Nortel Millennium Card Bedienungsanleitung
NTP: 506-6501-202
Millennium Card-based terminals:
Installing terminal hardware
Document number: P0883898
Document issue: 00.01
Document status: Standard
Date: June 1998
S
St
ta
an
nd
da
ar
rd
d
Terminals covered by this document:
• Card terminals
• Inmate terminals
insbk202 Page 1 Tuesday, February 16, 1999 8:15 AM
Millennium terminals installation, operation, and
maintenance documentation modules
The table below shows all the customer-orderable books in the terminal
installation, operation and maintenance suite.These books can be ordered
separately as modules or in sets as documentation kits.
Title Order code
All terminals
Millennium terminals provisioning guide A0685011
Millennium terminals: using the craft interface P0883893
Millennium terminals: maintenance troubleshooting P0883894
Millennium terminals pocket troubleshooting guide P0883895
Multi-pay-based terminals
Millennium Multi-pay-based terminals: installing
terminal hardware P0883896
Millennium Multi-pay-based terminals: replacing parts P0883897
Card-based terminals
Millennium Card-based terminals: installing terminal
hardware P0883898
Millennium Card-based terminals: replacing parts P0883899
Desk terminals
Millennium Desk terminals: installing and replacing
hardware P0883900
Also available:
Accessory kit: binder, cover, and spine A0737727
Complete assembly kit (one each of all modules) A0737720
Multi-pay terminal documentation kit A0737722
Card terminal documentation kit A0737723
Desk terminal documentation kit A0737725
insbk202 Page 2 Tuesday, February 16, 1999 8:15 AM
Millennium Card-based terminals:
Installing terminal hardware
Document number: P0883898
Document issue: 00.01
Document status: Standard
Document date: June 1998
©1998 Northern Telecom
All rights reserved
Printed in Canada
NORTHERN TELECOM CONFIDENTIAL:
The information contained in this document is the property
of Northern Telecom. Except as specifically authorized in writing by Northern Telecom, the holder of this
document shall keep the information contained herein confidential and shall protect same in whole or in
part from disclosure and dissemination to third parties and use same for evaluation, operation, and
maintenance purposes only.
Information subject to change without notice
Millennium is a trademark of Northern Telecom
insbk202 Page iii Tuesday, February 16, 1999 8:15 AM
iv
NTP: 506-6501-202 Document issue: 00.01 Status: Standard Date: June 1998
insbk202 Page iv Tuesday, February 16, 1999 8:15 AM
v
Millennium Card-based terminals: installing terminal hardware
Publication history
June 1998
This is the standard release of the installation procedures for
Millennium Card and Inmate terminals reflecting the new
modularized concept for the NTP information.
This new format combines the installation procedures for all
Card-based terminals, including the Millennium Inmate
terminal. Most installation procedures are the same for all
terminals.However,theInmateterminalrequires thataportable
display beinstalledto viewthe craftinterfaceforinstallationand
maintenance routines.This procedure is discussed in a
separate chapter for easy reference.
Also included in this release is a flowchart noting the key points
of the installation procedure to allow experienced installers to
move quickly through the installation procedure.
April 1997
This was the standard release for Millennium card terminals
based on firmware release MTR 1.9.This guide reflects an
upgrade of the Millennium Manager platform to MSR 2.0.
The MSR 2.0 release is backwards compatible with MSR 1.6,
1.7, and 1.8 terminal vintages, therefore the previous versions
of this document and support documents still apply for those
terminals.
insbk202 Page v Tuesday, February 16, 1999 8:15 AM
vi
NTP: 506-6501-202 Document issue: 00.01 Status: Standard Date: June 1998
insbk202 Page vi Tuesday, February 16, 1999 8:15 AM
vii
Millennium Card-based terminals: installing terminal hardware
Table of contents
1 Introduction 1-1
How this guide is organized 1-1
2 Pre-installation overview 2-1
Installation overview 2-1
Setting up the site 2-1
Installing the terminal on-site 2-2
Installing and testing terminal function 2-2
Selecting a site 2-2
Determining backboard requirements 2-3
Selecting the proper fasteners 2-3
Terminal site specifications 2-5
Cable length specifications 2-5
Suggested tools and equipment 2-7
Installing peripheral equipment 2-8
Pre-mounting considerations 2-9
Installing an IAS module 2-9
Positioning the IAS module 2-9
Installing a lock on the terminal 2-11
Identifying your terminal type 2-14
Telephony/control board identification 2-15
Other documentation 2-15
3 Mounting the terminal 3-1
Mounting the backboard 3-2
Testing the line to the terminal 3-3
Mounting and connecting the terminal 3-4
A. Positioning the terminal on the backboard 3-4
B. Unlocking and opening the terminal 3-7
insbk202 Page vii Tuesday, February 16, 1999 8:15 AM
viii
Table of contents
NTP: 506-6501-202 Issue: 00.01 Status: Standard Date: June 1998
C. Installing internal components 3-10
Removing the PCP assembly 3-11
Installing an internal instruction card 3-15
Installing the quick access keys label 3-17
Installing the number card 3-18
D. Re-installing the PCP assembly 3-20
E. Connecting the outside line 3-21
Connecting power to an IAS module 3-23
F. Completing the installation 3-25
Installing external instruction card 3-27
4 Installing a portable display 4-1
Before you install the display 4-2
Entering the craft interface 4-2
Opening the Inmate terminal 4-4
Installing the external portable display 4-5
Re-entering the craft interface 4-7
Removing the portable display 4-9
5 Installation flowcharts 5-1
Card terminal installation flowchart 5-2
Appendix A: Regulatory notes A-1
Industry Canada notice A-1
Shock hazard warning A-3
Address for warranty and repairs in Canada A-3
U.S. regulations A-3
Radio/TV interference A-3
Federal Communications Commission notice A-4
CSA/NRTL/UL installation instructions A-6
Important safety instructions A-7
Shock hazard warning A-8
Appendix B: INSTALL routinequick reference B-1
Installation troubleshooting B-4
Index I-1
insbk202 Page viii Tuesday, February 16, 1999 8:15 AM
Table of contents
ix
Millennium Card-based terminals: installing terminal hardware
Figures
Figure 2-1: Backboard for terminal 2-4
Figure 2-2: Locating the IAS module 2-10
Figure 2-3: Wire positions on the rear terminal PCP block 2-11
Figure 2-4: Installing the terminal housing lock 2-13
Figure 2-5: Locating the product ID label 2-14
Figure 3-1: Backboard with bolt holes indicated 3-2
Figure 3-2: Attaching studs to back of terminal 3-5
Figure 3-3: Backboard keyhole slots 3-6
Figure 3-4: Locating the T- or L-tool apertures 3-7
Figure 3-5: Proper sequence to open housing 3-8
Figure 3-6: Opening the housing, overhead view 3-8
Figure 3-7: Identifying rear housing parts, including ESD points 3-9
Figure 3-8: Front housing, PCP assembly attached 3-10
Figure 3-9: Control PCP connectors 3-12
Figure 3-10: Locating the PCP assembly latch 3-13
Figure 3-11: Removing the PCP assembly 3-14
Figure 3-12: Releasing the clamp plate and ID bezel 3-15
Figure 3-13: Quick access keys bezels 3-17
Figure 3-14: Screws securing the quick access keys 3-18
Figure 3-15: Locating the number card beneath the handset 3-18
Figure 3-16: Accessing the number card 3-19
Figure 3-17: Connecting wires to the terminal block 3-22
Figure 3-18: IAS module terminal block connections 3-23
Figure 3-19: Wire positions on the terminal block 3-24
Figure 3-20: Inserting the external instruction card 3-27
Figure 4-1: Portable VFD on Inmate terminal 4-1
Figure 4-2: Proper sequence to open the housing 4-4
Figure 4-3: Opening the terminal, overhead view 4-5
Figure 4-4: Installing the external portable VFD 4-6
Figure 4-5: Connecting the VFD to the control PCP 4-6
Figure 4-6: Locking/unlocking with the tiebar 4-8
Figure 4-7: Disconnecting the VFD cable 4-10
Figure 4-8: Closing the housing 4-11
Figure 5-1: Terminal installation overview 5-1
Tables
Table 2-1: Fasteners for backboards 2-3
Table 2-2: Cable length chart 2-6
Table 2-3: Recommended tools and equipment 2-7
Table 2-4: Telephony and control PCP labels 2-15
insbk202 Page ix Tuesday, February 16, 1999 8:15 AM
x
Table of contents
NTP: 506-6501-202 Issue: 00.01 Status: Standard Date: June 1998
Table 3-1: Control PCP connections 3-11
Table 3-2: Telephony PCP connections 3-13
Table B-1: INSTALL quick reference B-1
insbk202 Page x Tuesday, February 16, 1999 8:15 AM
Andere Handbücher für Millennium Card
1
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Andere Nortel Touch-Terminal Handbücher
Beliebte Touch-Terminal Handbücher anderer Marken
Wincor Nixdorf
Wincor Nixdorf iPOS plus Advanced Bedienungsanleitung
Ingenico
Ingenico AXIUM EX4000 Bedienungsanleitung
Heisei Electronics
Heisei Electronics Q-POS 815 Bedienungsanleitung
Amano
Amano MTX-15 Bedienungsanleitung
FLOWBIRD
FLOWBIRD CWT Compact Touch Bedienungsanleitung
Demco
Demco SP7 Bedienungsanleitung
Motorola
Motorola MTP850 Bedienungsanleitung
YASKAWA
YASKAWA 62H-MDC0 Bedienungsanleitung
MVG industries
MVG industries NeptuLink Bedienungsanleitung
Price Industries Limited
Price Industries Limited FDC Gebrauchsanweisung
Honeywell
Honeywell TemaKey Bedienungsanleitung
EBN
EBN BPC65-B-A16G Bedienungsanleitung