Mercia Garden Products 01GRO0806DD-V2 Gebrauchsanweisung

P 1

01GRO0806DD-V2

8X6 GROUNDSMAN

2mm Drill bit

x2 Winter = High Moisture = Expansion

Summer = Low Moisture = Contraction

All building’s should be

erected by two adults

For ease of assembly, you

MUST pilot drill all screw

holes and ensure all screw

heads are countersunk.

For assistance please contact customer care on: 01636 880514

Mercia Garden Products Limited,

Sutton On Trent,

Newark,

Nottinghamshire,

NG23 6QN

www.merciagardenproducts.co.uk

CAUTION

Every eort has been made during the

manufacturing process to eliminate the

prospect of splinters on rough surfaces of the

timber. You are strongly advised to wear gloves

when working with or handling rough sawn

timber.

**Protim Aquatan T5 (621)**

Your building has been treated with Aquatan.

Aquatan is a water-based concentrate which is diluted with water, the building as been treated by the correct

application of Aquatan solution and then allowed to dry.

Aquatan is a decorative nish to colour the wood, which is applied industrially to timber fence panels and

garden buildings.

Aquatan undiluted contains: boric acid, sodium hydroxide 32% solution, aqueos mixture of sodium dioctyl

sulphosuccinat and alcohols: 2, 4, 6-trichlorophenol.

Please retain product label and instructions for future reference

General Instructions

BEFORE YOU START PLEASE READ INSTRUCTIONS CAREFULLY

- Check the pack and make sure you have all the parts listed.

- When you are ready to start, make sure you have the right tools at hand (not supplied)

including a Phillips screwdriver, Stanley knife, wood saw, step ladder and drill with 2mm

bit.

- Ensure there is plenty of space and a clean dry area for assembly.

TIMBER

As with all natural materials, timber can be aected during various weather conditions.

For the duration of heavy or extended periods of rain, swelling of the wood panels may

occur. Warping of the wood may also occur during excessive dry spells due to an interior

moisture loss. Unfortunately, these processes cannot be avoided but can be helped. It is

suggested that the outdoor building is sprayed with water during extended periods of

warm sunshine and sheltered as much as possible during rain or snow.

Our buildings are pre treated with a water based treatment**; this only helps to protect

the product during transit and for upto 3 months against mould. To validate your

guarantee and ensure longevity of the product, it is ESSENTIAL the building is treated

with a wood preserver within the rst three months of assembly and thereafter in

accordance with the manufactures recommendations. Care must be taken to ensure

the product is placed on a suitable base.

BUILDING A BASE

When thinking about where the building and base is going to be constructed:

Ensure that there will be access to all sides for maintenance work and annual

treatment.

Ensure the base is level and is built on rm ground, to prevent distortion. Refer to

diagrams for the base dimensions, The base should be slightly smaller than the external

measurement of the building, i.e. The cladding should overlap the base, creating a run

o for water. It is also recommended that the oor be at least 25mm above the

surrounding ground level to avoid ooding.

TYPES OF BASE

- Concrete 75mm laid on top of 75mm hard-core.

- Slabs laid on 50mm of sharp sand.

Whilst all products manufactured are made to the highest standards of Safety and in

the case of childrens products independently tested to EN71 level, we cannot accept

responsibility for your safety whilst erecting or using this product.

Refer to the instructions pages for you specic product code

P 2

01GRO0806DD-V2

Overall Dimensions:

Length = 2513mm

Width = 1969mm

Height = 2111mm

Base Dimensions:

Length = 2387mm

Width = 1783mm

Please retain product label and instructions for future reference

Before assembly

please make sure you have a

suitable base ready to erect your

building

MADE IN GREAT BRITAIN

Fixing Kit

Content

Door Gable Plain Gable Plain Side

Window Side Floor Roof

Qty 2

Window

16 17 18 19

Fascia - 12x95x1120mm Qty 4

Door Frame Upright - 12x45x1732mm Qty 2

Door Frame Top - 12x45x1185mm

Window Strip - 12x45x1100mm

Tower Bolt Mounting Block - 12x45x120mm

Cover Trim - 12x30x1652mm Qty 4

Finial

Qty 2

Felt Tower Bolt

and Catch

Casement Stay

T-hinge Qty 6

Butt hinge

Qty 2

Door

15 Door Cloaking strip

Nail Bag

50mm Screw x 12

40mm Screw x 12

Felt Tacks x 110

20mm Screw x 6

30mm Screw x 109

16mm Screw x 6

Hasp & Staple

P 3

Please retain product label and instructions for future reference

Step 1

Fit the door frame onto the

door gable using 4x30mm

screws for each strip. The

door frames should sit

15mm from the door

aperture.

12x30mm Screws

15mm

30mm

screw

Pre drill

hole

42x30mm screws

Step 2

Fix the T-hinges onto the

doors and door frame as

shown. using 30mm

screws. Ensure that each

hinge is xed to the doors

going through to the

framing.

Pre drill

hole

30mm

screw

Remove transportation blocks

from the bottom of each panel

before beginning assembly.

Each panel should have two

blocks.

Step 3

Place the oor on a rm and

level base, ensure base has

suitable drainage free from

areas where standing water

can collect. (See front page for

base requirements).

Step 4

P 4

For assistance please contact customer care on: 01636 880514

Mercia Garden Products Limited,

Sutton On Trent,

Newark,

Nottinghamshire,

NG23 6QN

www.merciagardenproducts.co.uk

Please retain product label and instructions for future reference

Fix the corner with 3x

50mm screws as shown in

diagram.

Step 5

50mm

screw

Pre drill

hole

The window panel can be tted

on either the left or right hand

side of the building.

3x50mm screws

Fix the corners with 3x

50mm screws as shown in

diagram.

Step 6

50mm

screw

Pre drill

hole

For buildings with no windows

x a plain panel here.

9x50mm screws

Step 7

Fix the roof panels on either

side of the gables as shown

in the diagram. Ensure the

roof framing ts into the

slots at the top of both

gables.

Fix the panels into position

using 30mm screws frpm

the top of the panel,

straight into the rafter.

Pre-drill holes to prevent

spliting.

Ensure the larger overhang

on both panels are facing

each other at the top point.

24x30mm screws

30mm

screw

Pre drill

hole

P 5

Please retain product label and instructions for future reference

Cut the felt into three

sheets measuring 2613mm.

Lay them onto the building

as shown in the diagram

and x using felt tacks at

100mm intervals.

Step 8

110 x Felt tacks

Felt

tacks

HANDLE

WITH CARE

Fit the cover trims to the front

and back of the building as

shown in the illustration

using 30mm screws.

Trim the length of the cover

trims to the required size

before tting if necessary.

Pre drill to avoid splitting.

Step 9

30mm

screw

12x30mm Screws

Attach the fascias to the roof

leaving a slight overhang at

the top. Fit the fascias to the

roof over the felt and secure in

place with 40mm screws as

shown.

Pre drill to avoid splitting.

Step 10

12x40mm Screws

Pre drill

hole

40mm

screw

P 6

Please retain product label and instructions for future reference

To x the lock in place. Screw the Staple

to the Door Gable or Slave door.

Making sure the Hasp is in line with

the staple and screw into the Door or

Master door.

To lock the Door, place the Hasp over the

Staple and twist into the lock position as

shown.

8x30mm screws.

30mm

screw

Pre drill

hole

30mm

16mm

Opening Window

Fixed Window

30mm

screw

30mm

screw

16mm

screw

30mm

screw

Place the opening window strip

11mm above the window gap in the

window panel and x with 3x30mm

screws.

If you would like the windows to be

opening use the butt hinges to

attach the opening window strip

and the opening window together.

Use 30mm screws to x the butt

hinge to the Window Strip and

16mm screws to x it to the

Opening Window.

If you want to x the opening

windows, instead of xing butt

hinges to the opening window,

use 4x30mm screws to attach

the opening windows to the

window panel as shown in the

diagram.

3x30mm Screws

6x30mm Screws

6x16mm Screws

4x30mm Screws

Step 11 Step 12

P 7

Please retain product label and instructions for future reference

Step 13

Attach the tower bolt

mounting block to the top

of the slave door with

2x30mm screws. Align the

tower bolt onto the block

and x using 6x30mm

screws

8x30mm screws

30mm

screw

Pre drill

hole

Step 14

Fix the casement stay to the

opening window then align

the xings onto the window

panel frame. Ensure the

casement stay ts into

xings when closed before

screwing them down using

20mm screws. 20

6x20mm screws

20mm

screw

It is ESSENTIAL that you apply wood

treatment immediately after the building

has been assembled.

AFTER TREATMENT:

score around protective

cover on glazing and

carefuly peel

covering back

Inhaltsverzeichnis

Andere Mercia Garden Products Gartenhaus Handbücher

Mercia Garden Products

Mercia Garden Products 01DTOVRA0806SDFW-V1 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 01PTJER0806-V1 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 10DTBARK0804-V1 Bedienungsanleitung

Mercia Garden Products

Mercia Garden Products 01DTPRMSHDB1008DDOP-V1 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 03DTSHAX0705HGD2MW-V1 Bedienungsanleitung

Mercia Garden Products

Mercia Garden Products 03DTSHPN0407DSHSA-V1 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 0619LOG015-V4 Bedienungsanleitung

Mercia Garden Products

Mercia Garden Products 01DTSHRAX0705SDFW-V1 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 01OVLPA0304SDNW-V1 Bedienungsanleitung

Mercia Garden Products

Mercia Garden Products OIDTOVRA1006SDFW-V1 Bedienungsanleitung

Mercia Garden Products

Mercia Garden Products 02DTSHOPN0305-V1-PEFC Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 01PTSHPWOR1010DDOW-V4 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 01SHPWOR1010DDOW-V2 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 01PTOSBA1008DDFW-V1 Bedienungsanleitung

Mercia Garden Products

Mercia Garden Products 01DTPRMSHPN1408DDOP-V1 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 01DTSHAX0406SDFW-V1 Bedienungsanleitung

Mercia Garden Products

Mercia Garden Products 02DTTWR0605-V1-PEFC Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 01DTSHPN0604SDFW-V1 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 02SNO0705-V1 Bedienungsanleitung

Mercia Garden Products

Mercia Garden Products 01DTOVRA1006SDFW-V1 Bedienungsanleitung

Mercia Garden Products

Mercia Garden Products 03DTSHCR0909GD4TW-V2 Bedienungsanleitung

Mercia Garden Products

Mercia Garden Products 01DTOVRA0806SDFW-V2 Bedienungsanleitung

Mercia Garden Products

Mercia Garden Products 03TGCOR0707-V5 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 01GRO0705-V2 Gebrauchsanweisung

Beliebte Gartenhaus Handbücher anderer Marken

Lemeks

Lemeks Palmako PA120-5930-6 Installationshandbuch

Rion

Rion Hobby Gardener Bedienungsanleitung

Gartenhaus-King

Gartenhaus-King Valery Bedienungsanleitung

Select

Select ISAAC E9682 Bedienungsanleitung

Palmako

Palmako Saale Bedienungsanleitung

Lemeks

Lemeks Palmako Kira EL16-3623 Installationshandbuch

Palmako

Palmako Roger FR44-5953-2 Bedienungsanleitung

Pergola kits USA

Pergola kits USA PREMIUM VINYL PAVILION Bedienungsanleitung

G21

G21 Boston 882 Bedienungsanleitung

Lemeks

Lemeks Palmako Grace PM56-4529 Installationshandbuch

Shire

Shire Salcey Bedienungsanleitung

Rutland County

Rutland County Burley 6ft Bedienungsanleitung

Palmako

Palmako Roger 27,7 Bedienungsanleitung

Lemeks

Lemeks Palmako PA120-5930-9 Installationshandbuch

Lemeks

Lemeks Palmako PM70-6436 Installationshandbuch

Lemeks

Lemeks Palmako PM56-4435 Installationshandbuch

Lemeks

Lemeks 106214 Installationshandbuch

POD

POD Camping 480 Bedienungsanleitung