1. GENERAL
The manual is a part of the scope of supply and serves to ensure proper handling and
optimum functioning of the instrument. For this reason, the manual must be read before
start-up.
In addition, the manual is for all personnel who require knowledge concerning transport,
setup, operation, maintenance and repair.
The manual must not be used for the purpose of competition without a written consent
from Pall and must also not be forwarded to third parties.
Copies for personal use are permitted.
All information, technical data and illustrations contained in these instructions are based
on information available at the time of publication.
1.1 Symbol assertion
This symbol indicates a safety instruction.
These safety instructions should always be followed carefully.
By not following these instructions injuries of persons or material damage
could happen.
Pall does not accept liability in the event of these
safety instructions being ignored.
This symbol indicates a note.
These notes should be observed to achieve optimum functioning
of the equipment.
1.2 Safety instructions
General Safety Instructions
• Excessive mechanical loads and incorrect usage should always
be avoided.
• In general, work on live components should be avoided and
when absolutely necessary should be performed by qualified
personnel only.
• Installation, electrical connection, maintenance and commissioning
should be performed by qualified personnel only.
Safety instructions for use of the alarm module
with voltages >50V
• To insulate the optional relay connections from the low-voltage side of
the water sensor, the partition provided for this purpose must be fitted
in the lower section.
• During operation of the instrument the modular housing must be
completely closed.
• The protection class of an opened housing corresponds to IP00 and
direct contact with components carrying dangerous voltages is therefore
possible. In general, work on live components should be avoided and
when absolutely necessary, should be performed by qualified personnel
only.
1.3 Disposal of Equipment
At the end of its life, the Water Sensor should be dismantled and disposed
of in accordance with all applicable local waste disposal laws and bylaws.
Where facilities exist, component parts of the unit may be recycled.
Details of the materials of construction are given on the product installation
drawing and if required, more detailed information regarding specific
items may be obtained from Pall or an approved agent.
If component parts of the equipment were previously contaminated with
the service fluid, an appropriate Manufacturer’s Safety Data Sheet (MSDS)
for the fluid should be obtained and read to ensure that contaminated
component parts are disposed of safely. Pall Europe Ltd., will meet it’s
obligations under the EU Directive on Waste Electrical and Electronic
Equipment (WEEE).
Hardware 4
instruction booklet
Pall WS08 Series
Water Sensor
