Oase Aquarius Eco Expert 28000 Bedienungsanleitung

42423/09-16-MH

Aquarius Eco Expert 22000/28000

42423 GA Aquarius_Eco_Expert_end_. 13.09.16 16:48 Seite 2

--

ARS0033

ARS0034

ARS0025

ARS0026

--

ARS0027

ARS0030

--

ARS0029

ARS0028

--

ARS0031

-EN -

Translation of the original Operating Instructions

WARNING

•This unit can be used by children aged 8 and above and by per-

sons with reduced physical, sensory or mental capabilities or lack

of experience and knowledge if they are supervised or have been

instructed on how to use the unit in a safe way and they understand

the hazards involved.

•Do not allow children to play with the unit.

•Only allow children to carry out cleaning and user maintenance un-

der supervision.

•Ensure that the unit is fused for a rated fault current of max. 30 mA

by means of a fault current protection device.

•Only connect the unit if the electrical data of the unit and the power

supply correspond. The unit data is to be found on the unit type plate,

on the packaging or in this manual.

•Possible death or severe injury from electrocution! Before reaching

into the water, always disconnect all units in the water that have a

voltage of >12 V AC or >30 V DC from the power supply.

•Only operate the unit if no persons are in the water.

•Do not use the unit if electrical cables or housings are damaged.

•A damaged connection cable cannot be replaced. Dispose of the

unit.

Safety information

Correct electrical installation

•Electrical installations must meet the national regulations and may only be carried out by a qualified electrician.

•A person is regarded as a qualified electrician if, due to his/her vocational education, knowledge and experience, he

or she is capable of and authorised to judge and carry out the work commissioned to him/her. This also includes the

recognition of possible hazards and the adherence to the pertinent regional and national standards, rules and regula-

tions.

•For your own safety, please consult a qualified electrician.

•Extension cables and power distributors (e.g. outlet strips) must be suitable for outdoor use (splash-proof).

•Protect the plug connection from moisture.

•Only connect the unit to a correctly fitted socket.

-EN -

Safe operation

•The impeller unit in the pump contains a magnet with a strong magnetic field that may affect the operation of pace-

makers or implantable cardioverter defibrillators (ICDs). Always keep magnets at least 0.2 m away from implanted

devices.

•Never carry or pull the unit by the electrical cable.

•Route cables such that they are protected from damage and do not present a tripping hazard.

•Never carry out technical changes to the unit.

•Only carry out work on the unit described here.

•Only use original spare parts and accessories for the unit.

Information about these operating instructions

Welcome to OASE Living Water. You made a good choice with the purchase of this product Aquarius Eco Expert

22000/28000.

Prior to commissioning the unit, please read the instructions of use carefully and fully familiarise yourself with the unit.

Ensure that all work on and with this unit is only carried out in accordance with these instructions.

Adhere to the safety information for the correct and safe use of the unit.

Keep these instructions in a safe place! Please also hand over the instructions when passing the unit on to a new

owner.

Symbols used in these instructions

Warnings

The warning information is categorised by signal words, which indicate the extent of the hazard.

WARNING

•Indicates a possibly hazardous situation.

•Non-observance may lead to death or serious injuries.

CAUTION

•Indicates a possibly hazardous situation.

•Non-observance may lead to slight or minor injuries.

NOTE

Information for the purpose of clarification or for preventing possible damage to assets or to the environment.

Additional information

A Reference to a figure, e.g. Fig. A.

→Reference to another section.

Scope of delivery

A

Aquarius Eco Expert 22000/28000

Filter pump with filter housing (2)

Filter housing

Stand

38 mm (1½ ‘‘) hose connector

50 mm (2 ‘‘) hose connector

Union nut 50 mm (2 ‘‘) for fastening the hose connector (4)

Flat seal 45 × 33 × 3 mm for the hose connector (4)

Hose clip 40 … 60 mm

-EN -

Product Description

B

Aquarius Eco Expert 22000/28000

Pump casing

•The position of the outlet can be changed by fitting the pump casing rotated through 90°.

Outlet (pressure socket)

Inlet (suction socket)

Filter housing

Stand

•Ensures secure and stable positioning of the pump.

•Can be firmly bolted to the ground.

Connection OASE Easy Garden Control (EGC)

•The pump can be controlled via EGC with Eco Control or InScenio FM-Master WLAN (optional).

•This manual does not contain a description of the connection and operation of EGC. For information please contact your specialist dealer

or OASE.

Important: Moisture at the connections can damage the pump.

•Only remove the protection caps for connecting the EGC lines.

•Ensure that the rubber seals are clean and fit exactly.

•Replace damaged rubber seals.

Switch for switching on/switching off the Dynamic Function

Properties

•Excellent delivery rates meeting the requirements of demanding filter systems and large water courses and waterfalls.

•Can deal with coarse debris with a particle size of up to 4 mm.

•Ergonomic handle for safe transport.

•Suitable for immersed or dry installation.

•Unique, patented frost protection: The pump is guaranteed to operate without damage at temperatures as low as

-20 °C.

•Suitable for swimming ponds and natural swimming pools (installed in an external pump chamber).

Dynamic Function

Different values for the pump flow rates are pre-programmed in the pump control system to allow a dynamic fountain

pattern with changing heights and diameters. When the Dynamic Function is activated, the pump is continuously con-

trolled with these values.

Intended use

Aquarius Eco Expert 22000/28000, referred to as "unit", may only be used as specified in the following:

•Pumping of normal water for creating fountains.

•Operate in accordance with instructions.

•Operation under observance of the permissible water quality. (→Water quality)

The following restrictions apply to the unit:

•Do not use in swimming ponds.

•Never use the unit to convey fluids other than water.

•Never run the unit without water.

•Do not use for commercial or industrial purposes.

•Do not use in conjunction with chemicals, foodstuff, easily flammable or explosive substances.

•Do not connect to the domestic water supply.

-EN -

Installation and connection

WARNING

Possible death or severe injury from hazardous electrical voltage!

•Prior to reaching into the water, isolate (switch off and disconnect) all units/devices used in the water.

•Isolate the device (disconnect from the power supply) before carrying out any work on it.

WARNING

Death or serious injuries from hazardous electrical voltage due to operation of this unit in a swimming pond.

•Never operate this unit in a swimming pond.

Operating the unit in the pond

C

•Never operate the pump in a swimming pond.

•Only operate the pump when it is below the water surface level.

•Only operate the pump with the filter basket fitted.

•Ensure that the pump is in a secure and stable position.

NOTE

If the pump is used for conveying excessively soiled water, the impeller unit will be subject to increased wear

and will require earlier replacement.

Remedy:

•Thoroughly clean the pond or pool before installing the pump.

•Install the pump approx. 200 mm above the floor of the pond to avoid excessively soiled water from being

drawn into the pump.

How to proceed:

E

1. Screw the stepped hose adapter including union nut and sealing ring to the outlet.

2. Slip the hose clip over the hose, fit the hose onto the hose connector and secure with the hose clip.

Install the unit at a dry place

D

•Swimming pond or pool that may be accessed by people.

– Install the unit at least 2 m away from the water.

•Do not expose the unit to direct sunlight.

•Ensure that the pump is in a secure and stable position.

How to proceed:

F

1. Remove the screws for fastening the filter basket and remove the filter basket.

2. Screw the hose connector with union nut and seal onto the inlet.

3. Slip the hose clip over the hose, fit the hose onto the hose connector and secure with the hose clip.

4. Screw the hose connector with union nut and seal onto the outlet.

5. Slip the hose clip over the hose, fit the hose onto the hose connector and secure with the hose clip.

6. Fasten the pump to a suitable base using screws (not included in the scope of delivery).

NOTE

Recommendations for hoses and pipes:

•Use 50 mm (2 ") hose connectors and hoses for a length of up to 5 m.

•Use DN 75 or DN 100 pipes for a length greater than 5 m.

-EN -

Commissioning/start-up

NOTE

Sensitive electrical components. Incorrect connection will destroy the unit.

•Do not connect the unit to a dimmable power supply.

When started up, the pump automatically performs a pre-programmed self-test of approx. two minutes length (Envi-

ronmental Function Control (EFC)). The pump detects if it is running dry / blocked or submerged. The pump

switches off automatically after approx. 90 seconds if it runs dry (is blocked). In the event of a malfunction, disconnect

the power supply and flood the pump or remove the obstacle. Following this, the unit can be restarted.

Switching on: Connect the unit to the mains. The unit switches on immediately.

Switching off: Disconnect the unit from the mains.

Dynamic Function

How to proceed:

G

•Slide the switch.

– ON: The function is activated.

– OFF: The function is deactivated.

NOTE

When the Dynamic Function is activated, the function of the EFC (Environmental Function Control) is limited.

•The unit is not protected from running dry.

Remedy of faults

Malfunction

Cause

Remedy

Pump does not start

No mains voltage

−Check the mains voltage

−Check supply lines

Pump does not deliver

Filter housing clogged

−Clean

Excessively soiled water

−Clean pump. The pump automatically

switches on again once the motor has

cooled down.

Impeller unit blocked

−Disconnect the power supply and remove

obstacle. Then switch the pump on again.

Insufficient delivered quantity

Filter housing clogged

−Clean

Excessive loss in the supply lines

−Select larger hose diameter

−Reduce hose length to reduce frictional

loss

−Avoid unnecessary connection elements

Pump switches off after a short running period

Excessively soiled water

−Clean pump. The pump automatically

switches on again once the motor has

cooled down.

Water temperature too high

−Note maximum water temperature of

+35°C. The pump automatically switches

on again once the motor has cooled down.

Impeller unit blocked

−Disconnect the power supply and remove

obstacle. Then switch the pump on again.

Pump has run dry.

−Flood pump. Fully submerge the unit when

operated in the pond.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Oase Wasserpumpe Handbücher

Oase

Oase ProfiClear Premium Fleece 500 Bedienungsanleitung

Oase

Oase USP Classic 200 Bedienungsanleitung

Oase

Oase ProfiClear Premium TF-L Pump Fed EGC Bedienungsanleitung

Oase

Oase Aquarius Fountain Set Eco Leitfaden

Oase

Oase ProMax Pressure Automatic 5500/5 Bedienungsanleitung

Oase

Oase AquaOxy 2500 Leitfaden

Oase

Oase OptiMax 85i Bedienungsanleitung

Oase

Oase AquaMax Eco 5000 Bedienungsanleitung

Oase

Oase AquaMax Eco Series Bedienungsanleitung

Oase

Oase Aquamax 2000 Bedienungsanleitung

Oase

Oase AquaMax Eco Premium 4000 Bedienungsanleitung

Oase

Oase BioSmart 5000 Bedienungsanleitung

Oase

Oase Aquarius Eco Expert Bedienungsanleitung

Oase

Oase AquaMax Eco Twin 20000 Bedienungsanleitung

Oase

Oase AquaOxy 250 Bedienungsanleitung

Oase

Oase Aquarius Universal 4000 Bedienungsanleitung

Oase

Oase AquaMax Eco Expert 21000 Bedienungsanleitung

Oase

Oase Aquarius 1500 Bedienungsanleitung

Oase

Oase Profimax 7000 Wartungs- und Serviceanleitung

Oase

Oase Varionaut 2/DMX/02 Bedienungsanleitung

Oase

Oase Aquarius Universal Classic 440 Bedienungsanleitung

Oase

Oase Nautilus 50 Bedienungsanleitung

Oase

Oase Biotec 12 Bedienungsanleitung

Oase

Oase AquaAir 250 LM Bedienungsanleitung

Beliebte Wasserpumpe Handbücher anderer Marken

Neptun

Neptun NPHW 5500 Bedienungsanleitung

Sensidyne

Sensidyne Gilian BDX-II Montage- und Bedienungsanleitung

Draper

Draper 47808 Bedienungsanleitung

Trolla

Trolla 12820 Bedienungsanleitung

Sunfab

Sunfab SVH Series Bedienungsanleitung

WilTec

WilTec 50740 Bedienungsanleitung

Fieldmann

Fieldmann FVC 5015 EK Bedienungsanleitung

Everbilt

Everbilt EFSUB5-122HD Bedienungsanleitung

Graco

Graco Husky 3300e Bedienungsanleitung

esotec

esotec 101018 Bedienungsanleitung

Becker

Becker BASIC VASF 2.80/1-0.AC230 Bedienungsanleitung

Sykes AmeriPumps

Sykes AmeriPumps GP100M Fehlerbehebungshandbuch

DUROMAX

DUROMAX XP WX Series Bedienungsanleitung

BRINKMANN PUMPS

BRINKMANN PUMPS SBF550 Bedienungsanleitung

Franklin Electric

Franklin Electric IPS Bedienungsanleitung

Xylem

Xylem e-1532 Series Bedienungsanleitung

Milton Roy

Milton Roy PRIMEROYAL Bedienungsanleitung

STA-RITE

STA-RITE ST33APP Bedienungsanleitung