Fig.1
1
0
Function
Setting manner one:DIP switch
As below shown, by S1,S2 to set the detection range, S3,S4 the delay time, S5 the light-control value,S6 the
brightness percentage function . It may take times to adjust values before they satisfy your need.
SENS:S1,S2
1
0
(1)Detection range setting (sensitivity)
Detection range is the term used to describe the radii of the
roughly circle casting on the ground when installed at the
height of 2.5 m. To set the switch to ON is “1”, to OFF is
“0”. Read through the right shown the corresponding table
of the switch position to the detection range.
S1 S2 Detection range
0 0 2m(radii)
0 1 4m(radii)
1 0 6m(radii)
1 1 8m(radii)
Notice: when using this product, please adjust the sensitivity (detection range) to an
appropriate value but the maximum to avoid the abnormal reaction caused by the easy
detection of the wrong motion by the blowing leaves & curtains, small animals or the
interference of power grid & electrical equipment. All the above mentioned will lead to the
error reaction. When the product does not work normally, please try to lower the sensitivity
appropriately, and then test it.
Human movement will cause the sensor induction,so when you under the function
testing,please leave the induction region and don't make movement to prevent the sensor
continuous work.
Friendly reminder: when installing two or more microwaves together, you are required to
keep 4 meters one from another, otherwise the interference among them will lead to error
reaction.
(2)Time setting
It can be defined from 10 seconds to 12minute.
Any movement detected before this time
elapse will re-start the timer. It is
recommended to select the shortest time for
adjusting the detection range and for
performing the walk test. To set the switch to
ON is “1”, to OFF is “0”. Read through the right
shown the corresponding table of the switch
position to the delay time.
It is mainly for the adjustment of the delay time from the moment the signal detected and light
auto-on till the light auto-off. You can define the delay time to your practical need. But you’d
better lower the delay time for the sake of energy saving, since the microwave sensor has the
function of continuous sensing, that is, any movement detected before the delay time
elapses will re-start the timer and the light will keep on only if there is human in the detection
range.
TIME:S3,S4
1
0
S3 S4 Time setting
0 0 10sec
0 1 2min
1 0 6min
1 1 12min
