Mercia Garden Products 02SNO0705-V1 Bedienungsanleitung

02SNO0705-V1

Dimensions

Length = 1475mm

Width = 2114mm

Height = 2037mm

Fixing Kit

For Assistance Please

Contact Customer Care on

01636 880514

2mm Drill bit

Winter = High Moisture = Expansion

Summer = Low Moisture = Contraction

This building should be erected by

two Adults.

For ease of assembly, it is advisable to

pilot drill all screw holes and ensure

all screw heads are countersunk.

BEFORE YOU START PLEASE READ INSTRUCTIONS CAREFULLY

- Check the pack and make sure you have all the parts listed.

- When you are ready to start, make sure you have the right tools at hand

(not supplied) including a Phillips screwdriver, Stanley knife, wood saw,

step ladder and drill with 2mm bit.

- Ensure there is plenty of space and a clean dry area for assembly.

- Make sure you have a suitable base ready to erect your building

TIMBER

As with all natural materials, timber can be aected during various weather

conditions. For the duration of heavy or extended periods of rain, swelling of the

wood panels may occur. Warping of the wood may also occur during excessive

dry spells due to an interior moisture loss. Unfortunately, these processes cannot

be avoided but can be helped. It is suggested that the outdoor building is

sprayed with water during extended periods of warm sunshine and sheltered as

much as possible during rain or snow.

Our buildings are delivered pre-treated with a water based timber treatment

however this only helps to protect during transit of your garden item. To

validate your guarantee and for better protection against weathering it is

highly recommended that you treat the garden building with a wood preserver

within 3 months of assembly. This will need to be re-applied annually to ensure

longevity of your building. Care must be taken when constructing the garden

building that it is not touching the ground and is on a suitable base.

BUILDING A BASE

When thinking about where the building and base is going to be constructed: Ensure that there will be access to all sides for maintenance work and

annual treatment.

TYPES OF BASE

- Concrete 75mm laid on top of 75mm hard-core.

- Slabs laid on 50mm of sharp sand.

Ensure the base is level and is built on rm ground, to prevent distortion. Refer to diagrams for the base dimensions, The base should be slightly

smaller than the external measurement of the building, i.e. the cladding should overlap the base, creating a run o for water. It is also recommended

that the oor be at least 25mm above the surrounding ground level to avoid ooding.

MADE IN GREAT BRITAIN

Whilst all products manufactured are made to the highest standards of Safety and in the case of childrens products independently tested to EN71 level. We

cannot accept responsibility for your safety whilst erecting or using this product. Children of any age should not be left to play unsupervised.

Mercia Garden Products Limited, Sutton On Trent, Newark,Nottinghamshire, NG23 6QN

WARNING: Only for domestic use

Not suitable for children under 36 month

To be used under direct supervision of an adult

Door Gable Plain Gable

Plain Side

Floor

1st floor

Rail Guard

Large Roof Sheet

1795 x 1400mm

Small Roof Sheet

1795x990mm

456

Window Side

Door

Support Block - 495mm x3

17 18

Roof Eave - 1795mm x2

Roof Support Bar - 1448mm x1

Fascia - 1427mm x2

Ladder Sides - 1418mm x2

1st Floor Support Bar - 1270mm x 1

Fascia - 1041mm x2

Ladder Step - 390mm x4

Fascia Block

140mm x1

Finial x2

21 22

Door Stop x1

Window Frame x3

Butterfly x1

Window Shutters x4

Window Box x2 25

Contents

Retain Instructions for future reference

Assembly

Nail Bag & Ironmongery

50mm Screw x 48

40mm Screw x 21

Felt Tacks x 80

20mm Screw x 16

30mm Screw x 69

60mm Screw x 21

10mm Screw x 5

Wooden door

handle

Corner

Bracing x2

Felt

Antique Hinge x3

30mm Black Screw x 21

Step 1

Remove transportation blocks

from the bottom of each panel

before beginning assembly. Each

Panel should have two blocks.

Lay the door gable face up on a at surface, place the

door within the door aperture. Position the door so that

you have a 12mm gap from the door to the door gable on

all four sides.

Useful tip: Use a12mm thick piece of timber from your

xing kit within the gaps to ensure the door does not

move.

Once you are happy the door is in the correct position

place a hinge at the top, middle and bottom of the door,

ensuring the screws will go into the framing and using

30mm black screws x the hinge to the door and the door

gable. Ensure to pre-drill the holes rst.

12mm

21x 30mm black screws

Step 2

Place the floor on a firm and

level base, ensure base has

suitable drainage free from

areas where standing water can

collect. (See front page on base

requirements).

Step 3

Fix the ladder together using

50mm screws, pre drill all screw

holes to avoid the timber spliting.

50mm

screw

16x 50mm screws

1055mm

Step 4

Fix the 1st oor support bar to the

front gable with 4 x 60mm screws

at a height of 1055mm from the

bottom piece of framing to the

top of the bar as shown in the

diagram.

60mm

screw

4x 60mm screws

Step 5

Do not secure the building to

the floor until the roof is fitted.

Fix the panels onto the floor

using 50mm screws in align-

ment with the floor joists

Fix the corners with 50mm

screws as shown in diagram.

Position the panels so there is equal spacing

between the floor and cladding on all 4 sides

12 x 50mm Screws

50mm

screw

Step 6

Fix Door Gable and Window

Panel using the same method

shown in step 5.

18 x 50mm Screws

50mm

screw

Step 7

1st floor

60mm

screws

Fix the 1st oor onto the 1st oor

support bars with 60mm screws,

pre drill before hand. Screw

through the support bars through

to the 1st oor framing.

60mm

screw

8 x 60mm screws

60mm

screws

60mm

screws

1st floor

Steps

Building floor

27/10/04

Fix the Rail Guard to the 1st oor using 3 x 60mm screws, pre drill

before hand. Fix the Ladder with 60mm screws. Screw through the

ladder into the oor, rail guard and plain gable. 7 x 60mm screws

Step 8

Line the support block up with the gable

framing, use 40mm screws to x.

Place the roof support bar on top of

the support block and using corner

braces x with 30mm screws.

8 x 30mm screws

8 x 40mm screws

30mm

screw

Step 9

Fix a roof eave to each roof sheet using

30mm screws.

Position the roof sheets on the building

and x to the roof support bar the rail

guard and the sides of the building using

30mm screws.

32 x 30mm screws

Step 10

Fix the support block between the

apex of the roof ush with the edge

of the roof sheets using 30mm

screws.

Fix the fascia block in the middle of

the the large roof sheet ush with

the edge using 30mm screws.

4 x 30mm screws

Step 11

Felt

tacks

80 x felt tacks

Cut felt into 3 sheets and lay onto roof

as shown in diagram ensuring there is

a 50mm overhang around the sides.

Fix using felt tacks at 100mm intervals

Window Shutters x4

Step 12

Fix fascias and nials using 40mm

screws. Pre drill holes to avoid

splitting. Ensure to the trap the felt

between the fascia and building.

14 x 40mm screws

40mm

screw

Step 13

WINDOW

WINDOW BOX

Fix the window box underneath the

window screwing through the door gable

into the window box using 4 x 30mm

screws.

Fix the window shutters through the

door gable into the shutter using 4 x

30mm screws per shutter.

30mm

screw

30mm

screw 24 x 30mm Screws

Step 14 Place a window frame cross against the inside of each window.

Position the frame centrally to the window and x using 4x20mm

screws per frame.

Place the wooden door handle on the outside of the door and use a

60mm screw from the inside to secure. Pre drill hole rst to avoid

splitting.

On the inside of the door opening x the ply triangle door stop to

the bottom left corner using 3x20mm screws.

Fix the buttery onto to the door using 4 x 10mm screws. Pre drill to

avoid splitting.

15 x 20mm screws

4 x 10mm screws

1 x 60mm screw

60mm

screw

20mm

screw

20mm

screw

10mm

screw

It is ESSENTIAL that you apply wood

treatment immediately after the building

has been assembled.

Andere Mercia Garden Products Gartenhaus Handbücher

Mercia Garden Products

Mercia Garden Products 01OSBP1006SDFW-V1 Bedienungsanleitung

Mercia Garden Products

Mercia Garden Products 01DTOVRA0604SDFW-V1 Bedienungsanleitung

Mercia Garden Products

Mercia Garden Products 01GRO0806DD-V2 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 03WES1008-V3 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 03TGCOR0707-V5 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products Wessex 03WES1208-V3 Bedienungsanleitung

Mercia Garden Products

Mercia Garden Products 0644LOG213-V4 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 01COR0707-V1 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 0634CSNE0303HGDD2SW-V1 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 0628LOG131-V4 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 01OVLPA0808DDFW-V1 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 01JER0806-V1 Bedienungsanleitung

Mercia Garden Products

Mercia Garden Products 03WES0808-V1 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 06LOG016-V1 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 03DTSHAX0608FGD4MW-V2 Bedienungsanleitung

Mercia Garden Products

Mercia Garden Products 01DTPOT0806-V1 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 0644RANE4535FGDD2TW1SW-V1 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 01OVLPA0304SDNW-V1 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 01BEACH-V1 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 03WES1008-V1 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 01OVLPA0304SDNW-V1 Bedienungsanleitung

Mercia Garden Products

Mercia Garden Products 0619PNNE0403HGDD3SW-V1 Bedienungsanleitung

Mercia Garden Products

Mercia Garden Products 03DTSHPN0408DSHPB-V1 Bedienungsanleitung

Mercia Garden Products

Mercia Garden Products 02DTTWRS0605-V1-PEFC Gebrauchsanweisung

Beliebte Gartenhaus Handbücher anderer Marken

Lemeks

Lemeks Palmako PA120-5930-6 Installationshandbuch

Rion

Rion Hobby Gardener Bedienungsanleitung

Gartenhaus-King

Gartenhaus-King Valery Bedienungsanleitung

Select

Select ISAAC E9682 Bedienungsanleitung

Palmako

Palmako Saale Bedienungsanleitung

Lemeks

Lemeks Palmako Kira EL16-3623 Installationshandbuch

Palmako

Palmako Roger FR44-5953-2 Bedienungsanleitung

Pergola kits USA

Pergola kits USA PREMIUM VINYL PAVILION Bedienungsanleitung

G21

G21 Boston 882 Bedienungsanleitung

Lemeks

Lemeks Palmako Grace PM56-4529 Installationshandbuch

Shire

Shire Salcey Bedienungsanleitung

Rutland County

Rutland County Burley 6ft Bedienungsanleitung

Palmako

Palmako Roger 27,7 Bedienungsanleitung

Lemeks

Lemeks Palmako PA120-5930-9 Installationshandbuch

Lemeks

Lemeks Palmako PM70-6436 Installationshandbuch

Lemeks

Lemeks Palmako PM56-4435 Installationshandbuch

Lemeks

Lemeks 106214 Installationshandbuch

POD

POD Camping 480 Bedienungsanleitung