Milwaukee PH55 Bedienungsanleitung

BATTERY REPLACEMENT:

Units are supplied with BEPS (Battery Error Pre-venting

System) which avoids any erroneous reading due to low

battery level, by switching the meter off. To replace the

batteries unscrew the battery compartment cap and replace all

three 1.5V batteries while paying attention to their polarity.

Make sure the gasket is in place before screwing back the cap.

Batteries should only be replaced in a nonhazardous area using

the battery type specified in this instruction manual.

WARRANTY:

This meter (base unit) is warranted from all defects in

materials and manufacturing for a period of two years.

The electrode (probe end) is warranted for a period of 6

months.

During this period, the required repair or replacement of parts,

where the damage is not due to negligence or erroneous

operation by the user, will be effected free of charge.

WARRANTY REGISTRATION:

Please go to our web site and register your unit at

http://www.milwaukeeinstruments.com/registration.html

__________________________________________________

FOR A MUCH MORE DETAILED

OPERATORS MANUAL

GO TO OUR WEB SITE / MANUALS SECTION

AT THE FOLLOWING ADDRESS

www.milwaukeeinstruments.com

_______________________________________

Milwaukee Instruments

2950 Business Park Drive

Rocky Mount, NC 27804

Phone # 242-443-3630

PH55 & PH56 WATERPROOF

METER

STARTER MANUAL

•When calibration is completed the unit LED will flash

“OK 2”for 2 sec. then return to the temperature display

& normal operation taking the unit out of the calibration

mode. ** YOU ARE NOW CALIBRATED AND

READY TO PERFORM MEASURMENTS

_____________________________________

#3: OPERATION OF THE PH55 –PH56:

• Remove the unit from your storage container cup or jar

( Remember to always store the probe wet )

• Turn the pH55 - Ph56 on by pressing the ON key.

• Immerse the electrode in the solution to be tested.

• Stir gently and wait for the reading to stabilize.

• After the reading is stable you can press “SET / HOLD”

button and unit will freeze display until you press the

“SET / HOLD” button again to release the display.

• After use, turn unit off by pressing the OFF key and

rinse the end of the probe with water and then return it

to jar or cup for storage.

____________________________________________

#3: STORAGE OF THE PH55 –PH56:

Leave the protective cap off and put the unit back in a

cup or jar that has 1” to 1.5” of either bottle drinking

water, or 4.01 calibration solution, or MA9015 storage

solution

___________________________________________

You Must Move Unit - VERY FAST –Between

The 7.0 & 4.0 Cal Solution During The

Calibration Procedure –> Please Read Through

Instructions prior to starting procedure

NEVER LET YOUR PROBE DRY OUT

_________________________________

NEVER USE DISTILLED OR

DEIONIZED WATER FOR STORAGE

PURPOSES.

Andere Handbücher für PH55

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Milwaukee Messgerät Handbücher

Milwaukee

Milwaukee MAX MW160 Bedienungsanleitung

Milwaukee

Milwaukee Heavy Duty 2270-20 Bedienungsanleitung

Milwaukee

Milwaukee MW105 MAX Bedienungsanleitung

Milwaukee

Milwaukee REDLITHIUM L4 3PL Bedienungsanleitung

Milwaukee

Milwaukee MC730 Bedienungsanleitung

Milwaukee

Milwaukee MA871 Bedienungsanleitung

Milwaukee

Milwaukee 48-22-9801 Bedienungsanleitung

Milwaukee

Milwaukee MI 106 Bedienungsanleitung

Milwaukee

Milwaukee SM500 Bedienungsanleitung

Milwaukee

Milwaukee MI415 Bedienungsanleitung

Milwaukee

Milwaukee 2235-40 Bedienungsanleitung

Milwaukee

Milwaukee REDSTICK MLDIG14 Bedienungsanleitung

Milwaukee

Milwaukee MI605 Bedienungsanleitung

Milwaukee

Milwaukee LDM 30 Bedienungsanleitung

Milwaukee

Milwaukee PRO MW801 Bedienungsanleitung

Milwaukee

Milwaukee LRD100 Bedienungsanleitung

Milwaukee

Milwaukee PRO MI415 Bedienungsanleitung

Milwaukee

Milwaukee MI407 Bedienungsanleitung

Milwaukee

Milwaukee MW100 Bedienungsanleitung

Milwaukee

Milwaukee M12 3622-20 Bedienungsanleitung

Milwaukee

Milwaukee Mi 180 Bedienungsanleitung

Milwaukee

Milwaukee MA872 Bedienungsanleitung

Milwaukee

Milwaukee MA881 Bedienungsanleitung

Milwaukee

Milwaukee MW170 MAX Bedienungsanleitung

Beliebte Messgerät Handbücher anderer Marken

Suaoki

Suaoki D40 Bedienungsanleitung

Elster

Elster BK-G1.6 Bedienungsanleitung

Endress+Hauser

Endress+Hauser Deltabar FMD71 Handbuch

Duratool

Duratool D03128 Bedienungsanleitung

Vega

Vega VEGAPULS 65 Bedienungsanleitung

Tonghui

Tonghui TH2618B Bedienungsanleitung

Tenmars

Tenmars TM-801 Bedienungsanleitung

MSR

MSR 145 Bedienungsanleitung

TPS

TPS WP-82 Bedienungsanleitung

ELMETRON

ELMETRON CP-511 Bedienungsanleitung

PCB Piezotronics

PCB Piezotronics 003C30 Bedienungsanleitung

Tenma

Tenma 72-10465 Bedienungsanleitung

Endress+Hauser

Endress+Hauser Proline Promag 50 Technische Daten

Siemens

Siemens SITRANS F Coriolis FCT030 Stücklistenhandbuch

KLINGER

KLINGER CMF V Series Bedienungsanleitung

EXFO

EXFO FTB-2 Bedienungs- und Wartungshandbuch

Keysight

Keysight M8290A Bedienungsanleitung

ADTEK

ADTEK MW-5 Bedienungsanleitung