Netvox R311FA Bedienungsanleitung

Model：R311FA

Wireless Activity Detection Sensor

User Manual

This document contains proprietary technical information which is the property of NETVOX

Technology. It shall be maintained in strict confidence and shall not be disclosed to other parties, in whole

or in part, without written permission of NETVOX Technology. The specifications are subject to change

without prior notice.

Table of Content

1. Introduction ...............................................................................................................2

2.Appearance ................................................................................................................3

3. Main Features............................................................................................................4

4. Set up Instruction.......................................................................................................5

5. Data Report................................................................................................................7

6. Installation...............................................................................................................12

7. Relative Devices......................................................................................................13

8. Important Maintenance Instruction .........................................................................13

1. Introduction

The R311FA is a Wireless Activity Detection Sensor for Netvox ClassA type devices based on the

LoRaWAN open protocol and is compatible with the LoRaWAN protocol.

When the device detects movement or vibration, it immediately triggers an alarm.

LoRa Wireless Technology:

LoRa is a wireless communication technology dedicated to long distance and low power consumption.

Compared with other communication methods, LoRa spread spectrum modulation method greatly

increases to expand the communication distance. Widely used in long-distance, low-data wireless

communications. For example, automatic meter reading, building automation equipment, wireless

security systems, industrial monitoring. Main features include small size, low power consumption,

transmission distance, anti-interference ability and so on.

LoRaWAN:

LoRaWAN uses LoRa technology to define end-to-end standard specifications to ensure interoperability

between devices and gateways from different manufacturers.

2. Appearance

Indicator

Battery cover

Function Key

3. Main Features

Apply SX1276 wireless communication module

2 section 3V CR2450 button battery powered

Vibration and battery voltage detection

Compatible with LoRaWANTM Class A

Frequency hopping spread spectrum technology

Configuration parameters can be configured through third-party software platforms, data can be read

and alarms can be set via SMS text and email (optional)

Available third-party platform: Actility / ThingPark, TTN, MyDevices/Cayenne

Improved power management for longer battery life

Battery Life:

⁻Please refer to web: http://www.netvox.com.tw/electric/electric_calc.html

⁻At this website, users can find battery life time for variety models at different configurations.

1. Actual range may vary depending on environment.

2. Battery life is determined by sensor reporting frequency and other variables.

4. Set up Instruction

On/Off

Power on Insert two sections of 3V CR2450 button batteries and close the battery cover

Turn on Press any function key till the green and red indicator flash once.

Turn off

(Restore to factory setting)

Press and hold the function key for 5 seconds till the green indicator flashes for

20 times.

Power off Remove Batteries.

Note:

1. Remove and insert the battery; the device memorizes previous on/off

state by default.

2. On/off interval is suggested to be about 10 seconds to avoid the

interference of capacitor inductance and other energy storage components.

3. Press any function key and insert batteries at the same time; it will enter

engineer testing mode.

Network Joining

Never joined the network

Turn on the device to search the network to join.

The green indicator stays on for 5 seconds: success

The green indicator remains off: fail

Had joined the network

Turn on the device to search the previous network to join.

The green indicator stays on for 5 seconds: success

The green indicator remains off: fail

Fail to join the network

(when the device is on)

First two mins: wake up every 15 seconds to send request.

After two mins: enter sleeping mode and wake up every 15 minutes to send

request.

Note: Suggest to remove batteries if the device is not used to save power.

Suggest to check device verification on gateway.

Function Key

Press and hold for 5 seconds

Restore to factory setting / Turn off

The green indicator flashes for 20 times: success

The green indicator remains off: fail

Press once The device is in the network: the green indicator flashes once and sends a report

The device is not in the network: the green indicator remains off

Sleeping Mode

The device is on and in the

network

Sleeping period: Min Interval.

When the reportchange exceeds setting value or the state changes: send a data

report according to Min Interval.

The device is on but not in

the network

First two mins: wake up every 15 seconds to send request.

After two mins: enter sleeping mode and wake up every 15 minutes to send

request.

Note: Suggest to remove batteries if the device is not used.

Suggest to check device verification on gateway.

Low Voltage Warning

Low Voltage

2.4V

5. Data Report

The device will immediately send a version packet report along with an uplink packet including vibration

status and battery voltage.

The device sends data in the default configuration before any configuration is done.

Default setting:

MaxTime: Max Interval = 60 min = 3600s

MinTime: Min Interval = 60 min = 3600s

BatteryChange: 0x01 (0.1V)

ActiveThreshold: 0x0003 (Threshold range: 0x0003-0x00FF, 0x03 is the most sensitive)

Deactivetime: 0x05 (Deactive time Range: 0x01-0xFF)

ActiveThreshold:

Active Threshold = Critical value ÷ 9.8 ÷ 0.0625

*The gravitational acceleration at standard atmospheric pressure is 9.8 m/s2

*The scale factor of the threshold is 62.5 mg

R311FA vibration alarm:

The device detects a sudden movement or vibration, change of the quiescent state, and it will

immediately send a report. After the vibration alarm, the device waits for DeactiveTime to enter the

quiescent state before starting the next detection. If the vibration continues to occur during this process,

the timing restarts until it enters the quiescent state.

R311FX Series DeviceType:

R311FA 0x01; R311FB 0x02; R311FC 0x03

Note:

The device report interval will be programmed based on the default firmware which may vary.

The interval between two reports must be the minimum time.

Please refer Netvox LoRaWAN Application Command document and Netvox Lora Command Resolver

http://www.netvox.com.cn:8888/page/index to resolve uplink data.

Data report configuration and sending period are as following:

Example of data configuration:

FPort：0x07

Bytes 1 1 Var(Fix =9 Bytes)

CmdID DeviceType NetvoxPayLoadData

CmdID– 1 bytes

DeviceType– 1 byte – Device Type of Device

NetvoxPayLoadData– var bytes (Max=9bytes)

(1) Configure device parameters MinTime = 1min, MaxTime = 1min, BatteryChange = 0.1v

Downlink: 014F003C003C0100000000

The device returns:

814F000000000000000000 (configuration succeeded)

814F010000000000000000 (configuration failed)

Min Interval

(Unit: second)

Max Interval

(Unit: second) Reportable Change Current Change≥

Reportable Change

Current Change＜

Reportable Change

Any number between

1~65535

Any number between

1~65535 Can not be 0. Report

per Min Interval

Report

per Max Interval

Description Device

Cmd

Device

Type

NetvoxPayLoadData

Config

ReportReq

R311FA

0x01

0x4F

MinTime

(2bytes Unit:s) MaxTime

(2bytes Unit:s)

BatteryChange

(1byte

Unit:0.1v)

Reserved

(4Bytes,Fixed

0x00)

Config

ReportRsp

0x81

Status

(0x00_success)

Reserved

(8Bytes,Fixed 0x00)

ReadConfig

ReportReq

0x02

Reserved

(9Bytes,Fixed 0x00)

ReadConfig

ReportRsp 0x82 MinTime

(2bytes Unit:s) MaxTime

(2bytes Unit:s)

BatteryChange

(1byte

Unit:0.1v)

Reserved

(4Bytes,Fixed

0x00)

(2) Read device configuration parameters

Downlink: 024F000000000000000000

The device returns:

824F003C003C0100000000 (current device configuration parameters)

(3) Change the device type to R311FB (0x02)

Downlink: 034F020000000000000000

The device returns:

834F000000000000000000 (configuration succeeded)

834F010000000000000000 (configuration failed)

(4) Check the current device type

Downlink: 044F000000000000000000

The device returns:

844F020000000000000000 (current device type R311FB)

Description Device

Cmd

Device

Type

NetvoxPayLoadData

SetR311F

TypeReq

R311F

0x03

0x4F

R311FType

(1Bytes,0x01_R311FA,0x02_R

311FB,0x03_R311FC)

Reserved

(8Bytes,Fixed 0x00)

SetR311F

TypeRsp

0x83

Status

(0x00_success)

Reserved

(8Bytes,Fixed 0x00)

GetR311F

TypeReq

0x04

Reserved

(9Bytes,Fixed 0x00)

GetR311F

TypeRsp 0x84

R311FType

(1Bytes,0x01_R311FA,0x02_R

311FB,0x03_R311FC)

Reserved

(8Bytes,Fixed 0x00)

SetActive

ThresholdReq 0x05 Threshold

(2Bytes) Deactivetime

(1Byte,Unit:1s)

Reserved

(6Bytes,Fixed

0x00)

SetActive

ThresholdRsp

0x85

Status

(0x00_success)

Reserved

(8Bytes,Fixed 0x00)

GetActive

ThresholdReq 0x06 Reserved

(9Bytes,Fixed 0x00)

GetActive

ThresholdRsp 0x86 Threshold

(2Bytes) Deactivetime

(1Byte,Unit:1s)

Reserved

(6Bytes,Fixed

0x00)

Andere Handbücher für R311FA

Inhaltsverzeichnis

Andere netvox Zubehör Handbücher

netvox

netvox R718PG-AS923 Bedienungsanleitung

netvox

netvox R718G Bedienungsanleitung

netvox

netvox R809A Bedienungsanleitung

netvox

netvox R718N1 Bedienungsanleitung

netvox

netvox R311DB Bedienungsanleitung

netvox

netvox R718PA2 Bedienungsanleitung

netvox

netvox R718VA Bedienungsanleitung

netvox

netvox R712 Bedienungsanleitung

netvox

netvox ZigBee Z311G Bedienungsanleitung

netvox

netvox R718AD Bedienungsanleitung

netvox

netvox R718PB15A Bedienungsanleitung

netvox

netvox RA0716A Bedienungsanleitung

netvox

netvox R718CN2 Bedienungsanleitung

netvox

netvox R718PQA Bedienungsanleitung

netvox

netvox R313WA Bedienungsanleitung

netvox

netvox R718B1 Series Bedienungsanleitung

netvox

netvox R718J Bedienungsanleitung

netvox

netvox R72615 Bedienungsanleitung

netvox

netvox R718MA Bedienungsanleitung

netvox

netvox R718N1 Bedienungsanleitung

netvox

netvox R718PQ Bedienungsanleitung

netvox

netvox R718DA2 Bedienungsanleitung

netvox

netvox Z311C Bedienungsanleitung

netvox

netvox R311CB Bedienungsanleitung

Beliebte Zubehör Handbücher anderer Marken

Hillco

Hillco 2810 Bedienungsanleitung

Siemens

Siemens QSA2700D Bedienerhandbuch

Contours

Contours ZY024 Bedienungsanleitung

Saivod

Saivod VS621 Bedienungsanleitung

Virtuox

Virtuox VirtuCLEAN 2.0 Bedienungsanleitung

SCE

SCE ENVIRO-THERM SCE-TE170B24VSS Bedienungsanleitung

Z-Wave

Z-Wave HSD-200Z Bedienungsanleitung

turck

turck FMX-IM-2UPLI63FX Bedienungsanleitung

Decagon Devices

Decagon Devices 10HS Bedienungsanleitung

UPPAbaby

UPPAbaby Cup Holder Bedienungsanleitung

Elko

Elko SmartSensor Leakage Wireless Bedienungsanleitung

Grizzly

Grizzly H8371 Bedienungsanleitung

Panasonic

Panasonic HG-T Series Bedienungsanleitung

IFM Electronic

IFM Electronic Efector 250 Series Referenzhandbuch

DigiDesign

DigiDesign 888/24 I/O Bedienungsanleitung

PROZIS

PROZIS QUAY Bedienungsanleitung

patagonia

patagonia PSI Vest Bedienungsanleitung

SFC Energy

SFC Energy EFOY GO! Bedienungsanleitung

netvox R311FA Bedienungsanleitung

Beliebte Zubehör Handbücher anderer Marken