauchs- und Pflegehandbuch

Meinberg

Meinberg LANTIME M400 Gebrauchs- und Pflegehandbuch

Meinberg

Meinberg LANTIME M300/GPS/2LNE/AD10-AD10 Gebrauchs- und Pflegehandbuch

Meinberg

Meinberg LANTIME M300/GNS/AD10-AD10 Gebrauchs- und Pflegehandbuch

Meinberg

Meinberg LANTIME M300/TCR Gebrauchs- und Pflegehandbuch

Meinberg

Meinberg LANTIME M300 Gebrauchs- und Pflegehandbuch

Meinberg

Meinberg LANTIME M600 Gebrauchs- und Pflegehandbuch

Meinberg

Meinberg LANTIME M200/GPS Gebrauchs- und Pflegehandbuch

Meinberg

Meinberg LANTIME M100 Bedienungsanleitung

Meinberg

Meinberg LANTIME M300 PZF Gebrauchs- und Pflegehandbuch

Meinberg

Meinberg LANTIME M300/RDT Gebrauchs- und Pflegehandbuch

Meinberg

Meinberg LANTIME M400/GPS Gebrauchs- und Pflegehandbuch

Meinberg

Meinberg IMS LANTIME M1000 Bedienungsanleitung

Beliebte Netzwerkzeitserver Handbücher anderer Marken

EKOS

EKOS EKOSync 1588 Bedienungsanleitung

TPA

TPA S5 Bedienungsanleitung

Gorgy Timing

Gorgy Timing LEDI NETWORK iTS Bedienungsanleitung

Mobatime

Mobatime DTS 4160.grandmaster Bedienungsanleitung

Mobatime

Mobatime DTS 4128.timeserver Bedienungsanleitung

BRG Precision Products

BRG Precision Products NTP100B Bedienungsanleitung

Krontek

Krontek KT2000 Bedienungsanleitung

Mobatime

Mobatime NTS Bedienungsanleitung

Bodet Time

Bodet Time Sigma H Anleitungen und Rezepte

Bodet

Bodet NETSILON 7 AC Bedienungsanleitung

Tekron

Tekron NTS 02-G Bedienungsanleitung

KYLAND Technology

KYLAND Technology PTS-10A Bedienungsanleitung

Gorgy Timing

Gorgy Timing LEDI NETWORK TDS V1 Bedienungsanleitung

KYLAND Technology

KYLAND Technology PTS-DR200 Bedienungsanleitung

Mobatime

Mobatime DTS 4150.grandmaster Bedienungsanleitung

Brandywine

Brandywine NFS-221 Bedienungsanleitung

GlobalTime Electronic

GlobalTime Electronic GTT-100 Bedienungsanleitung

SERTEL

SERTEL T-GPS-300 Bedienungsanleitung