Panasonic CQ-C3503N Bedienungsanleitung
ORDER NO.ACED060112C8
AUTOMOTIVE AFTERMARKET
CQ-C3503N / CQ-C3303N
MP3 CD Player/Receiver
SPECIFICATIONS
Specifications*
General
Power Supply DC 12V (11V - 16V),
Test Voltage 14.4V
Negative Ground
Current Consumption Less than 2.1A (CD mode ; 0.5W
4-channels)
Maximum Power Output 50W×4 (at 4 )
Power Output 22W×4 (DIN45 324, at 4 )
Tone Adjustment Range Bass ; ±12dB at 100Hz
Treble ; ±12dB at 10kHz
Speaker Impedance 4-8
Pre-Amp Output Voltage 2.5V (CD mode)
Pre-Amp Output Impedance 200
Front AUX Input
Input Impedance 10k
Allowable External Input 2.0V
Connector 3.5mm Stereo mini-pin
FM Stereo Radio
Frequency Range 87.5MHz - 108MHz
Usable Sensitivity 6dB/ V (S/N 30dB)
Stereo Separation 35dB (at 1kHz)
1
AM (MW) Radio
Frequency Range 531kHz - 1,602kHz
Usable Sensitivity 27dB/ V (S/N 20dB)
AM (LW) Radio
Frequency Range 153kHz - 279kHz
Usable Sensitivity 32dB/ V (S/N 20dB)
CD Player
Sampling Frequency 8 Times Oversampling
DA Converter 1bit DAC System
Pick-Up Type Astigma 3-beam
Light Source Semiconductor Laser
Wave Length 790nm
Frequency Response 20Hz to 20kHz (±1dB)
Signal to Noise Ratio 93dB
Total Harmonic Distortion 0.01% (1kHz)
Wow and Flutter Below measurable limits
Channel Separation 75dB
Dimensions** 178×50×160mm
Weight** 1.4kg
* Specifications and the design are subject to possible
modification without notice due to improvements.
** Dimensions and Weight shown are approximate.
-Above specifications comply with EIA standards.
2006 Matsushita Electric Industrial Co., Ltd. All rights reserved.
Unauthorized copying and distribution is a violation of law.
1. ABOUT LEAD FREE SOLDER (PbF)
Distinction of PbF PCB:
PCBs (manufactured) using lead free solder will have a PbF stamp on the PCB.
Caution :
2
- Pb free solder has a higher melting point than standard solder; Typically
the melting point is 50 - 70°F (30 - 40°C) higher. Please use a soldering
iron with temperature control and adjust it to 700 ± 20°F (370 ± 10°C). In
case of using high temperature soldering iron, please be careful not to
heat too long.
- Pb free solder will tend to splash when heated too high (about 1100°F/
600°C)
- This lead free solder will be used for the products after serial No.
1,000,001.
2. LASER PRODUCTS
3. FEATUERS
- Large-sized volume control.
- SQ (Sound Quality).
- SRS TruBass [CQ-C3503N].
- The AUX input terminal is equipped on the front panel.
- This manual is for 2 models CQ-C3503N and CQ-C3303N. The following
table describes the differences between 2 models.
3
4. REPLACING THE FUSE
Use fuses of the same specified rating (15amps). Using different substitutes or fuses with higher
ratings, or connecting the product directly without a fuse, could cause fire or damage to the stereo unit.
5. MAINTENANCE
Your product is designed and manufactured to ensure a minimum of maintenance. Use a dry, a soft
cloth for routine exterior cleaning. Never use benzine, thinner or other solvents.
6. NOTES
[RADIO BLOCK]
Do not align the AM/FM package block. When the package block is necessary, it will be supplied already
aligned at the factory.
[CD DECK BLOCK]
This model has no servo alignment points because microcomputer controls the servo circuit.
7. DIMENSIONS
8. WIRING CONNECTION
4
5
9. TERMINALS DESCRIPTION
9.1. Main Block
IC601 : YESAM356
Pin
No.
Port Description I/O (V)
FM AM CD
1 XIN Crystal oscillator I 2.5 2.5 2.5
2 TEST2 Ground I 0 0 0
3 VREG Bypass condenser
connected.
O 2.9 2.9 2.9
4VSSCPUGround - 0 0 0
5 NC - - - - -
6 NC - - - - -
7 NC - - - - -
8 NC - - - - -
9 LCD
DO
LCD data output I 5 5 5
10 LCD DI LCD data input O 4.9 5 4.9
11 LCD
CLK
LCD clock O 5.1 5.1 5.1
12 LCD CE LCD chip enable
output
O 0 0 0.3
13 CD DO CD data output I 5.1 5.2 4
14 CD DI CD data input O 0 0 4.6
15 CD
CLK
CD clock O 4.9 49 4.9
16 CD CE CD chip enable O 0 0 1
17 CD LM
(+)
CD loading motor
control
O 0 0 0
18 CD LM
(-)
CD loading motor
control
O 0 0 0
19 CD S/L CD spindle motor
control
O 5.1 5.1 5.1
20 SUB
READY
Sub CPU ready
signal
I 0 0 5
21 CD
INSW1
CD insert SW input I 0 0 0
22 CD
SW2
CD mechanism
SW2
I 5.1 5.1 0
23 CD
LIMIT
SW
CD limit SW I 0.2 0.2 5.1
24 CD
MUTE
CD Mute signal I 5.1 5.1 5.1
25 CD RST CD reset O 5.1 5.1 5.1
26 CD
DMUTE
CD mute O 0 0 5.1
6
Pin
No.
Port Description I/O (V)
FM AM CD
27 LOW
BATT
Battery low level
detect
I 5.1 5.1 0
28 NC - - - - -
29 PANEL Panel detect switch I 0 0 0
30 NC - - - - -
31 NC - - - - -
32 NC - - - - -
33 NC - - - - -
34 NC - - - - -
35 TBASS TruBASS IC
contorol
O 0 0 0
36 NC - - - - -
37 NC - - - - -
38 NC - - - - -
39 VDD
PORT
Power supply (+5V) - 5.1 5.1 5.1
40 VSS
PORT
Ground - 0 0 0
41 NC - - - - -
42 NC - - - - -
43 NC - - - - -
44 NC - - - - -
45 NC - - - - -
46 NC - - - - -
47 NC - - - - -
48 NC - - - - -
49 PWR
CNT
Power on control O 4.9 5 5
50 AMP
CNT
Amp control signal O 5.1 5.1 5.1
51 AMP
MUTE
Power IC mute
signal
O 5.1 5.1 5.1
52 STBY Power IC standby
control
O 5.1 5.1 5.1
53 SSC Tuner search
sensitivity change
O 0 0 5.1
54 AF
MUTE
AF mute O 5.1 5.1 5.1
55 I2C
DATA
Electronic VOL
data
O 5.1 5.1 5.1
56 I2C
CLK
Electronic VOL
clock
O 5.1 5.1 5.1
57 NC - - - - -
58 POWER
LED
Power LED O 0 0 0
59 NC - - - - -
60 NC - - - - -
7
Pin
No.
Port Description I/O (V)
FM AM CD
61 NC - - - - -
62 NC - - - - -
63 OP/CL Panel open/close
signal
I - - -
64 EJECT Eject switch signal I 5.1 5.1 5.1
65 EJ ILL Eject LED drive
control
O 5.1 5.1 5.1
66 TEL
MUTE
Telephone mute
signal
I 5.1 5.1 5.1
67 BATT Battery detection I 5.1 5.1 5.1
68 MODE
B
Rotary encoder
input B
I 5 5 5
69 RDS
CLK
RDS clock I 2.4 2.4 2.4
70 RM
DATA
Remote control
data
I - - -
71 MODE
A
Rotary encoder
input A
I 5 5 5.1
72 NC - - - - -
73 NC - - - - -
74 MONO FM MONO signal O 0 0 0
75 AM
MODE
Radio AM mode
control
O 8.2 0 8.2
76 FM
MODE
Radio FM mode
control
O 0 8.2 0
77 LEVEL Audio signal input
for level meter
I 0 0 1.5
78 INIT C Initial setting port I 0 0 0
79 INIT B Initial setting port I 0 0 0
80 INIT A Initial setting port I - - -
81 VSSADCGround - 0 0 0
82 RDS
DATA
RDS data I 2.6 0 2.5
83 ST FM stereo signal I 5.1 5.2 5.2
84 SD FM/
AM
Radio signal
strength
I 0 0 0
85 NC Ground I 0 0 0
86 RESET Reset signal I 5 5 5
87 ACC ACC signal input I 5.3 5.3 5.3
88 NC Ground I 0 0 0
89 NC Ground I 0 0 0
90 FM/AM
IFC
FM/AM IF input I 1.4 1.3 1.3
91 NC - - - - -
92 NC - - - - -
93 VDDPLLPower supply of
PLL
- 5.1 5.1 5.1
8
Pin
No.
Port Description I/O (V)
FM AM CD
94 NC - - - - -
95 OSC
FM/AM
FM/AM osc input I 1.4 1.3 1.3
96 VSSPLL Ground - 0 0 0
97 NC - - - - -
98 EO1 PLL phase
comparison error
output
O 2.2 2.1 2.3
99 TEST1 Ground I 0 0 0
100 XOUT Crystal oscillator O 2.6 2.6 2.6
9.2. Display Block
IC901 : C0HBA0000195
Pin
No.
Port Description I/O (V)
1 GREEN
CNT
LED control (Green) O 0
2 RED CNT LED control (Red) O 4.9
3 -39 SEG3 -39 LCD segment data O 2.5
40 -43 COM1 -4 LCD common O 2.5
44, 45 SEG40,
41
LCD segment data O 2.5
46 -49 KS3-6 Key scan O 5.0
50 -54 Kl1-5 Key data I 0
55 TEST (Connecting to ground) - 0
56 VDD +5V power supply - 5.0
57 VDD1 VDD1 filter terminal - 3.3
58 VDD2 VDD2 filter terminal - 1.7
59 VSS Ground - 0
60 OSC Oscillator terminal - 3.8
61 DO Key data output O 5.0
62 CE LCD driver chip enable I 0.3
63 CLK LCD clock I 5.1
64 DI LCD data I 4.9
10. PACKAGE AND IC BLOCK DIAGRAM
10.1. Main Block
PA051 : YESAP403
9
IC201 : YESAM293
IC231 : YESAM320
IC501 : YESAM283
10
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Andere Panasonic Empfänger Handbücher
Panasonic
Panasonic CS-HZ25UKE Bedienungsanleitung
Panasonic
Panasonic SA-G90 Bedienungsanleitung
Panasonic
Panasonic TUIRD20 - DSS RECEIVER Bedienungsanleitung
Panasonic
Panasonic SAHE100 - RECEIVER Bedienungsanleitung
Panasonic
Panasonic SAHE70 - RECEIVER Bedienungsanleitung
Panasonic
Panasonic PressIT TY-SB01WP Bedienungsanleitung
Panasonic
Panasonic EX7 Bedienungsanleitung
Panasonic
Panasonic CY-TM200N Bedienungsanleitung
Panasonic
Panasonic RF-SW250 Bedienungsanleitung
Panasonic
Panasonic HDMI SA-XR700 Bedienungsanleitung
Panasonic
Panasonic SAXR50 - DIGITAL A/V RECEIVER Bedienungsanleitung
Panasonic
Panasonic CQVD7700U - CAR A/V DVD NAV Bedienungsanleitung
Panasonic
Panasonic RF-2400D Bedienungsanleitung
Panasonic
Panasonic CQ-VD5505W Bedienungsanleitung
Panasonic
Panasonic WVRC150 - CONTROLLER Bedienungsanleitung
Panasonic
Panasonic BT-WMA17G Bedienungsanleitung
Panasonic
Panasonic SAHE9 - RECEIVER Bedienungsanleitung
Panasonic
Panasonic TZ-DRD100 Bedienungsanleitung
Panasonic
Panasonic RF-SW250S Bedienungsanleitung
Panasonic
Panasonic WX-SR202P Bedienungsanleitung
