-READ AND FOLLOW ALL INSTRUCTIONS
-Never allow children to operate or play with door controls. Keep the remote control (where provided) away from children.
-Personnel should keep away from a door in motion and keep the moving door in sight until it is completely closed or opened.
NO ONE SHOULD CROSS THE PATH OF A MOVING DOOR.
-Test the door’s safety features at least once a month. After adjusting the limit of travel, retest the door operator’s safety
features. Failure to adjust the operator properly may cause severe injury or death.
-For products having a manual release, if possible, use the manual release only when the door is closed. Use caution when
using this release when the door is open. Weak or broken springs may cause the door to fall rapidly, causing severe injury or
death.
-KEEP DOORS PROPERLY OPERATING AND BALANCED. See Door Manufacturer’s Owner’s Manual. An improperly operating or
balanced door could cause severe injury or death. Have trained door systems technician make repairs to cables, spring
assemblies, and other hardware.
-Press the “OPEN” device or use emergency disconnect mechanism if a person is trapped under the door.
-SAVE THESE INSTRUCTIONS. The owner or users must understand the safety and operation of door system. Insure that this
installation manual be located close to the door system.
READ AND FOLLOW ALL INSTALLATION INSTRUCTIONS
-Commercial door operators are never to be installed on a residential installation
-Install only on a properly operating and balanced door. A door that is operating improperly could cause severe injury. Have
qualified service personnel make repairs to cables, spring assemblies, and other hardware before installing the operator.
-Remove all pull ropes and remove, or make inoperative, all locks (unless mechanically and/or electrically interlocked to the
power unit) that are connected to the door before installing the operator.
-Install the door operator at least 8 feet or more above the floor if the operator has exposed moving parts.
-Do not connect the operator to the source of power until instructed to do so.
-Locate the control station: (a) within sight of the door, (b) at a minimum height of 5 feet so that small children cannot reach it,
and (c) away from all moving parts of the door.
-Install the Entrapment Warning Placard next to the control station in a prominent location.
-For products having a manual release, instruct the end user on the operation of the manual release.
-Install non-contact entrapment protection devices (photocells) and/or contact entrapment protection devices
(reversing edges). Note: photocells should be installed at no more than 6” from the floor. Edges should be installed on
the leading edge of the door.
