Mellerware Tidy! Random Bedienungsanleitung

Tidy! Random

Robot vacuum cleaner

Robot aspirador

Robot aspirateur

Robot aspirador

Straubsaugerrobter

Robot aspirapolvere

C D E F

ENENGLISH

Dear customer,

Many thanks for choosing to purchase

a Mellerware brand product.

Thanks to its technology, design and

operation and the fact that it exceeds

the strictest quality standards, a fully

satisfactory use and long product life

can be assured.

Read these instructions

carefully before

switching on the

appliance and keep

them for future

reference. Failure to

follow and observe

these instructions could

lead to an accident.

This appliance can

be used by children

aged from 8 years and

above and persons

with reduced physical,

sensory or mental

capabilities or lack

of experience and

knowledge if they have

been given supervision

or instruction

concerning use of the

appliance in a safe way

and understand the

hazards involved.

Safety advice

and warnings

Cleaning and user

maintenance shall not

be made by children

without supervision

This appliance is not a

toy. Children should be

supervised to ensure

that they do not play

with the appliance.

Disconnect the battery

charger from the mains

when not in use and

before undertaking any

cleaning task.

Only use the appliance

with the specic power

supply unit, provided

with the appliance.

Only connect the

appliance to a very

low safety voltage

that corresponds to

the marking on the

appliance.

If the connection to

the mains has been

damaged, it must

be replaced, take

the appliance to an

authorised technical

support service. Do not

attempt to disassemble

or repair the appliance

by yourself in order to

avoid a hazard.

The battery must be

removed from the

appliance before it is

scrapped.

The appliance must

be disconnected from

the supply mains when

removing the battery.

The battery is to be

disposed of safely.

This appliance is for

household use only, not

professional, industrial

use.

10.

11.

12.

Do not use the appliance if the

cable or plug is damaged.

If any of the appliance casings

breaks, immediately disconnect

the appliance from the mains to

prevent the possibility of an electric

shock.

Do not use the appliance if it has

fallen on the oor, if there are

visible signs of damage or if it has

a leak.

Avoid all contact with the liquid

that could be released from the

battery. In case of contact with

eyes, wash them thoroughly and

seek medical advice. The liquid

spilled from the battery may cause

irritation or burns.

USE AND CARE

Do not use the appliance if its

accessories are not properly tted.

Do not use the appliance to gather

up water or any other liquid.

Do not use the appliance if the on/

o switch does not work.

Respect the MAX level indicator.

Remove the batteries from the

appliance if you are not going to

use it for some time.

Store this appliance out of reach

of children and/or persons with

physical, sensory or reduced

mental or lack of experience and

knowledge.

Do not work on areas where there

are metal objects, such as nails

and/or screws.

Ensure that the voltage indicated

on the charger rating label

matches the mains voltage before

plugging in the charger.

Connect the appliance to a socket

that can supply a minimum of 10

amperes.

The charger’s plug must t

correctly into the mains socket. Do

not alter the plug. Do not use plug

adaptors.

Do not force the power cord. Never

use the power cord to lift up, carry

or unplug the battery charger.

Do not wrap the power cord

around the appliance.

Check the state of the power

cord. Damaged or tangled cables

increase the risk of electric shock.

Do not touch the plug with wet

hands.

–

Never vacuum hot or sharp objects

(cigarette butts, ashes, nails, etc.).

Do not open the battery/ies under

any circumstances whatsoever.

When the battery/ies is not in use,

keep it away from other metal

objects like paper clips, coins, keys,

screws... that could connect a

terminal to another.

Do not short-circuit the battery

terminals as this may cause an

explosion or re.

The battery/ies should be stored at

a temperature of below 40˚C.

Recharge the battery/ies only

with the charger supplied by the

manufacturer. A charger that is

suitable for one type of battery

may cause explosion or re hazard

when used with other battery/ies.

Use the device only with the

battery/ies for which has been

specically designed. The use of

any other battery/ies s can cause

an explosion or re hazard.

Service

Any misuse or failure to follow the

instructions for use renders the

guarantee and the manufacturer’s

liability null and void.

Description

A – Front impact infrared sensor

B – Anti-scratch band

C – On/o button

D – Fixed / blinking error red

indicator light

E – Operation indicator light

F – Charging indicator light

G – Anti-fall sensors

H – Charging contact points

I – Central wheel

J – Side wheels

K – Central rotary brush

L – On/o switch

M – Battery lid

N – Cleaning brush

O – Sides brush

DUST TANK

P – Dust tank

Q – Dust tank cover

R – Dust tank release button

S – Sponge lter

T – EPA lter

U – Textile prelter

WATER TANK

V – Water tank

W – Water tank cover

X – Microber mop

Y – Water tank release button

REMOTE CONTROL

1 – AUTO cleaning mode button

2 – Button to return to the charging

base

3 – Directional buttons (up / down/

left/right)

4 – On/o button

5 – Button to select the hour

6 – Button to select the schedule

7 – SPIRAL cleaning mode button

8 – EDGE cleaning mode button

9 – ROOM cleaning mode button

10 – MAX suction and AUTO mode

button

–

the fall arrest sensors do not work

properly.

Installation

Be sure to remove all packaging

material from inside the appliance.

CHARGING BASE POSITION

Connect the charger to the

charging base.

Place the load base  at and next

to the wall.

To receive a good signal, you must

leave a radius of 1m to the right

and left and 2 meters forward of

the base.

Connect to the power.

CHARGING BASE

11 – Charging base

12 – Charger

13 – Charging contact points

NOTE: Insert 2 AAA batteries before

using the remote control for the  rst

time. Make sure that the positive

and negative poles are located in

the correct direction in the battery

compartment.

If the model of your appliance does

not have the accessories described

above, they can also be bought

separately from the Technical

Assistance Service.

IMPORTANT: Cables or other

objects on the ground can hinder

the mobility of the robot. Remove

these objects before using the

robot vacuum cleaner.

Use the vacuum cleaner the robot

only on short pile carpets.

Furniture less than 8cm can block

the robot. Lift the furniture if you

need to clean this area.

Put a safety barrier on the stairs

to prevent it from falling in case

SIDE BRUSHES INSTALLATION

Mount the side brushes on the

bottom of the robot by pressing the

brushes into its slot.

CHARGING THE BATTERY

Warning: A new battery does not

come with a full charge and must

be fully charged before using the

Charge the battery at an

atmospheric temperature of

between 4 and 40˚C.

Turn on the ON/OFF button located

on the bottom of the robot.

Put the robot in the charging base

and ensure that the automatic

charging poles are aligned

correctly.

The charging indicator light (F) will

blink in red color. When the LED

stops blinking the robot is loaded.

Load the robot for 4 hours before

Instructions for use

START CLEANING

Before starting use, ensure that the

power switch (L) is on.

You can turn on the robot in several

(C), the start/stop button (4) or the

AUTO cleaning mode button (1) on

the remote control.

NOTE: If the battery is about to

run out, the robot will return to the

charging base automatically to

recharge.

NOTE: If the load base is

inaccessible, the robot can not

be recharged, it will return to the

initial situation and the cleaning

system will end. In this case, place

–

the robot manually in the charging

base so that it can be recharged

correctly.

STOP THE ROBOT

To stop the robot, press the on/o

button (C) or the start/stop button

(4) on the remote control.

To resume the cleaning cycle, press

the on/o button (C) or the on/o

button (4) on the remote control

again.

To return the robot to the charging

base (11) press button (2).

TURN OFF THE ROBOT

To turn o the robot, keep the

on/o button (C) pressed for a

few seconds until the operation

indicator goes o .

Cleaning modes

AUTO CLEANING MODE

The robot starts to vacuum

automatically and combines the

di erent cleaning modes in one

optimizing the cleaning of your

home to the maximum.

To use the AUTO cleaning mode,

press (1) button from the remote

control.

When the cleaning cycle ends or

if the battery runs out, it returns to

the charging base automatically.

SPIRAL CLEANING MODE

The robot starts vacuum at a

particular point by spiraling

outward approximately (1 meter) in

diameter and then spiraling inward

to where it started.

To use the SPIRAL cleaning mode,

press the (7) button from the

remote control.

MAX CLEANING MODE

The robot increases its suction

power to provide a deeper

cleaning.

To use the MAX cleaning mode,

press the (10) button from the

remote control.

–

that it only has 15% of the battery

left.

To activate this option, press the (2)

button from the remote control.

WATER TANK MODE

At the end of the vacuuming

process, you can change the

dust tank for the water tank (V) to

continue cleaning. The water tank

works by dripping so the mop will

gradually moisten and scrub the

 o o r .

Open the hermetic lid of the tank

(W) and introduce water into the

tank.

Add the mop on and make sure it is

secure.

EDGE CLEANING MODE

Once the robot  nishes cleaning

the open areas of your  oor, use

the perimeter mode to make sure

it has been cleaned along the

walls and around the legs of the

furniture.

To use the EDGE cleaning mode,

press the (8) button from the

remote control.

ROOM CLEANING MODE

When it is necessary to clean a

speci c room, press the ROOM

cleaning mode button from the

remote control (9).

When the cleaning is  nished, the

robot will stop.

Make sure to close the doors of the

room while using this mode.

BACK TO THE CHARGING BASE

The robot automatically returns to

the charging base when it detects

–

Inhaltsverzeichnis

Sprachen:

Andere Mellerware Staubsauger Handbücher

Mellerware

Mellerware VAC14001400W Bedienungsanleitung

Mellerware

Mellerware Broomy Bedienungsanleitung

Mellerware

Mellerware Whooshy! Wireless Bedienungsanleitung

Mellerware

Mellerware Rider Pro Bedienungsanleitung

Mellerware

Mellerware INNOVAC 31120RD Bedienungsanleitung

Mellerware

Mellerware VORTEX Bedienungsanleitung

Mellerware

Mellerware Handy! Bedienungsanleitung

Mellerware

Mellerware EXECUTIVE VAC18001800W Bedienungsanleitung

Mellerware

Mellerware VAC20002000W Bedienungsanleitung

Mellerware

Mellerware Rider Lithium Bedienungsanleitung

Mellerware

Mellerware Whooshy! Wireless Bedienungsanleitung

Beliebte Staubsauger Handbücher anderer Marken

Bissell

Bissell LittleGreen Proheat 1425 Series Bedienungsanleitung

Panasonic

Panasonic MC-YL637S147-AE Bedienungsanleitung

NEFF

NEFF N17XH10 0 Series Bedienungsanleitung

LG A9 Series Bedienungsanleitung

Oreck

Oreck Cordless Captura BK51700 Series Bedienungsanleitung

Kogan

Kogan KAVACROBVWA Bedienungsanleitung

Kränzle

Kränzle VENTOS 50 ID Benutzerhandbuch

EVVO

EVVO Ai35 Bedienungsanleitung

DeWalt

DeWalt DWH200D Bedienungsanleitung

Pontec

Pontec Pondomatic Vacuum Cleaner Bedienungsanleitung

Cleanmaxx

Cleanmaxx PC-P007E Bedienungsanleitung

Exido

Exido 240-114 Bedienungsanleitung

RIDGID

RIDGID WD1685AU0 Bedienungsanleitung

Ezviz

Ezviz RE4P Bedienungsanleitung

STG global

STG global TANVAC HDV3000 Bedienungsanleitung

Shark

Shark ROTATOR PRO COMPLETE NV550 Series Bedienungsanleitung

Factory

Factory M3340 Bedienungsanleitung

Shop-Vac

Shop-Vac VN92 SERIES Bedienungsanleitung