Oki B710dn Bedienungsanleitung

1

B7 00 S erie s 200 K Pag e

Ma in te na n ce K it I ns tr uc ti on s

The following document outlines the procedures to install the fuser assembly, BTR roller,

and retard roller assemblies included in the B710/720 and the B730 200K page

maintenance kits.

B710/720 Kit Part Number - 58284203 B730 Kit Part Number - 58284204

Fuser Replacement Procedure

Removing the Old Fuser Assembly:

NOTE: If the unit was recently running please turn off and allow 30 minutes for the fuser

to cool down before starting the replacement procedure. Fuser gets extremely HOT.

1. If there is a duplexer installed on the unit press button to release the duplexer

assembly and drop into an open position.

2. Squeeze the two tabs to open the rear cover.

3. Push down on both of the orange tabs to release and remove the fuser.

2

Installing the New Fuser Assembly

1. Line up the connector on the fuser with the connector on the printer and insert the

new fuser.

Fuser Connector Printer Connector

2. Lock the Fuser in position by pushing up on the orange tabs.

3

B710 B720 and B730 Fuser Counter Reset Procedure

-Instructions for Resetting the Maintenance Counters-

First, enter the diagnostic mode in order to do a maintenance counter

reset.

To enter the Diagnostics area:

Turn the printer power OFF.

Press and Hold the MENU^ and Enter buttons.

Turn the printer power ON (you can release these buttons as soon as “loading … ’’ is

displayed.

The Operator Panel reads “Diagnostics”

There is a list of Test Options and settings.

Press the Down Arrow highlight “Maintenance Info.” Press the Enter button

The Operator Panel Display reads “Maintenance Info” with setting listed.

Reset Maintenance reqd. is highlighted. Press Enter

Reset Maint. Reqd. is displayed and Execute is highlighted.

Press Enter.

The Display reads --

Resetting

Maintenance Required.

This completes the process.

4

Replacing the Retard Rollers

1. Gently push the notch on the tab away from the groove in the shaft.

2. While holding the tab clear of the shaft move the roller toward the groove in to

remove.

3. Repeat the procedure to remove the rollers at all three locations shown below.

150 Paper Cassette Assembly

5

150 Feeder Assembly

550 Feeder Assembly

550 Paper Cassette

6

Installing the new Retard Rollers

1. Install the roller by aligning the shaft with the opening in the roller and push the roller

over the groove in the shaft until the notch on the tab locks into place.

7

BTR Kit Instructions

The following document outlines the procedures to install the new BTR assembly.

Red circle shows fuser location, BTR assembly located directly under fuser. Note: Before removing

the BTR roller, open the top access cover, and remove print cartridge.

1. Reach inside through the top and squeeze the left side tabs of the BTR and pull out.

2. Now squeeze the right side tabs and pull out.

3. Now grab from the center of the BTR and remove it through the top of the printer.

Final Step:

4. Install the new BTR assembly. When installing the new BTR, the gear should be

on the right side when facing the rear of the printer.

8

59412901

© 2012 OKI Data Americas, Inc.

Andere Handbücher für B710dn

4

Dieses Handbuch passt für folgende Modelle

4

Inhaltsverzeichnis

Andere Oki Druckerzubehör Handbücher

Oki

Oki C9200 Bedienungsanleitung

Oki

Oki LP441s Bedienungsanleitung

Oki

Oki CCS Copier Unit Bedienungsanleitung

Oki

Oki B710dn Montageanleitung

Oki

Oki C7300 Bedienungsanleitung

Oki

Oki 4336822A Bedienungs- und Wartungshandbuch

Oki

Oki C9600hdn Bedienungsanleitung

Oki

Oki KN-4530 Bedienungsanleitung

Oki

Oki KN-4530 Bedienungsanleitung

Oki

Oki C3200n Bedienungsanleitung

Oki

Oki B 4600n Bedienungsanleitung

Oki

Oki C3200n Bedienungsanleitung

Oki

Oki C9300 Series Bedienungsanleitung

Oki

Oki B4200 Bedienungsanleitung

Oki

Oki C9300 Series Bedienungsanleitung

Oki

Oki OKIPAGE18 Bedienungsanleitung

Oki

Oki C3200n Bedienungsanleitung

Oki

Oki 70037301 Bedienungsanleitung

Oki

Oki T400 Bedienungsanleitung

Oki

Oki OKIPOS X400 Bedienungsanleitung

Oki

Oki ML520n Bedienungsanleitung

Oki

Oki ML520n Bedienungsanleitung

Oki

Oki MPS4200mb Bedienungs- und Wartungsanleitung

Oki

Oki OKIPOS X400 Bedienungsanleitung

Beliebte Druckerzubehör Handbücher anderer Marken

Star Micronics

Star Micronics TSP800 Series Bedienungsanleitung

REA

REA JET HR pro 2K Bedienungsanleitung

HP

HP Laserjet,Color Laserjet 4si Bedienungsanleitung

oliser

oliser MS 45 Bedienungsanleitung

Roland

Roland DU2-64 Anleitungen und Rezepte

Xerox

Xerox EFI EXP6000 Bedienungsanleitung

Canon

Canon Finisher-T1 Bedienungsanleitung

Sharp

Sharp FO-1MK Bedienungsanleitung

Labelmate

Labelmate PM-300 Bedienungsanleitung

Epson

Epson T6248 Betriebsanleitung

Epson

Epson OT-BZ20 Bedienungsanleitung

Canon

Canon TonerRobot EP-27 Bedienungsanleitung

Ricoh

Ricoh LCIT RT5100 Kurzanleitung

GBC

GBC 16 Series Bedienungsanleitung

Canon

Canon INNER 2-WAY TRAY-E1 Bedienungs- und Wartungshandbuch

Develop

Develop SD-509 Bedienungsanleitung

Kyocera

Kyocera KM-6230 Handbuch

Triumph Adler

Triumph Adler DF-710 Handbuch