Numatic RSU150 NX Bedienungsanleitung
NUMATIC RUCKSACK SANITISER UNIT
BATTERY POWERED
Original Instructions
CAUTION,
Read instructions before using the machine.
This machine is not suitable for
spraying / sanitising electrical items.
KEEP FOR FUTURE REFERENCE
numatic.com
RSU150 NX
Kit - Lance & Solution Tube
Assembly - Solution Tube to Machine
is running.
Assembly - Solution Tube to Lance
WARNING: Make sure the solution
tube is securely tted in place.
Do not remove whilst machine
is running.
A
B
To release the solution tube push the quick release
solution tube.
A
Chemical Dosage
WARNING:
dilution rates, could cause reduced cleaning strength or a
high concentration of sanitising mist.
chemical concentrated solution.
Remove the solution tank from the machine prior
to lling with cold water and chemical to avoid
spillage onto the machine. (See following page).
WARNING:
DO NOT USE WITH WATER ABOVE 20°C
TECcare Dosage
Note: Chemical dosage should be strictly adhered
to and only applies to Numatic supplied chemical.
sheet for dilution rates.
5
Fill the solution tank with the required amount
of COLD water.
See dosage table on
the previous page.
Chemical Dosage Machine Setup
Remove the solution tank to ll with cold water and chemicals, this is to avoid spilling liquid
on to the machine.
Fill the solution tank with the correct chemical
dosage.
3
Chemical Information
Note: Inappropriate selection of disinfectant solution may result in damage to unit including
corrosion, pump failure, reduction in mist performance etc. The RSU is fully compatible with
disinfection solutions based on Quaternary Ammonium Salts or Hypochlorous Acid using
appropriate dilution levels. Use of other chemical / disinfectant solutions may invalidate warranty.
Never spray into or towards face.
WARNING IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses,
if present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/attention.
If medical advice is needed, have product container or label at hand.
Always refer to the MSDS (manufacturer’s safety data sheet) for safe usage and disposal.
Only use the chemicals / detergent solution provided. Replacements available from Numatic.
lenses, if present and easy to do.
Continue rinsing.
comfortable for breathing.
This chemical should be kept in the packaging/container
!!
CAS
CAS
Power
- On
User should not turn machine on / o without Solution tube & lance connected.
This machine is not suitable for spraying / sanitising electrical items.
Assembly - Battery Fitting
Using the machine
Adjusting harness height
Caution: The initial priming of the machine can take 1 to 2 minutes. Subsequent relling of the
solution tank will not require re-priming unless system has been de-pressurised.
During start up.
applied.
Ensure harness is straight
and level.
Adjust to t.
Lance Storage (in use)
NOTE*
It is advisable to t the lance to
the carabiner BEFORE tting the
machine to the user.
Lance Storage
Important - Always remove the battery from the machine after use.
being discharged.
De-pressurising the machine
tank from machine.
solution tank after each
use.
Note: wear appropriate
PPE whilst cleaning
machine.
3
The system must be de-pressurised before
disconnecting the solution tube.
3
Cleaning the machine
Male Tank feed O ring
and the machine and requires replacing
if found to be cracked or damaged.
Solution Tank lter
should be cleaned on a frequent basis.
Cleaning Spray Lance
reassemble.
Note: If there is constant dripping when spraying tighten both spray nozzle nuts.
3
Replacement parts
Chemical
Spares and Accessories
Battery
37 V Battery
Fast charger
Charging your battery
Operating time
charger original operating instructions.
Machine data
Schematic diagram
Model Hand / Arm
Vibration
Weight
(Ready to work)
Sound pressure (LpA)
Uncertainty (KpA)
Protection
class Dimensions
Class III
Fluid
Container
Flow
Rate Rated Power Pressure Rating Machine
Weight IP Rating
Andere Handbücher für RSU150 NX
1
Inhaltsverzeichnis
Andere Numatic Zubehör Handbücher
