Delta softstart RevB17 26-9-17
9
6.0 ISOLATION
1In an emergency, switch off at the mains wall isolator, or the machine’s
emergency stop button. To release the emergency stop button, turn clockwise.
7.0 CLEANING INSTRUCTIONS
NOTE:
-Cleaning must be carried out by fully trained personnel only.
-Isolate machine from mains supply before carrying out any cleaning.
-Do not steam clean or use a jet of water,
except in the rotary template drive gear compartment
All the outer surfaces of the machine should be wiped over with warm soapy water.
Do not use any form of caustic detergent or abrasive.
BETWEEN PRODUCT MIX CHANGES
1 The hopper, hopper pump, template, nozzles etc should be removed from the
machine and dismantled for thorough cleaning.
2Prior to removing the hopper or template, the guards must be hinged up and
propped into the appropriate position.
3Slacken template clamp strip nuts and remove fitted template from hopper
pump assembly by sliding out to avoid subsequent damage.
4To reduce weight and bulk, separate and remove hopper body from hopper
pump assembly whilst still on the machine. Unscrew the nuts holding the
hopper body to the hopper pump to reveal the ‘0’ sealing ring. Ensure seal is
not damaged during cleaning.
5Unscrew hopper retaining pin and remove hopper pump assembly from
machine to separate cleaning area.
HINGED UP
STOP BUTTON
