MFJ MFJ-902 Bedienungsanleitung
MFJ-902/902H Travel Tuner Instruction Manual
1
INTRODUCTION
The MFJ-902/902H Travel Antenna Tuner was specially compact-built for Icom
IC-706MKIIG, Yaesu FT-100, Kenwood TS-50, and other rigs with a built-in
SWR Meter.
You can operate 80 through 10 Meters -- anywhere with any transceiver -- use
any coax fed or random wire antenna. The 902H also has a 4:1 balun with
binding post for balanced lines. It’s great for mobile, base, backpack, etc. The
MFJ-902/902H handles 150 watts RF output and has a tuner bypass switch.
INSTALLATION
The MFJ-902/902H should be installed between the transmitter and antenna.
1. Locate the tuner in a convenient location at the operating position.
2. Use a 50 ohm coaxial cable to connect the transmitter or transceiver to the
SO-239 labeled TRANSMITTER on the back of the tuner.
3. Connect an antenna feed to the appropriate tuner output:
a.) COAX-FEED to the SO-239 connector labeled ANTENNA.
b.) RANDOM WIRE
MFJ-902: A random wire may be used by connecting to the center of
the SO-239 connector with the supplied plug.
MFJ-902H: Connect to the red binding post labeled WIRE.
The MFJ-902/902H must be grounded when using a random wire.
c.) BALANCED FEEDERS (MFJ-902H only) to the red binding posts
labeled BALANCED LINE. When using a balanced feedline, connect a
short jumper from the WIRE binding post to the closest balanced line
post (see labeling on back of unit).
4. Connect your tuner and transmitter to a good earth ground.
OPERATION
This tuner has a BYPASS/TUNE switch located on the back of the unit. Simply
place the switch toward the BYPASS labeling to completely bypass the tuning
circuit. Change the switch toward the TUNE labeling to place the tuning circuit
between the transmitter/transceiver and the antenna.
MFJ-902/902H Travel Tuner Instruction Manual
2
In this tuner the TRANSMITTER and ANTENNA matching controls have
maximum capacitance at position 0 (fully meshed), and minimum capacitance at
position 10 (fully open). Be sure to use the highest possible capacitance for
each band. This will provide the smoothest tuning, highest efficiency, and
greatest power handling capability.
The INDUCTANCE switch has maximum inductance in position "A", and
minimum inductance in position "L". Less inductance is needed as the
frequency is increased. If too little inductance is used, the tuner may not match
the load properly. If too much inductance is used, the tuner will be "touchy",
power handling will be compromised (capacitors could arc, etc.) and the
bandwidth will not be as wide.
Special Note: Always use the minimum amount of inductance as possible.
Minimum inductance gives the best efficiency, maximum power
handling, and widest bandwidth.
The MFJ-902/902H covers 80 through 10 meters. Do not operate on 160
meters.
Tuning Procedure:
1. Position the TRANSMITTER control to 5 on the corresponding scale.
2. Position the ANTENNA control to 0 on the corresponding scale.
3. Place the BYPASS/TUNE switch in the TUNE position.
4. Apply just enough power to obtain noticeable deflection on the reflected
power meter or SWR meter.
5. Adjust the INDUCTOR control for lowest deflection on the reflected power.
6. Carefully adjust the TRANSMITTER control for the lowest reflected power,
then increase the ANTENNA control slightly and adjust the
TRANSMITTER control for the lowest reflected power. Again, increase the
ANTENNA control slightly and adjust the TRANSMITTER control for
lowest reflected power. Repeat this process for lowest reflected power.
Note: These controls interact. Go back and forth between these adjustments
as many times as required until the lowest reflected power (best SWR)
is obtained.
7. After the lowest reflected power (or SWR) is obtained in step 6, use the
INDUCTOR switch to reduce the inductance one switch position (L is the
lowest inductance setting). Adjust the TRANSMITTER and ANTENNA
controls for the lowest SWR. Continue this process until the lowest SWR
cannot be repeated, then use the INDUCTOR switch to increase the
MFJ-902/902H Travel Tuner Instruction Manual
3
inductance by one switch position (A is the highest inductance setting).
Tune for lowest SWR.
WARNING: Never transmit while changing the INDUCTOR switch.
Note: Always use as little inductance as possible. Step 7 minimizes the
inductance and maximizes the capacitance.
8. After a low SWR is obtained, the transmitter power may be increased to any
value up to 150 watts.
WARNING: Do not exceed 150 watts output. You will damage the tuner!
TECHNICAL ASSISTANCE
If you have any problem with this unit first check the appropriate section of this
manual. If the manual does not reference your problem or your problem is not
solved by reading the manual you may call MFJ Technical Service at 662-323-
0549 or the MFJ Factory at 662-323-5869. You will be best helped if you have
your unit, manual and all information on your station handy so you can answer
any questions the technicians may ask.
You can also send questions by mail to MFJ Enterprises, Inc., 300 Industrial
Park Road, Starkville, MS 39759; by Facsimile to 662-323-6551; or by email to
explanation of exactly how you are using your unit, and a complete description
of your station.
NOTES
MFJ-902/902H Travel Tuner Instruction Manual
4
SCHEMATIC
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Andere MFJ Tuner Handbücher
MFJ
MFJ MFJ-989C Bedienungsanleitung
MFJ
MFJ MFJ-991B Bedienungsanleitung
MFJ
MFJ MFJ-906 Bedienungsanleitung
MFJ
MFJ MFJ-993BRT Bedienungsanleitung
MFJ
MFJ MFJ-993 Bedienungsanleitung
MFJ
MFJ MatchMaker 212 Bedienungsanleitung
MFJ
MFJ MFJ-9234 Bedienungsanleitung
MFJ
MFJ VersaTuner III -962D Bedienungsanleitung
MFJ
MFJ MFJ-959B Bedienungsanleitung
MFJ
MFJ MFJ-926 Bedienungsanleitung
MFJ
MFJ MFJ-9201 Bedienungsanleitung
MFJ
MFJ IntelliTuner MFJ-993 Bedienungsanleitung
MFJ
MFJ AutoTuner Extender MFJ-914 Bedienungsanleitung
MFJ
MFJ VERSA TUNER III Bedienungsanleitung
MFJ
MFJ MFJ-936C Bedienungsanleitung
MFJ
MFJ Versa Tuner II 941D Bedienungsanleitung
MFJ
MFJ MFJ-1642 Bedienungsanleitung
MFJ
MFJ MFJ-945E Bedienungsanleitung
MFJ
MFJ MFJ-940B Bedienungsanleitung
MFJ
MFJ VersaTuner III Bedienungsanleitung
Beliebte Tuner Handbücher anderer Marken
NAD
NAD C 445 Bedienungsanleitung
Sony
Sony ST-SA5ES Bedienungsanleitung
Sirius Satellite Radio
Sirius Satellite Radio SC-FM1 Bedienungsanleitung
Antique Automobile Radio
Antique Automobile Radio 283501B Bedienungsanleitung
Monacor
Monacor PA-1200R Bedienungsanleitung
Technics
Technics ST-X301L Bedienungsanleitung
