Panasonic Diga DMR-EZ27 Gebrauchs- und Pflegehandbuch

DMR-EZ27 Firmware Installation Instructions

Table of Contents

Table of Contents ..............................................................................................1

1Firmware History.............................................................................................. 2

1.1 Applicable Models ........................................................................................ 2

1.2 Purpose...................................................................................................... 2

2Download Firmware ......................................................................................... 3

3Burn Firmware.................................................................................................. 4

3.1 Windows® OS CD Writing Program ................................................................ 4

3.2 Other OS CD Writing Program........................................................................ 5

3.3 3rd Party CD Burning Software ....................................................................... 5

3.4 Dragging & Dropping.................................................................................... 6

4Install Firmware............................................................................................... 7

DMR-EZ27 DVD Recorder Firmware Installation Instructions

Page 1 of 8

1Firmware History

1.1 Applicable Models

DMR-EZ27

Includes models with suffix K or S

1.2 Purpose

U8-225

•Improved playback DVD+R media which was recorded by SONY DVD Recorder.

•Optimization of track jump control for CD-RW.

•Improvement of recording quality for DVD-R DL.

U8-217

•Enhances Closed Captioning display.

•Enables the unit to the download the New V-Chip/Regional Rating Table (RRT).

U8-201

•ATSC level meter indication improvement with weak signal.

•Stops disc rotation when the [EJECT] button is pressed.

U8-196

•Countermeasure for occurred aging mode by remote control signal.

•Protection for Drive unit fuse blowing due to customer Disc condition.

•Upgrade program for next generation drive.

U8-190

•When recording program of 5.1 ch Audio, the center channel audio is not output.

•The title information of the recorded program is not displayed correctly.

U8-184

•Hang-up sometimes occurs using JPEG of RAM disc on "Direct Navigator".

•"Copying has been stopped" message is displayed on the "Status".

•"oooooo" is indicated continuously on power off after malfunction occurs.

•DVD-Video is played back on indication of "oooooo" after power off using EZ-Sync.

DMR-EZ27 DVD Recorder Firmware Installation Instructions

Page 2 of 8

2Download Firmware

1) Left click on the DOWNLOAD icon for the DMR-EZ27 DVD Recorder Firmware.

- DMR-EZ27 DVD Recorder Firmware

2) Left click on SAVE.

The file name displayed should be

PANA

DVD.FRM.

3) Left click on DESKTOP, and then left click on SAVE.

NOTE: The PANA_DVD.FRM file will be placed on the DESKTOP.

DMR-EZ27 DVD Recorder Firmware Installation Instructions

Page 3 of 8

3Burn Firmware

Use one of the below procedures to burn the firmware to a CD-R disc.

3.1 Windows®OS CD Writing Program

1) Insert a blank CD-R disc into a CD Burner Drive installed in or attached to the computer.

2) If the below (or similar) screen appears (Windows XP), left click on CANCEL.

3) Right click on the PANA_DVD.FRM file on the DESKTOP, mouse over SEND TO, and

then left click on the CD BURNER DRIVE.

4) If the below screen appears, left click on YES.

NOTE: The below screen may appear momentarily.

DMR-EZ27 DVD Recorder Firmware Installation Instructions

Page 4 of 8

5) Lift click on the YOU HAVE FILES WAITING TO BE WRITTEN TO THE CD icon in the

SYSTEM TRAY.

6) Left click on WRITE THESE FILES TO CD.

7) Type a name for the CD, check the CLOSE THE WIZARD AFTER THE FILES HAVE

BEEN WRITTEN check box, and then left click on NEXT.

NOTE: The below screen will appear during the burning process.

8) After the PANA_DVD.FRM file has been burned to the CD, the disc should automatically

eject from the CD Burner Drive. If it doesn’t, manually eject the disc.

3.2 Other OS CD Writing Program

Refer to the computer’s owner’s manual or HELP files for instructions on how to copy the

PANA_DVD.FRM to a CD-R using the ISO-9660 format.

3.3 3rd Party CD Burning Software

Refer to the software application’s owner’s manual or HELP files for instructions on how to

copy the PANA_DVD.FRM to a CD-R using the ISO-9660 format.

DMR-EZ27 DVD Recorder Firmware Installation Instructions

Page 5 of 8

3.4 Dragging & Dropping

If an icon for the CD Burner Drive has been placed on the DESKTOP, left click on the

firmware file, hold the left mouse button down, drag the file to the CD Burner Drive icon and

release the left mouse button.

If using the Windows XP operating system, use procedure from STEP 5 of SECTION 3.1 on

PAGE 5 of 8.

DMR-EZ27 DVD Recorder Firmware Installation Instructions

Page 6 of 8

4Install Firmware

CAUTION: Do not turn the DVD Recorder OFF or press any buttons on the DVD

Recorder while the firmware update is in progress.

1) Power the DVD Recorder on.

2) Press the [OPEN/CLOSE] button to OPEN the disc tray.

3) Place the CD-R with the firmware update into the disc tray with the label side facing up.

4) Press the [OPEN/CLOSE] button to CLOSE the disc tray.

NOTE: If the firmware version in the unit is the same or higher than the firmware

CD, UNSUPPORT may be displayed on the front panel. In this case, an update is

unnecessary. Please remove the disc.

NOTE: If the firmware update will be installed, BYE will display on the front panel,

the DVD Recorder will power off, and then power back on.

NOTES:

•Several messages will be displayed on the front panel during the firmware

update.

•When the firmware update is complete, the disc tray will automatically OPEN.

5) Remove the CD-R with the firmware update from the disc tray.

6) Without closing the disc tray, press the [POWER] button on the DVD Recorder to power

the unit off. The disc tray will CLOSE automatically, display BYE,and then power off.

7) Unplug the power cord for at least 30 seconds, and then plug the power cord back in.

8) Press the [POWER] button on the DVD Recorder to power the unit on. (The unit will

display HELLO and then begin the FIRST TIME SETUP.)

NOTE: If the unit does not begin the FIRST TIME SETUP automatically, it is

recommended to initiate the FIRST TIME SETUP.

•Tune the DVD Recorder to a channel.

•Simultaneously press the [CHANNEL UP] and [CHANNEL DOWN] buttons on the

front of the DVD Recorder for approximately 10 – 15 seconds (until the unit powers

off).

DMR-EZ27 DVD Recorder Firmware Installation Instructions

Page 7 of 8

•When the DVD Recorder is powered back on, the FIRST TIME SETUP screen should

be displayed.

9) Follow the on-screen prompts to complete the FIRST TIME SETUP.

DMR-EZ27 DVD Recorder Firmware Installation Instructions

Page 8 of 8

Andere Handbücher für Diga DMR-EZ27

Inhaltsverzeichnis

Andere Panasonic DVD-Recorder Handbücher

Panasonic

Panasonic DMR-ES45VP Bedienungsanleitung

Panasonic

Panasonic DMR-ES25P Bedienungsanleitung

Panasonic

Panasonic Diga DMR-EX79EB Bedienungsanleitung

Panasonic

Panasonic Diga DMR-EZ17 Bedienungsanleitung

Panasonic

Panasonic DMR-EH63 Bedienungsanleitung

Panasonic

Panasonic WJHD220 - DIGITAL DISK RECORDER Bedienungsanleitung

Panasonic

Panasonic DMR-EH57EC Bedienungsanleitung

Panasonic

Panasonic DMR-EZ47VP Bedienungsanleitung

Panasonic

Panasonic DIGA DMR-ES15 Bedienungsanleitung

Panasonic

Panasonic Diga DMR-EZ28 Bedienungsanleitung

Panasonic

Panasonic Diga DMR-ES20 Bedienungsanleitung

Panasonic

Panasonic DMR-EZ28K Bedienungsanleitung

Panasonic

Panasonic DMR-EX97C Bedienungsanleitung

Panasonic

Panasonic DMR-EH55EE Bedienungsanleitung

Panasonic

Panasonic DIGA DMR-ES15 Bedienungsanleitung

Panasonic

Panasonic DMR-EH50EB Bedienungsanleitung

Panasonic

Panasonic Diga DMR-EX79 Bedienungsanleitung

Panasonic

Panasonic Diga DMR-EZ47 Bedienungsanleitung

Panasonic

Panasonic DMREA38V - DVD RECORDER - MULTI LANGUAGE Bedienungsanleitung

Panasonic

Panasonic Diga DMR-EX99V Bedienungsanleitung

Panasonic

Panasonic Diga DMR-ES15EBL Bedienungsanleitung

Panasonic

Panasonic Diga DMR-EH65 Bedienungsanleitung

Panasonic

Panasonic Diga DMR-EX97 Bedienungsanleitung

Panasonic

Panasonic Diga DMR-EX79 Bedienungsanleitung

Beliebte DVD-Recorder Handbücher anderer Marken

Pioneer

Pioneer DVR-65H-S Einrichtungshandbuch

Sony

Sony RDR-VX525 - DVDr/ VCR Combo Bedienungsanleitung

Daewoo

Daewoo DHD-4000D Bedienungsanleitung

Medion

Medion MD 40570 Bedienungsanleitung

Philips

Philips ShowView DVDR3460H Bedienungsanleitung

Sony

Sony RDR-GX355 - Tunerless DVD Recorder Bedienungsanleitung

Sony

Sony DVDirect VRD-MC3 Bedienungsanleitung

Samsung

Samsung DVD-R130/XAA Bedienungsanleitung

FUNAI

FUNAI HD-B2735 Bedienungsanleitung

Pioneer

Pioneer PRV-LX1 Technisches Handbuch

Sanyo

Sanyo DRW-1000 Bedienungsanleitung

Philips

Philips DVDR610/05 Bedienungsanleitung

JVC

JVC DR-M10 Bedienungsanleitung

Samsung

Samsung SV-DVD40 Bedienungsanleitung

Philips

Philips DVDR3355 Bedienungsanleitung

FUNAI

FUNAI FDR-90E Bedienungsanleitung

LG RC298 Bedienungsanleitung

Samsung

Samsung DVD-R130 Bedienungsanleitung