Movincool PC7 Bedienungsanleitung

OPERATION MANUAL

READ THIS MANUAL CAREFULLY FOR INSTRUCTIONS ON CORRECT

INSTALLATION AND USAGE, AND READ ALL SAFEGUARDS.

SECCION EN ESPANOL

SECTION EN FRANÇAIS

‘

Congratulations on purchasing the MovinCool portable air conditioner. This manual explains

how to install and operate the MovinCool PC7 portable air conditioning unit. Please

read this operation manual thoroughly to familiarize yourself with the features of the unit and

to ensure years of reliable operation. You may also find it useful to keep this operation

manual on hand for reference.

Components and/or procedures are subject to change without prior notice.

Foreword

Contents

Instructions

Unit description and function

Operation of remote control

Use of control panel

Water drainage methods

Maintenance/service

Storage methods

Safety cautions

Troubleshooting

Installation

Window kit installation

Attention:

(1) The unit is not intended for use by young children without supervision.

(2) The plug should be accessible after installing the unit.

(3) The unit should be installed in accordance with national wiring regulations/codes.

(4) If the power cord is damaged, it must be replaced by the manufacturer or

a qualified service contractor. Contact your reseller for more information.

INTRODUCTION

The PC7 is a small appliance,which can adjust the temperature and humidity in

a room making it easy to use in different occasions. It also has multiple modes,

including cooling, dehumidifying and fan only.This unit was designedto be used

in a family house, office, etc.

MOBILE AIR CONDITIONER

Other air conditioning solutions are recommended when the indoor temperature

is either below 650F(170C) or above 950F(350C) .

Before you use your PC7 air conditioner,please read entire instruction

manual carefully.

This instruction manual is used for information only and does not form part of a

contract. We reserve the right to make technical changes without prior notice.

ATTENTION

FRONT

BACK

control panel

hot air outlet grill

condenser air inlet grill

evaporator air inlet grill

air oulet

up/down air swinging fins

caster cable (power

cordandplug)

water tank

handle

left/right air swinging fins

UNIT DESCRIPTION AND FUNCTION

Sets the room

temperature

SWING Button

Pressing this button

will activate/deactivate

auto-swing feature for

front louvers

FAN SPEED Button

Pressing this button

will cycle through high,

middle,or low fan speed.

MODE Button

Pressing this button will

cycle through cooling,

drying,or fan-only mode

TIMER Button

Press this button to set the

timerfor switch-on,switch-

off or to stop the timer.

TIME Button

This button sets

the present time

and TIMER .

POWER

Indication

light

WATER

FULL

indication

light

ON/OFF Button

Press this button will turn

the unit ON or OFF

TEMP Button

Displayspreset temperature and failure codes

*When SET is displayed,the displayed digits

indicate the preset temperature

*When FAULT is displayed.the displayed digits

indicate the code of failures.

MODE

COOL

DRY

FAN

HEAT

FAN SPEED HIGH MED LOW

SWING

SET FAULT C

OFF

0peration mode

indicator

Timer Display

The displayed digits

indicate the remaining

time of on/off operation

Louver indicator

Fan speed indicator

TIMER TIME

POWER WATER FULL

SWING

FAN SPEEP MODE

TEMP

MODE

COOL

DRY

FAN

HEAT

FAN SPEED HIGH MED LOW

SWING

SET FAULT C

OFF

MODE

UNIT DESCRIPTION AND FUNCTION

OPERATION OF REMOTE CONTROL

SETTING CURRENT TIME

When batteries are inserted, Time is automatically set to AM 12:00

Example:Set time to AM 10:30

Display screen

Temperature setting button

This button is used to set the

room temperature,Each

pressing of the" " or " "

button, will increase or

decreased the set temp by

10C or 10F.

ON/OFF Button

Pressing this button

will turn the machine

ON or OFF.

MODE selection

Button

Pressing this button will

cycle through cooling,

dehumidification, or

fan mode

SWING button

Allows the louver

grills to oscillate

back and forth

automatically

HOLD button

Press this button to

lock or unlock the

keyboard.

FAN SPEED Button

Pressing this button

chooseshigh, medium, or

low fan speed.

TIMER button

Used to program unit timer.

When used together with the

"HOUR" button, the time setting

can be madewithin the range

of 1-12 hours, with the interval

of one hour.

Time Setting button

This button is used to set

the current time or the time

for timed switch-on or switch-

off.

ON/OFF

MODE

TIMER

HOUR

HOLD

MIN

FAN SPEED

SWING

HEAT

COOL DRY FAN

AM PM ON

OFF

Press the CLK button.

Remove the back cover push the clock botton with

the tip of a ball pen, etc. The time indicator will flicker

and can be set to the present time.

Press the HOUR button. (Set to AM 10 )

Press the MIN button. (Set to 30)

Press the CLK botton again, then reattach

the back cover.

NOTE Current time must be set correctly for timer

to operate correctly.

ON/OFF

MODE

TIMER

HOUR

HOLD

MIN

FAN SPEED

SWING

HEAT

COOL DRY FAN

AM PM ON

OFF

CLK ACL

Remove the

back cover

CONTROL PANEL OPERATION

DEHUMIDIFYING OPERATION

DEHUMIDIFYING AND COOLING OPERATION

The operating ranges for cooling operation is 650F-860F(or 180C-310C)and

the operating range for dehumidifying is 650F-860F(or 180C-310C).

POWER SOURCE

*The AC socket must secured and in good condition

*Do not connect the PC7 to anoutlet which is also being used for other electrical equipment.

*Fully insert plug into A/C outlet,

* The unit will beep for 2 seconds.

After two seconds has passed, press" " button, the unit will begin to run.

1. Keep windows and doors closed to aid in effectively dehumidifying the room.

2. Ensure that the drain tank is properly seated in the unit

3. Repeatedly press " " button to choose the dehumidifying mode, LCD window will show

"DRY". Note: Fan speed cannot be adjusted during dehumidification.

4. When using as a dehumidifier, do not use the air exhaust duct.

NOTE:

In order to improve the cooling efficiency of the unit,ensure that:

a) Do not place the unit in direct sunlight

b) Do not place unit near another heat source.

COOLING OPERATION

1. Ensure that the drain tank is properly seated in the unit.

2.Repeatedly press " " button to choose the cooling mode, LCD window will show "cool".

Note: During the cooling operation, always place the duct through an open window open to

exhaust warm air from the room.

3. Repeatedly press " " button to set a proper room TEMP.at 650F-860F(or 180FC-310C).

4. Press " " button to cycle between fan, high, middle, and low speed.

5. Press " " button to turn on/off louver autoswing, The LCD window will show " " when on.

MODE

USE OF CONTROL PANEL

WATER DRAINAGE

When in cooling or dehumidifying mode, the condensate water will drain

into the tank. When the tank gets full, the WATER FULL indicator will flash.

As shown in the Fig. 1, 2 and 3 below, remove the condensate tank,

empty condensate tank and replace in original position

WATER DRAINAGE METHODS

AUTO SWING FUNCTION

1.Auto swing function

Press" " button, LCD window will show " " and the louvers will swing automatically.

2.Press once again" "button, the symbol " " in the LCD window will disappear, and the

louvers will stop swinging automatically.

fig. 1

Attention:

Press " " and " " buttons together for more than two seconds to lockout the keys. LCD

window will show " " , press the two buttons together again to unlock the keys, " " will

disappear.

TIME SET FUNCTION

To set start time, while the machine is turned off (but power supplied), press" " button, the

LCD window will show " ", press the TIME button to set the start time. The setting range

is 1-12 hours.

To set stop time, while the unit is operating locate and press " " button,the LCD window

will show " ", press the TIME button again to set the stop time. The setting range

is 1-12 hours.

OFF

1. When in cooling or dehumidifying mode, do not take out the condensate tank,or

the buzzer will sound,the compressor will stop, and the mode will change to FAN.

2. If you wish to empty the condensate water before the tank is full, first stop the

unit and wait 3 minutes before removing the condensate tank to prevent water

from spilling ontothe floor.

3. There is a plastic tube with a plug located in the condensate tank area. Do not

remove the plug while the unit is operating.

CAUTION

WATER DRAINAGE METHODS

fig. 2

fig. 3

MAINTENANCE/SERVICE

If the air filter is dirty the unit's air flow volume may be affected. It is recommended

to clean filter once every two weeks.

Removing the air filter

1. Pull the air filter cover out, then up to remove the air filter cover from the unit.

2. Remove foam filter from the air filter cover.

AIR FILTER

*Unplug the unit before cleaning to prevent accidents caused by electric shock.

*Do not use chemical solvent ( like benzene, alcohol glazer) to clean the

surface of the unit. The surface of the PC7 will be scratched,damaged,and

plastic casing can become deformed.

MAINTENANCE METHODS

Clean

Wash the air filter by immersing it gently into warm (approximately 1040F) water

with a neutral detergent, rinse the filter of detergent and dry thoroughly in a

shaded area.

Mounting

1. Attach the filter to the filter cover using the attachment hooks on the inside

surface of the cover.

2. Place tabs at the bottom of the filter cover into mating holes in the case, push

filter back into its orginal position.

grip

Andere Handbücher für PC7

Inhaltsverzeichnis

Andere Movincool Klimaanlage Handbücher

Movincool

Movincool 10SFU-1 Bedienungsanleitung

Movincool

Movincool OFFICE PRO 12 Bedienungsanleitung

Movincool

Movincool Climate Pro K24 Bedienungsanleitung

Movincool

Movincool Classic 18 Bedienungsanleitung

Movincool

Movincool Office Pro 24 Bedienungsanleitung

Movincool

Movincool OFFICE PRO 12 Bedienungsanleitung

Movincool

Movincool Climate Pro K12 Bedienungsanleitung

Movincool

Movincool CM 12 Gebrauchs- und Wartungshandbuch

Movincool

Movincool Office Pro 10 Bedienungsanleitung

Movincool

Movincool Office Pro W20 Bedienungsanleitung

Movincool

Movincool Office Pro 10 Bedienungsanleitung

Movincool

Movincool OFFICE PRO 12 Bedienungsanleitung

Movincool

Movincool Classic 10 Bedienungsanleitung

Movincool

Movincool Office Pro W20 Bedienungsanleitung

Movincool

Movincool Ofice Pro 36 Bedienungsanleitung

Movincool

Movincool Office Pro 24 Bedienungsanleitung

Movincool

Movincool PC7 Bedienungsanleitung

Movincool

Movincool OFFICE PRO 12 Bedienungsanleitung

Movincool

Movincool Classic Plus 14 Bedienungsanleitung

Movincool

Movincool Climate Pro K12 Bedienungsanleitung

Movincool

Movincool Classic Plus 26 Bedienungsanleitung

Movincool

Movincool Classic Plus 14 Bedienungsanleitung

Movincool

Movincool CLIMATE PRO 18 Bedienungsanleitung

Movincool

Movincool Office Pro 36 Bedienungsanleitung

Beliebte Klimaanlage Handbücher anderer Marken

Spheros

Spheros CC 355 Bedienungsanleitung

Bosch

Bosch Climate 5000 SCI 24 CAS/ OU- OUE Bedienungsanleitung

Panasonic

Panasonic CS-E12HKEW Bedienungsanleitung

nedis

nedis ACMB1WT7 Bedienungsanleitung

Samsung

Samsung AR KV Series Leitfaden

Daikin

Daikin FCFV50A Bedienungsanleitung

Fujitsu

Fujitsu Inverter ASBA30JFC Bedienungsanleitung

Toshiba

Toshiba RAS-M10SMUV-E Bedienungsanleitung

Daikin

Daikin FXLQ20MAVE Bedienungsanleitung

Hitachi

Hitachi RAS-E24CAK Bedienungsanleitung

CIAT

CIAT Magister 2 Series Leitfaden

Bestron

Bestron AAC6000 Bedienungsanleitung

Hisense

Hisense 7K Technisches Handbuch

Frigidaire

Frigidaire FFRE0533S1E0 Bedienungsanleitung

Samsung

Samsung AS09HM3N Bedienungsanleitung

Frigidaire

Frigidaire CRA073PU11 Betriebsanleitung

Soleus Air

Soleus Air GB-PAC-08E4 Bedienungsanleitung

McQuay

McQuay MCK020A Bedienungsanleitung