Olympia electronics GR-8/leds Bedienungsanleitung

GENERAL

These luminaires are used indoors (ta 40 C)

on the wall, where emergency light is needed.

Each luminaire must be permanently

connected to mains power supply. In normal

operation the illumination LEDs are lit as well

as the green indicating charge LEDs, when

the battery is charging.

In case of a mains power supply failure the

luminaire will light the led strip automatically

in emergency mode. When the mains power

supply is restored the device turns to normal

operation.

Non Maintained / maintained operation

there is an option to select the non maintained

or maintained operation by placing the jumper

to the appropriate place according to the

figure 3 (see page 2).

INSTALLATION

To install the luminaire follow the installation

instructions on page 2.

ΑΤΤΕΝΤΙΟΝ!!!

1. Operations for installation, maintainance or

testing must be done by authorized personnel

only.

2. The device must be connected to the

mains power supply through a fuse dependent

by the total amount of the line’s power load.

3. It is suggested to check every month the

indication LED for battery charging, and by

pushing the TEST button to check the

emergency circuit. The led strip should light as

long as the TEST button is pressed. If the

luminaire doesn’t work as described above

contact the installer.

4. It is suggested to check every 6 months the

m i n i m u m a u t o n o n o u s d u r a t i o n b y

disconnecting the mains power supply. Count

the time that the led strip lights and in case of

less time than the nominal autonomy, the

battery must be replaced. If the measured time

is c ons i dera bly l ess t han t he no mina l

autonomy In case of contact the installer.

battery or led strip replacement, these must be

replaced by parts of the same type, by the

manufacturer or by a competent person.

5. In case of inactive use for a period greater

than 2 months, disconnect the battery by

pulling out the battery’s connector.

6. I s not allowed to discard batteries in to t i

common trash bins, they must be

discarded only in battery recycling

points. Do not incinerate.

The light source contained in this

luminaire shall only be replaced by the

manufacturer, or his agent, or a similar

qualified person.

NOTE! The light source is non-user

replaceable.

NON MAINTAINED / MAINTAINED EMERGENCY LUMINAIRES

923378005_09_008

Page 1 from 3

OPERATION TEMPERATURE RANGE

RELATIVE HUMIDITY

EXTERNAL DIMENSIONS

CONSTRUCTION MATERIALS

TYPICAL WEIGHT

GUARANTEE

OPERATION VOLTAGE

MAXIMUM POWER CONSUMPTION

BATTERIES (Ni-Cd)

CHARGING TIME

INDICATIONS - CONTROLS

MINIMUM AUTONOMOUS DURATION

DEGREES OF COVER PROTECTION

PRODUCED IN ACCORDANCE WITH

ILLUMINATION (230V AC / emergency)

ILLUMINATION SOURCE

1.5 h 3 h

24 h

Battery charge indication LEDs, TEST button

IP 42

12 white LEDs

EN 60598-1, EN 60598-2-22, ΕΝ 55015, ΕΝ 61547, ΕΝ 61000-3-2, ΕΝ 61000-3-3

5 to 40 C

Up to 95%

Bayblend FR3010, transparent polycarbonate

3 years (1 year for the battery)

240 x 90 x 44 mm

345gr.

220-240VAC/50-60Hz

350gr.

GR-8/leds GR-9/leds

3.6V/0.6Ah 3.6V/1Ah

2.7W/3VA 3W/3.5VA

40lm / 100lm 38lm / 100lm

TECHNICAL CHARACTERISTICS (for led module spcifications see page 2)

Thank you for your trust in our products.

Olympia Electronics - European manufacturer.

923378005_09_008923378005_09_008 Page 3 from 3Page 2 from 3

Figure 1 Diffusor

Reflector

Plastic base

Battery replacement.

It can be done only by a competent person and after the mains interruption.

1. Dismantle the device (step 1 of the installation instructions).

2. Disconnect the connector and remove the old battery.

3. Connect the new battery with the same type (step 4 of the installation instructions) and place it in

the position of the old one.

4. Follow the step 6 of the installation procedure and power the device.

Installation instructions (wall mounting)

1. To install the device you have to dismantle it carefully with a flat screwdriver as shown on figure 1.

2. Pass the mains cables through the hole (point 1 in figure 2) and secure it with a suitable bracket to

ensure immobilization of the cable at a distance of no more than 5cm from the luminaire’s cable

entry. ATTENTION!! To maintain the IP rating, the outer diameter of the power cable must be at

least 8.2 mm².

3. Mount the base plastic on the wall using the included mounting accessories in points 2 and 3 as

shown on figure 2.

4. Connect the battery`s cable with the appropriate terminal (figure 3).

5. Connect the mains cables to the terminal block as shown on figure 4.

6. Refit carefully the removed plastic parts and power on the luminaire.

NOTE!!

After finishing the installation you must power the luminaire at least for 24 hours for battery

charging to perform the nominal autonomy.

Figure 4

For fuse ratings

see text

LED MODULE CHARACTERISTICS

Manufacturer

Model Number

Voltage Range

Connections

Nominal Power

Temperature (tc)

Olympia Electronics S.A

45 °C max. across the board

Non reversible connection between main pcb and led module

2.9-3.6VDC

780mW

2501159

GR-8/leds GR-9/leds

(*) Maintained operation: The luminaire lights its

illumination source, when it is powered by the mains

power supply or not.

Non Maintained operation: The luminaire lights its

illumination source, only in power supply’s failure.

Note!! The installer should fill in, on the specification label,

the letter G if the luminaire is used as a safety sign.

X19

*0A G

NOTE: LED= Light Emitting Diode

LABELING EXPLANATION:

X: Self contained

1: Maintained (*)

A: Including test device

G: Internally illuminated

*90: 1.5 hour duration

180: 3 hours duration

WARRANTY

Olympia Electronics guarantees the quality, condition and operation of the goods. The period of

warranty is specified in the official catalogue of Olympia Electronics and also in the technical leaflet,

which accompanies each product. This warranty ceases to exist if the buyer does not follow the

technical instructions included in official documents given by Olympia Electronics or if the buyer

modifies the goods provided or has any repairs or re-setting done by a third party, unless Olympia

Electronics has fully agreed to them in writing. Products that have been damaged can be returned to

the premises of our company for repair or replacement, as long as the warranty period is valid.

Olympia Electronics reserves the right to repair or to replace the returned goods and to or not charge

the buyer depending on the reason of defection. Olympia Electronics reserves the right to charge or

not the buyer the transportation cost.

HEAD OFFICE

72nd km. O.N.R. Thessaloniki-Katerini

P.C. 60300 P.O. Box 06 Εginio Pierias Greece

www.olympia-electronics.gr

[email protected]

Figure 2

Figure 3

Non maintained

operation

Maintained

operation

Cable

support

Dieses Handbuch passt für folgende Modelle

Andere olympia electronics Laterne Handbücher

olympia electronics

olympia electronics GR-470 Bedienungsanleitung

olympia electronics

olympia electronics GR-796/ST/DUO/ADR Bedienungsanleitung

olympia electronics

olympia electronics GR-2100/ST Bedienungsanleitung

olympia electronics

olympia electronics CLASSIC LIGHT Series Bedienungsanleitung

olympia electronics

olympia electronics Double Easy Light GR-391/L Bedienungsanleitung

olympia electronics

olympia electronics WEATHER LIGHT Series Bedienungsanleitung

olympia electronics

olympia electronics POWER LIGHT Series Bedienungsanleitung

olympia electronics

olympia electronics Power Light Series Bedienerhandbuch

olympia electronics

olympia electronics GR-579/L/90/WP Bedienungsanleitung

olympia electronics

olympia electronics BAU LIGHT Series Bedienungsanleitung

olympia electronics

olympia electronics BAU LIGHT Series Bedienungsanleitung

olympia electronics

olympia electronics GR-220/DUO/M Bedienungsanleitung

olympia electronics

olympia electronics WEATHER LIGHT Series Bedienungsanleitung

olympia electronics

olympia electronics OLY-1024/WL Bedienungsanleitung

olympia electronics

olympia electronics WATERPROOF POWER LIGHT Series Bedienungsanleitung

olympia electronics

olympia electronics GR-8/leds Bedienungsanleitung

olympia electronics

olympia electronics OLY-500 Bedienungsanleitung

olympia electronics

olympia electronics GRL-37/90/ADR Bedienungsanleitung

olympia electronics

olympia electronics GR-2110 Bedienungsanleitung

olympia electronics

olympia electronics GRL-29 WP Bedienungsanleitung

olympia electronics

olympia electronics GR-427/12L/MAR Bedienungsanleitung

olympia electronics

olympia electronics GR-290 Bedienungsanleitung

olympia electronics

olympia electronics SLIM LIGHT Series Bedienungsanleitung

olympia electronics

olympia electronics SLD-28/DZ Bedienungsanleitung

Beliebte Laterne Handbücher anderer Marken

KYOWA

KYOWA KW-9114 Bedienungsanleitung

Stahl

Stahl ECOLUX 6610 Series Bedienungsanleitung

SNOWJOE

SNOWJOE SUNJOE 24V-LGT500-CT Bedienungsanleitung

PRG

PRG VARI LITE VL5 Bedienungsanleitung

Raytec

Raytec VARIO2 series Bedienungsanleitung

ENSA

ENSA LEDBT18WS2 Bedienungsanleitung

LUG

LUG OFFICE LB LED N/T Bedienungsanleitung

GE Wallighter 250 Bedienungsanleitung

Draper

Draper RLEDL19/B Bedienungsanleitung

Green Lighting

Green Lighting TRI-SENSOR GL4612LU Bedienungsanleitung

Panasonic

Panasonic EY3741B57 Bedienungsanleitung

Clas Ohlson

Clas Ohlson LCC8T Bedienungsanleitung

Coolon

Coolon WDN-140 Bedienungsanleitung

Holiday Travel

Holiday Travel 834873 Bedienungsanleitung

BEGA

BEGA 84 036 Bedienungsanleitung

BEGA

BEGA 33 596 Bedienungsanleitung

Dale Tiffany

Dale Tiffany GT701162 Bedienungsanleitung

Wagan

Wagan Brite Nite Pop-Up USB Lantern Bedienungsanleitung