Midea MVC-V18K-BG Bedienungsanleitung
VacuumCleaner
INSTRUCTION MANUAL
MVC-V18K-BG
MVC-V18K-BA
PLEASE READ THE
MANUAL CAREFULLY
BEFORE USING AND
KEEP IT PROPERLY FOR
FUTURE USE
STRUCTURE OF THE
PRODUCTV
01
Handle
Dust cup release button
Power button
Cord rewind button
Filter
1
2
3
4
5
6Dust cup
Accessories
This vacuum cleaner includes the following accessories:
Telescoping metal wand
Hose
Floor brush
1
2
3
Crevice tool
4
02
SAFETY DIRECTION
Do Not Oil the motor or the brushroll at any time. The bearings are permanently
lubricated and sealed.
electric shock, or injury:
•Do not use outdoors or on wet
surfaces.
•Do not leave vacuum cleaner when
plugged in. Turn off the switch and unplug
the electrical cord when not in use and before
servicing.
•Do not allow to be used as a toy. Close
attention is necessary when used by or near
children.
•Use only as described in this manual.
Use only manufacturer’s recommended
attachments.
•Do not use with damaged cord or plug. If
cleaner is not working as it should, has been
dropped, damaged, left outdoors, or dropped
into water, call the customer service
HELPLINE at 03-92211033.
•Do not pull or carry by the cord, use cord as
a handle, close door on cord, or pull cord
around sharp edges or corners. Do not run
vacuum cleaner over cord. Keep cord away
from heated surfaces.
•Do not use extension cords or outlets with
inadequate current carrying capacity.
•Turn off all controls before unplugging.
•Do not unplug by pulling on cord. To unplug,
grasp the plug, not the cord.
•Do not handle the vacuum cleaner with wet
hands or operate without shoes.
•Do not put any objects into openings. Do not
use with any opening blocked; keep free of
dust, lint, hair and anything that may reduce
•This vacuum cleaner creates suction. Keep
body away from openings and moving parts.
•Do not pick up anything that is burning or
smoking, such as cigarettes, matches, or hot
ashes.
•
•Use extra care when cleaning on stairs.
•
combustible liquids such as gasoline, or use
on areas where they may be present.
•Store you cleaner indoors in a cool, dry area.
•Keep your work area well lit.
•Unplug electrical appliances before
vacuuming them.
•Belt pulleys can become hot during normal
use. To prevent burns, avoid touching the
belt pulley when servicing the drive belt.
•Turn off the power switch and unplug cleaner
before rotating the nozzle.
SAVE THESE INSTRUCTIONS
To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider then the other).
change the plug in any way.
Thermal Cut Off
This vacuum cleaner has a special thermostat that protects the cleaner in case of motor overheating. If the cleaner
suddenly shuts off, push the on/off switch off (0) and unplug the cleaner. Check the cleaner for a possible source of
at least 30 minutes before attempting to use the cleaner. After the 30 minute period, plug the cleaner back in and
push the on/off switch on (l).
!
cup
cup
HOW TO USE
03
ASSEMBLY
Always disconnect the vacuum cleaner from the electrical socket
before attaching or removing accessories.
1. Attach the hose to the front of the vacuum cleaner by inserting
it into the air inlet and twisting to the right. To remove the hose
twist to the left and pull to detach.
2.Attach the telescoping wand to the hose at the bend by
pushing the two components together.
3. Attach the floor nozzle the the wand by connecting the two
and then twisting to secure.
Operation
Pull the power cord out of the vacuum cleaner and stop when you see
the yellow mark. Make sure the red mark is not visible or you have
pulled too far. When done cleaning, turn off the power, pull the plug
out of the electrical socket, and then push the rewind button until the
cord is completely retracted.
To turn on the vacuum cleaner, push the plug into an electrical socket
and press the power button.
Switching between carpet & hard floors
There is a switch located on the floor nozzle that can be pressed with
your foot to switch between floor modes. The symbols shown below
correspond to the type of floor the setting is for.
Position1: Bristles extended for hard floor
Position2: Bristles retracted for carpet
CAUTION: Always switch off the vacuum cleaner before connecting or disconnecting the hose/attachments
or removing and emptying the dust cup.
IMPORTANT: The vacuum cleaner is equipped with a thermal cut-off. If for any reason the vacuum deaner
does overheat, the thermostat will automatically turn the vacuum cleaner off. If this happens ,switch the
vacuum cleaner off and unplug it from the electrical socket. Remove and empty the dust cup also check the
vacuum deaner for blockages. Allow the vacuum cleaner to cool for approximately 1 hour (if you have
cleaned the incorrect space ,please wait 24 hours for the filters to fully dry before putting them back into the
machine).
MAINTENANCE
04
Emptying the dust cup
Always switch off the vacuum and unplug it from the electrical socket before carrying out any maintenance
or cleaning.
Empty the dust cup after each use. Also be sure to empty the dust cup anytime dust reaches the max fill
line.
A full dust cup will reduce the efficiency of the vacuum cleaner so be sure to empty the dust cup regularly.
1. Press the dust cup release button and take the dust cup out of the vacuum.
2. Bring the dust cup over a trash receptacle and then press the release button to open the lower lid. The
dust will fall out the bottom and into the trash.
3. Close the dust cup lid after dust has been fully emptied. Return the dust cup to the vacuum cleaner.
Cleaning the Filter
The filter is an effective system for removing dust.
Sponge filters require cleaning on a monthly basis (or more depending on use frequency).
Do not operate the vacuum cleaner without the sponge filter in place.
1. To remove the filter, pull on the dust cup lid clip and lift the cover upwards.
2. The filter is located inside the top cover of the dust cup.
Pull on the handle of the filter housing then remove it.
3. Tap the filter over a bin to remove the dust.
4. Take the sponge filter out of the filter housing.
5. Wash the filter under water (max. 40 degree).
DO NOT USE DETERGENTS to clean any part.
Leave it out to dry for 24 hours or until fully dry before placing it back in the vacuum cleaner.
6. Put the filter back into the housing. Put the housing and filter back into the dust cup lid. Finally,
close the dust cup lid.
7. Place the dust cup back into the vacuum cleaner until a click is heard.
Filter frame handle
Filter
Cyclone separation
system
PROBLEM SOLVING
05
Connecting to an electrical socket
Please check that the voltage indicated on the product corresponds with your supply voltage.
Problem Possible cause Solution
The vacuum
cleaner does
not turn on
•Too much dust in the cup
•Filter is blocked
•Hose is blocked
•Empty the dust cup
•
•Clear the blockage
The vacuum
cleaner does
not work
•Electrical outlet is not
The dust cup is filled
connected or not working
•Power switch was not
turned on
•Ensure the plug is properly connected in
the socket and the socket is active
•Press the power button
The vacuum
cleaner
suddenly
stops
•
•
•Suction inlet of brush or
accessories is blocked
•Empty the dust cup
•
•Clear the blockage
Make sure vacuum is turned off and power cord is unplugged.
!
N O T I C E: Thermal cut-off
This vacuum cleaner has a special thermostat that protects the vacuum in case of motor overheating.
If the vacuum suddenly shuts off, proceed as follows: 1) Push the power switch to off and
unplug the vacuum. 2) Check the vacuum for a possible source of overheating such as a full dust cup,
blocked hose or clogged filter. If these conditions are found, fix them and wait at least 30 minutes
before attempting to use the vacuum. 3) After the 30 minute period, plug the vacuum back in and
turn on the switch. If the vacuum still does not work, call the Eureka Customer Service HELPLINE at
1-800-282-2886.
Correct Disposal of this product
This marking indicates that this product should not be disposed with other household
wastes throughout the EU. To prevent possible harm to the environment or human
health from uncontrolled waste disposal, recycle it responsibly to promote the
sustainable reuse of material resources. To return your used device, please use the
return and collection systems or contact the retailer where the product was purchased.
They can take this product for environmental safe recycling.
PEMBERSIH VAKUM
PANDUAN PENGGUNA
MVC-C1433-BG
MVC-C1433-BA
SILA BACA BUKU PANDUAN
INI DENGAN TELITI SEBELUM
MENGGUNAKAN PRODUK INI,
DAN DISIMPAN DENGAN
BAIK UNTUK RUJUKAN
KELAK.
Notis amaran: Sila baca buku
panduan ini dengan teliti sebelum
menggunakan produk ini, dan
disimpan untuk rujukan kelak.
Reka bentuk dan spesifikasi produk
adalah tertakluk kepada perubahan
untuk penambahbaikan produk
tanpa notis terlebih dahulu.
Sila dapatkan nasihat daripada
peniaga atau pengeluar untuk
maklumat lebih lanjut.
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Sprachen:
Andere Midea Staubsauger Handbücher
Midea
Midea P71 Administratorhandbuch
Midea
Midea Eureka I5C Bedienungsanleitung
Midea
Midea VTW21A15T Bedienungsanleitung
Midea
Midea VCL10 Bedienungsanleitung
Midea
Midea MCS2025GB Bedienungsanleitung
Midea
Midea V19P13A20Q0C Bedienungsanleitung
Midea
Midea C3 VC1707 Administratorhandbuch
Midea
Midea VCS861P Bedienungsanleitung
Midea
Midea MVC-12M-GR Bedienungsanleitung
Midea
Midea MSB 5.700bs Administratorhandbuch
Midea
Midea Eureka I5C Bedienungsanleitung
Midea
Midea MVC-V18P Bedienungsanleitung
Midea
Midea VCS861B Bedienungsanleitung
Midea
Midea VTW21A15T-140 Bedienungsanleitung
Midea
Midea VSS5800 Bedienungsanleitung
Midea
Midea MVC-14D Bedienungsanleitung
Midea
Midea C5 Bedienungsanleitung
Midea
Midea VC-15C189 Bedienungsanleitung
Midea
Midea CH835 Bedienungsanleitung
Midea
Midea VCWX10 Bedienungsanleitung
Beliebte Staubsauger Handbücher anderer Marken
Bissell
Bissell LittleGreen Proheat 1425 Series Bedienungsanleitung
Panasonic
Panasonic MC-YL637S147-AE Bedienungsanleitung
NEFF
NEFF N17XH10 0 Series Bedienungsanleitung
LG
LG A9 Series Bedienungsanleitung
Oreck
Oreck Cordless Captura BK51700 Series Bedienungsanleitung
Kogan
Kogan KAVACROBVWA Bedienungsanleitung
