PARKIT360 TRANSFORMER 15K Bedienungsanleitung
INSTRUCTION MANUAL / USER GUIDE
VERSION 3.4FALL 2018 PARKIT360°
TRANSFORMER 15K
CALL TOLL-FREE:
1-888-926-5517
Ext. 1 - Sales
Ext. 2 - Administration
Ext. 4 - Technical Support
OFFICE HOURS (WEEKDAYS)
8AM-6PM EST
2
PARKIT360°/ TRANSFORMER 15K MANUAL
MORE PARTS AVAILABLE ONLINE: PARKIT360.COM
IN THE BOX
ALL TRANSFORMER
PACKAGES INCLUDE:
Transformer Unit Body
Two 6.5” Wide Tires
Battery Box (Battery NOT Included)
Wireless Controller with USB Charger Cable
Handle Tube with 2 D-Clips
BALL MOUNT PACKAGE
Thrust Washer
Hardware:
• 2 Handle Spring Clips
• Allen Key
FIFTH WHEEL PACKAGE
50” Kingpin Adapter
U Shaped Locking Pin with D-Clip
2 Set Screws with Allen Key
Kingpin Stabilizer Bar Kit:
• 2 Outer and Inner Stabilizer Bars
• 2 Outer and Inner Pivot Tubes
• 1 Mounting Ring Tube
Hardware:
• 6 Square D-Clips
•
•
•
• 4 Flat Washers
• 1 Spacer Plate
SOMETHING MISSING?
NEED EXTRA PARTS?
CALL TOLL-FREE:
1-888-926-5517
EXT. 1OR 4
1TRANSFORMER FRAME 8MOTOR (1.5 HP)
2CHAIN SHIELD 9MOTOR COVER
3SHIELD MOUNT 10 SHAFT / AXLE
4ELECTRONICS MODULE:
-CIRCUIT BOARD
-CIRCUIT BREAKERS
-RELAY
-CONTACTOR (400 AMP)
-VOLT METER
-7 WAY CONNECTOR
(SMART BRAKE)
11 TRANSFORMER HANDLE:
-WIRELESS CONTROLLER
-HANDLE SHAFT
12 SPROCKET:
-CHAIN
-LINKS (MASTER, HALF LINK)
5BUILT-IN BATTERY CHARGER 13 CASTER WHEEL
6TRANSFORMER CHARGER BRACKET 14 WHEEL & WIDE TIRES (6.5”)
7DRIVE PLATE 15 WHEEL BEARING
PARTS LIST
PARKIT360° / TRANSFORMER 15K MANUAL
3
2
8
9
14
9
14
3
4
11
5
13
13
1
7
12
15
8
10
6
TECHNICAL SUPPORT HOTLINE:
1-888-926-5517
EXT. 4
1
Install both 6.5” Wide Tires using
the supplied 1/2” bolts.
If you have a torque wrench, set it
to 80 ft-lbf. If not, ensure the bolts
are very snug.
2
Install the Battery (not included).
Connect the Battery Cables: Red
Black Cable to the Negative.
For the Battery Charger Cables
12V Group 24 Deep Cycle RV or
Marine Battery recommended.
3
install the Handle Tube and
attach the Wireless Controller
using the D-Clips provided.
Remove the Controller’s D-Clip to
control the Unit wirelessly from
a distance!
Controller Setup - Page 5
Controller Operation - Page 7
OPTIONAL:
INSTALL HANDLE TUBE
OR USE REMOTE
WIRELESSLY!
4
ASSEMBLY
PLEASE FOLLOW THESE
STEPS TO ASSEMBLE YOUR
PARKIT360 TRANSFORMER.
PARKIT360°/ TRANSFORMER 15K MANUAL
BATTERY CABLE
BATTERY
CHARGER
4
To access the controller’s
remove the 4 screws on the
Controller’s top cover.
5
Connect the loose Cables:
Battery Cable:
2 wires. There is a notch on the
top to ensure proper polarity.
Align this with the “Notch” label
written on the circuit board.
Charger Cable:
5 wires. Align the red wire end
of this cable with the “Red“ label
written on the circuit board.
Controller light will illuminate.
6
Replace the Controller Cover.
Secure using the 4 Screws
provided.
Due to Shipping Regulations and
Safety, the lithium battery is only
charged up to 30% capacity.
Charge the controller overnight
before rst use. Any standard
USB phone charger can be used.
5
PARKIT360°/ TRANSFORMER 15K MANUAL
BATTERY USB CHARGER
WIRELESS CONTROLLER SETUP
ASSEMBLY CONT’D:
CONNECT CONTROLLER WIRES & FULLY CHARGE BEFORE FIRST USE.
DUE TO SHIPPING REGULATIONS, THE BATTERY INSIDE OF THE CONTROLLER IS NOT CONNECTED.
PARKIT360°/ TRANSFORMER 15K MANUAL
6
OPERATION
YOUR TRANSFORMER HAS 2 MOTORS.
EACH MOTOR HAS TWO DRIVE MODES:
FREEWHEEL MODE SWITCHING GEAR
Neutral. For moving the Unit to
and from your application without
power while it is NOT under load.
locked in the drive position.
forwards or backwards before stopping.
Rock the unit so the wheels rest in between these
two stop points.
Pull on the Knob and turn it clockwise. Rest the
small pin on the outer metal, not in the pin hole.
Repeat on the other side of the Unit.
ENGAGED MODE SWITCHING GEAR
Drive. For connecting the Unit to
your hitch and moving the trailer
with battery power.
Ensure your unit is in position and ready to
connect to your trailer.
Pull on the Knob and turn it clockwise.
Ensure that the small pin ts into the slot.
Repeat on the other side of the Unit.
Rock the unit back and forth. The knob will pop in
Drive.
You’re now ready to connect to your hitch and
move the trailer!
ENSURE BOTH MOTORS ARE IN THE SAME GEAR BEFORE OPERATING.
PULL ON THE KNOB AND
TURN IT CLOCKWISE.
REST PIN OUTSIDE.
PULL ON THE KNOB AND
TURN IT CLOCKWISE.
PLACE PIN INSIDE.
LEFT
RIGHT
7
DRIVE DIRECTIONS
All directional terms used are from the
user’s point of view from behind the unit.
The Parkit360 Transformer wheels are
three-position switches.
The switches may be operated
WIRELESS SYNC LIGHT
Steady Light:
Wireless Connection Successful.
Slow Blink:
Receiver is OFF or is out of range.
Turn ON Unit or walk closer to it.
Fast Blink:
Controller Battery Low. Recharge.
SLEEP MODE
The wireless system will go to sleep
after 30 seconds of inactivity.
When one of the Rocker Switches is
done to save battery life.
The controller will also sleep when the
Unit’s power is turned OFF.
PARKIT360°/ TRANSFORMER 15K MANUAL
WIRELESS CONTROLLER
OPERATION CONT’D:
LEFT WHEEL SWITCH RIGHT WHEEL SWITCH
WIRELESS SYNC
FORWARD
FORWARD
(BACK UP TRAILER)
FORWARD
REVERSE
REVERSE
(TOWARDS USER)
REVERSE
BATTERY CHARGE
8
FRONT PLATE
Power:
Circuit Breakers:
Trailer Brake Plug: The Transformer features a connection for your trailer brake system. When the
Volt Meter:
the battery voltage.
PARKIT360°/ TRANSFORMER 15K MANUAL
ELECTRONICS MODULE
OPERATION CONT’D:
RESET / MOTOR L
MOTOR R
CIRCUITS / TRAILER BRAKES VOLT METER
POWER ON/OFF
7 PIN TRAILER BRAKE PLUG
QUESTIONS ABOUT ELECTRONICS?
CALL TOLL-FREE:
1-888-926-5517
EXT. 4 OR 1
9
SAFETY INSTRUCTIONS
DO NOT OPERATE ON
GRADES STEEPER THAN 4%
DO NOT EXCEED
WEIGHT CAPACITY
on grades steeper than 4% is not recommended.
Failing to follow these instructions could result in
depends on the Kit purchased:
Ball Mount:
Kingpin:
QUICK SET-UP GUIDE
PARKIT360°/ TRANSFORMER 15K MANUAL
1POSITION Switch both motors into Freewheel Mode and move the
Transformer to the trailer. Position it underneath your Trailer Hitch.
2POWER Connect the Battery Cables and 7 Pin Trailer Brake Control Cable.
3HITCH
Switch both motors to Engaged Mode and Connect your Hitch.
Press and Hold the ON/OFF button on the Unit for 2 seconds to
TURN ON. Button will illuminate.
4PARK Use the switches on the Wireless Controller to move your Trailer
Forwards and Backwards. Park the trailer in your desired location.
5DISCONNECT Push the Power Button on the Unit to TURN OFF.
Switch the Unit into Freewheel Mode and Disconnect your Hitch.
6STORE
Please ensure the unit is kept level to prevent battery acid
overow while charging.
10
PARKIT360°/ TRANSFORMER 15K MANUAL
1
Thread the desired Hitch Ball
Apply a generous portion of
All-Purpose Grease along the top
The bottom shoulder of the Hitch
Ball must be slightly below the top
surface of the Ball Mount Collar.
NOTE: HITCH BALL WELD SPOTS
Weld Spots on the
Hitch Ball are pointed towards the
rear left side of your trailer
at about 10 o’clock.
You will have trouble locking
your hitch if they are not
positioned properly!
2
underneath the hitch.
With the Weld Spots in the correct
Hitch and lock it as normal.
BALL MOUNT
ADAPTER
CONNECTING TO YOUR TRAILER:
BALL MOUNT TUTORIAL VIDEO:
HTTPS://YOUTU.BE/NZ-_WKINBZS
WELD SPOTS
12
6
39
Andere Handbücher für TRANSFORMER 15K
2
Inhaltsverzeichnis
Andere PARKIT360 Roller Handbücher
Beliebte Roller Handbücher anderer Marken
First Choice Mobility
First Choice Mobility Roma Medical Corella S741 Bedienungsanleitung
Carrera
Carrera impel Bedienungsanleitung
Afikim
Afikim Superlight SL-3 Bedienungsanleitung
CareCo
CareCo ZOOM Bedienungsanleitung
Douglas
Douglas Vespa G.S. Bedienungsanleitung
Gazelle
Gazelle with BOSCH System Bedienungsanleitung