ML Accessories EMKIT2 Bedienungsanleitung

INSTALLATION & MAINTENANCE MANUAL

EMKIT2

These instructions should be read carefully and retained after installation by the end user for future

reference and maintenance.

These instructions should be used to aid installation of the following product:

EMKIT2

GENERAL INSTRUCTIONS

• This product must be installed in accordance with the latest edition of the IEE Wiring Regulations (BS7671)

and current Building Regulations. If in any doubt, consult a qualiﬁed electrician

• Please isolate mains prior to installation or maintenance

• Check the total load on the circuit (including when this product is ﬁtted) does not exceed the rating of the

circuit cable, fuse or circuit breaker

• Please note the IP (Ingress Protection) rating of this product when deciding the location for installation

• Choose a suitable location for the ﬁtting allowing a 50mm space above and around the product

• This product must not be covered by insulation

• Do not overload this accessory or subject it to conditions outside its rating

• This product is Class II double insulated

• This product is IP20 rated (indoor use only)

SAFETY

• Provide power to the required point of installation (refer to BS7671 for correct cabling methods)

• Connect the cable marked “AC Mains” to the permanent Live (Brown) and Neutral (Blue)

(see Fig. 1)

• Connect the cable marked “LED Load” to the LED

• Connect the cable marked “LED Driver” to the secondary side of the compatible driver

Note: Some luminaires may have the connections reversed, in this case please use the adaptors provided to

convert a Female to a Male connector and a Male to Female connector (see Fig. 2)

INSTALLATION

Fig. 2

Fig. 1

• Switch on and check for correct operation ensuring that the green LED indicator is illuminated

We recommend, on commissioning the installation, a minimum charge period of 24 hours before carrying

out an emergency duration test

If the batteries have been left in a discharged state for an extended period, we recommend that one or more

charge and discharge cycles are completed which should help to restore the battery capacity

• The product comes equipped with two LED indicator holders. To install, mark the location of the LED

indicator holder and drill a 6.5mm/18mm hole ensuring it does not infringe with any joists, gas/water pipes

or electrical cables

Note: The LED indicator needs to be visible

This product must be disconnected from the circuit if subjected to any high voltage or insulation resistance

testing. Irreparable damage will occur if this instruction is not followed.

WARNING

This product should be recycled in the correct manner when it reaches the end of its life. Check local

authorities for where facilities exist.

The batteries in this luminaire are Nickel Cadmium and must be disposed of correctly. Please contact the

local authorities for the disposal of this toxic waste.

GENERAL

This product has a warranty of 3 years (excluding battery) from date of purchase. Failure to install this

product in accordance with the current edition of the IEE Wiring Regulations (BS7671), improper use, or

removal of the batch codes will invalidate the warranty. If this product should fail within its warranty period, it

should be returned to the place of purchase for a free of charge replacement. ML Accessories does not accept

responsibility for any installation costs associated with the replacement product. Your statutory rights are not

affected. ML Accessories reserve the right to alter product speciﬁcation without prior notice.

WARRANTY

TEST RECORD SHEET

INITIAL COMMISSIONING

3 HOUR TEST

SIGNED DATE

MONTH TEST

FIRST YEAR SECOND YEAR THIRD YEAR FOURTH YEAR FIFTH YEAR

SIGNED DATE SIGNED DATE SIGNED DATE SIGNED DATE SIGNED DATE

1 FUNCTIONAL

2 FUNCTIONAL

3 FUNCTIONAL

4 FUNCTIONAL

5 FUNCTIONAL

6 FUNCTIONAL

7 FUNCTIONAL

8 FUNCTIONAL

9 FUNCTIONAL

10 FUNCTIONAL

11 FUNCTIONAL

12 3 HOUR

Installed by: Installation date:

Contact number:

Recommended routine test procedure in accordance with BS5266

• Daily check – check LED charge indicator is illuminated

• Monthly functional test - simulate a mains supply failure for approx. 30 seconds by operation

of key switch or switching off circuit breaker. Ensure normal supply is restored after test and ensure

charge indicator is illuminated

• Annual three hour duration test - simulate a mains supply failure for three hour continuous test by

operation of key switch or switching off circuit breaker. Ensure normal supply is restored after test and

ensure charge indicator is illuminated

• If the luminaire fails any of the above tests, please contact a qualiﬁed electrician.

See below for test record sheet

TESTING FOR EMERGENCY LUMINAIRES

AVMAY21_V3

ML Accessories Limited LU5 4LT

www.mlaccessories.co.uk

INTERNATIONAL

CONTACT DETAILS

INTERNATIONAL

CONTACT DETAILS

INTERNATIONAL

CONTACT DETAILS

Inhaltsverzeichnis

Andere ML Accessories Beleuchtungsausrüstung Handbücher

ML Accessories

ML Accessories EMLSUS Bedienungsanleitung

ML Accessories

ML Accessories NH023AW Bedienungsanleitung

ML Accessories

ML Accessories ENM5 Bedienungsanleitung

ML Accessories

ML Accessories NH0183BD Bedienungsanleitung

ML Accessories

ML Accessories EMLRECL Bedienungsanleitung

ML Accessories

ML Accessories SPIKEW Bedienungsanleitung

ML Accessories

ML Accessories POTHB1 Bedienungsanleitung

ML Accessories

ML Accessories T8BLED15EM1 Bedienungsanleitung

ML Accessories

ML Accessories 12DCIP40 Bedienungsanleitung

ML Accessories

ML Accessories CABBCCW Bedienungsanleitung

ML Accessories

ML Accessories OWALL1 P Series Bedienungsanleitung

ML Accessories

ML Accessories SPIKE5S Bedienungsanleitung

ML Accessories

ML Accessories CFR5CCT Bedienungsanleitung

ML Accessories

ML Accessories LEDFRA6 Bedienungsanleitung

ML Accessories

ML Accessories Knightsbridge BT9H4/6K Bedienungsanleitung

ML Accessories

ML Accessories LWR2G Bedienungsanleitung

ML Accessories

ML Accessories NH019W Bedienungsanleitung

ML Accessories

ML Accessories FLP Series Bedienungsanleitung

ML Accessories

ML Accessories T8BLED12 Bedienungsanleitung

ML Accessories

ML Accessories NH016W Bedienungsanleitung

ML Accessories

ML Accessories BF1430S Bedienungsanleitung

ML Accessories

ML Accessories RW6WW Bedienungsanleitung

ML Accessories

ML Accessories RWL2A Bedienungsanleitung

ML Accessories

ML Accessories OSPCKIT Bedienungsanleitung

Beliebte Beleuchtungsausrüstung Handbücher anderer Marken

Brizo

Brizo 8SP-MU-4 Bedienungsanleitung

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Bedienungsanleitung

IKEA

IKEA BJÖRKSPIREA Bedienungsanleitung

Laserworld

Laserworld Evolution Series ES-400RGB Bedienungsanleitung

Alien

Alien RG STAR Bedienungsanleitung

EuroLite

EuroLite LED B-40 Bedienungsanleitung

Qazqa

Qazqa Suplux SL 3 Black 103062 Bedienungsanleitung

Commercial Electric

Commercial Electric 54568141 Bedienungsanleitung

CREE LIGHTING

CREE LIGHTING 304 Series Bedienungsanleitung

Goobay

Goobay 49867 Bedienungsanleitung

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Bedienungsanleitung

Alkalite

Alkalite Krypton KT-81 Bedienungsanleitung

Clas Ohlson

Clas Ohlson GU10 Bedienungsanleitung

DTS

DTS DELTA 10 F Bedienungsanleitung

ring

ring Solar Steplight Bedienungsanleitung

One Stop Gardens

One Stop Gardens 57696 Montageanleitung

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Bedienungsanleitung

SIREM

SIREM Swimeo A2 Bedienungsanleitung