MikroTik CCR2004-1G-2XS-PCIe Bedienungsanleitung

CCR2004-1G-2XS-PCIe

Safety Warnings

Before you work on any equipment, be aware of the hazards involved with electrical circuitry, and be familiar with standard practices for preventing

accidents.

Ultimate disposal of this product should be handled according to all national laws and regulations.

The Installation of the equipment must comply with local and national electrical codes.

This unit is intended to be installed in the rackmount. Please read the mounting instructions carefully before beginning installation. Failure to use the

correct hardware or to follow the correct procedures could result in a hazardous situation for people and damage to the system.

This product is intended to be installed indoors. Keep this product away from water, fire, humidity, or hot environments.

Use only the power supply and accessories approved by the manufacturer, which can be found in the original packaging of this product.

Read the installation instructions before connecting the system to the power source.

We cannot guarantee that no accidents or damage will occur due to the improper use of the device. Please use this product with care and operate at your

own risk!

In the case of device failure, please disconnect it from power. The fastest way to do so is by unplugging the power plug from the power outlet.

It is the customer's responsibility to follow local country regulations, including operation within legal frequency channels, output power, cabling

requirements, and Dynamic Frequency Selection (DFS) requirements. All Mikrotik devices must be professionally installed.

Quick start

Connect with your computer to the device;PCIe

Download the configuration tool ;https://mt.lv/winbox

Open the tab and connect to the device using the MAC address;

Neighbors



Theuser name: , by default there is no password;

admin

To dupdate the device to the latest software version ownload the latest RouterOS software from ;https://mikrotik.com/download

Choose ARM64 packages, and save them to your computer;

Return to the WinBox and upload downloaded packages;

Restart the device.

Powering

The device uses power from with Maximum power consumption of 29W.PCIe

Configuration

By default, the PCIe interface will show up as four virtual Ethernet interfaces. Two interfaces in passthrough mode to the 25G SFP28 cages. The remaining

two virtual Ethernet-PCIe interfaces are bridged with the Gigabit Ethernet port for management access.

Specifications

Product code CCR2004-1G-2XS-PCIe

CPU AL32400 2 GHz

CPU architecture ARM 64bit

CPU core count 4

Size of RAM 4 GB

RAM type DDR4

Storage 128 MB, NAND

Number of 1G Ethernet ports 1

Number of 25G SFP28 ports 2

Operating system RouterOS (License level 6)

Dimensions 170 x 69 x 18 mm

Operating temperature -20°C to +60°C

Max power consumption 25 W

Reset button

The reset button has two functions:

Hold this button during boot time until LED light starts flashing, release the button to reset RouterOS configuration.

Or Keep holding the button for 5 more seconds until LED turns off, then release it to make the RouterBOARD look for Netinstall servers.

Regardless of the above option used, the system will load the backup RouterBOOT loader if the button is pressed before power is applied to the device.

Useful for RouterBOOT debugging and recovery.

Included Parts

Operating System Support

The device supports RouterOS software with the version number v7 at or above what is indicated in the RouterOS menu /system resource. Other

operating systems have not been tested.

Minimum host kernel version required so that card is recognized: stable: 5.16.11 long-term: 5.15.25

https://git.kernel.org/pub/scm/linux/kernel/git/netdev/net.git/commit/?id=bf8e59fd315f

Safety Notice

Electric shock hazard. This equipment is to be serviced by trained personnel only.

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a commercial installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction

manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference

in which case the user will be required to correct the interference at his own expense

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this

equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful

interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Note: This unit was tested with shielded cables on the peripheral devices. Shielded cables must be used with the unit to ensure compliance.

Innovation, Science and Economic Development Canada

This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science, and Economic Development Canada’s license-exempt

RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference,

including interference that may cause undesired operation of the device.

L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique

Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : 1) L’appareil ne doit pas produire

de brouillage; 2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.

This ClassA digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe [A] est conforme à la norme NMB-003 du Canada.

CAN ICES-003 (A) / NMB-003 (A)

            UKCA marking

To avoid pollution of the environment, please separate the device from household waste and dispose of it in a safe manner, such as at

designated waste disposal sites. Familiarize yourself with the procedures for the proper transportation of the equipment to the designated

disposal sites in your area.

Andere Handbücher für CCR2004-1G-2XS-PCIe

Inhaltsverzeichnis

Andere MikroTik Netzwerk-Hardware Handbücher

MikroTik

MikroTik ATL LTE18 kit Bedienungsanleitung

MikroTik

MikroTik LHG LTE6 Bedienungsanleitung

MikroTik

MikroTik RouterBOARD Groove 2Hn Bedienungsanleitung

MikroTik

MikroTik wAP R ac Series Bedienungsanleitung

MikroTik

MikroTik RouterBOARD 750G Bedienungsanleitung

MikroTik

MikroTik RBM11G Bedienungsanleitung

MikroTik

MikroTik RouterBOARD 1000 Bedienungsanleitung

MikroTik

MikroTik L009UiGS-2HaxD-IN Bedienungsanleitung

MikroTik

MikroTik Network Controller Bedienungsanleitung

MikroTik

MikroTik RBwAPG-60ad-A Bedienungsanleitung

MikroTik

MikroTik RB5009UPr+S+IN Bedienungsanleitung

MikroTik

MikroTik RouterBOARD 800 Series Bedienungsanleitung

MikroTik

MikroTik CCR2004-16G-2S+PC Bedienungsanleitung

MikroTik

MikroTik CSS610-8G-2S+IN Bedienungsanleitung

MikroTik

MikroTik LHG Lite60 Bedienungsanleitung

MikroTik

MikroTik ATL LTE18 kit Bedienungsanleitung

MikroTik

MikroTik RBMetalG-52SHPacn Bedienungsanleitung

MikroTik

MikroTik RBwAPR-2nD Bedienungsanleitung

MikroTik

MikroTik CRS310-1G-5S-4S Plus OUT Bedienungsanleitung

MikroTik

MikroTik hAP ax lite LTE6 Bedienungsanleitung

MikroTik

MikroTik C52iG-5HaxD2HaxD-TC Bedienungsanleitung

MikroTik

MikroTik FiberBox Plus Bedienungsanleitung

MikroTik

MikroTik CCR2004-16G-2S+ Bedienungsanleitung

MikroTik

MikroTik RouterBOARD 711A-5Hn Bedienungsanleitung

Beliebte Netzwerk-Hardware Handbücher anderer Marken

Matrix Switch Corporation

Matrix Switch Corporation MSC-HD161DEL Bedienungsanleitung

B&B Electronics

B&B Electronics ZXT9-IO-222R2 Bedienungsanleitung

Yudor

Yudor YDS-16 Bedienungsanleitung

D-Link

D-Link ShareCenter DNS-320L Bedienungsanleitung

Samsung

Samsung ES1642dc Gebrauchsanweisung

Honeywell Home

Honeywell Home LTEM-PV Montageanleitung

evertz

evertz 7700 Series Bedienungsanleitung

D-Link

D-Link ShareCenter DNS-343 Bedienungsanleitung

Asante

Asante AsanteBridge 1012 Bedienungsanleitung

FireBrick

FireBrick FB2700 Bedienungsanleitung

Audiovox Electronics

Audiovox Electronics ARWH2T Bedienungsanleitung

ADC

ADC DSX-1 Handbuch

NetComm

NetComm NF2 Bedienungsanleitung

Alcatel-Lucent

Alcatel-Lucent 5620 Bedienungsanleitung

Dell EMC

Dell EMC XC6420 Series Bedienungsanleitung

Lanner

Lanner NCA-1020A Bedienungsanleitung

Allied Telesis

Allied Telesis AT-TN121-A Bedienungsanleitung

Lanner

Lanner NCA-1525 Bedienungsanleitung