Philips 8200 series Bedienungsanleitung
3
A
B
C
D
E
K
H
F
I
J
G
4
4
HQ8255
ENGLISH 6
19
32
45
59
73
86
100
114
128
141
155
169
6
Introduction
Congratulations on your purchase and welcome
to Philips! To fully benet from the support that
Philips offers, register your product at www.philips.
com/welcome.
Please read this user manual, as it contains
information about the wonderful features of this
shaver as well as some tips to make shaving easier
and more enjoyable.
Important
Read this user manual carefully before you use the
appliance. Save the user manual for future reference.
Danger
Make sure the adapter does not get wet.
Warning
Be careful with hot water.Always check if the
water is not too hot, to prevent your hands from
getting burnt.
The adapter contains a transformer. Do not cut
off the adapter to replace it with another plug, as
this causes a hazardous situation.
This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience
and knowledge, unless they have been given
supervision or instruction concerning use of the
appliance by a person responsible for their safety.
Children should be supervised to ensure that they
do not play with the appliance.
-
-
-
-
-
ENGLISH
Never immerse the shaver in water.
Charge, use and store the shaver at a temperature
between 10°C and 35°C.
Always put the protection cap on the shaver
to protect the shaving heads when you are
travelling.
The shaver and the other accessories are not
dishwasher-proof.
Never use water hotter than 80°C to rinse the
shaver.
Do not use the shaver in the bath or in the
shower.
Only use the adapter supplied.
Do not use the shaver or the adapter if it is
damaged.
If the adapter is damaged, always have it replaced
with one of the original type in order to avoid a
hazard.
The shaver complies with the internationally
approved IEC safety regulations and can be safely
cleaned under the tap.
This Philips appliance complies with all standards
regarding electromagnetic elds (EMF). If handled
properly and according to the instructions in this
user manual, the appliance is safe to use based on
scientic evidence available today.
The adapter transforms 100-240 volts to a safe
low voltage of less than 24 volts.
.
-
-
-
-
-
-
-
-
-
-
-
-
ENGLISH 7
Protection cap
BShaving unit
Shaving unit release button
DShaver on/off button with power-on symbol
EDisplay
FTrimmer
GCleaning brush
HStorage pouch (your pouch may differ from the
one shown in the gure)
IAdapter
JSmall plug
Charger
When the shaver is charging, the CHARGE light is
on continuously.
When the battery is fully charged, the CHARGE
light starts ashing.
Note: If the rechargeable battery runs low during
shaving, you can connect the shaver to the mains to
nish the shave.
When the battery is almost empty (when there
are only 5 or fewer shaving minutes left), the
LOW light goes on.
-
-
-
ENGLISH8
When you switch off the shaver, the LOW light
ashes a few seconds.
Charge the shaver when the LOW light goes on.
Do not charge the appliance in a closed pouch.
It takes approx. 60 minutes to fully charge the
battery.
When you charge the shaver for the rst time or
after a long period of disuse, let it charge for 12
hours.
Tip:To optimise the battery capacity, fully charge the
shaver and then use it normally until the battery is
completely empty. Repeat this process three times in a
row. If you optimise the battery capacity in this way, you
can also charge the shaver in between shaves, even if
the battery is not completely empty yet.
A fully charged shaver provides up to 17 cordless
shaves.
If you have a heavy beard, the shaver may provide
less than 17 cordless shaves.The shaving time may
also vary over time, depending on your shaving
behaviour, cleaning habits and beard type.
1 Put the small plug in the shaver.
2 Put the adapter in the wall socket.
The CHARGE light goes on.
Note: You can also use the appliance without charging.
Simply connect the appliance to the mains.
-
,
ENGLISH 9
1 Press the on/off button once to switch on the
shaver.
The power-on symbol in the on/off button lights
up.
2 Move the shaving heads over your skin. Make
both straight and circular movements.
Shaving on a dry face gives the best results.
Your skin may need 2 or 3 weeks to get
accustomed to the Philips shaving system.
3 Press the on/off button once to switch off the
shaver.
4 Clean the shaver (see chapter ‘Cleaning and
maintenance’).
You can use the trimmer to groom your sideburns
and moustache.
1 Press the on/off button once to switch on the
shaver.
The power-on symbol in the on/off button lights
up.
2 Push the trimmer slide downwards to open
the trimmer.
You can now start trimming.
3 After trimming, close the trimmer (‘click’) and
switch off the shaver.
,
-
-
,
,
ENGLISH10
Never use scouring pads, abrasive cleaning agents
or aggressive liquids such as petrol or acetone to
clean the appliance.
Clean the shaver after every shave for optimal
shaving performance.
Be careful with hot water.Always check if the
water is not too hot, to prevent your hands from
getting burnt.
You can clean the charger and the outside of the
shaver with a damp cloth.
Note:Water may leak from the socket at the bottom of
the appliance when you rinse it. This is normal and not
dangerous.
1 Switch off the shaver and disconnect it from
the mains.
2 Press the release button to open the shaving
unit.
3 Rinse the shaving unit and hair chamber under
a hot tap for some time.
Make sure that you clean the inside as well as the
outside of the shaving unit.
Be careful with hot water.Always check if the
water is not too hot, to prevent your hands from
getting burnt.
-
-
-
-
ENGLISH 11
4 Close the shaving unit and shake off excess
water.
Never dry the shaving unit and the hair chamber
with a towel or tissue, as this may damage the
shaving heads and the coupling spindles.
5 Open the shaving unit again and leave it open
to let the shaver dry completely.
1 Switch off the shaver and disconnect it from
the mains.
2 Press the release button to open the shaving
unit.
3 Turn the lock anticlockwise (1) and remove the
retaining frame (2).
4 Clean the shaving heads with the brush
supplied. Each shaving head consists of a cutter
and a guard.
Do not clean more than one cutter and guard
at a time, since they are all matching sets. If you
accidentally mix up the cutters and guards, it
may take several weeks before optimal shaving
performance is restored.
5 Put the shaving heads back into the shaving
unit.
ENGLISH12
Andere Handbücher für 8200 series
2
Dieses Handbuch passt für folgende Modelle
3
Inhaltsverzeichnis
Sprachen:
Andere Philips Elektrorasierer Handbücher
Philips
Philips HS990/33 Bedienungsanleitung
Philips
Philips HQ6900 series User m Bedienungsanleitung
Philips
Philips HQ8170 Bedienungsanleitung
Philips
Philips HQT784/00 Bedienungsanleitung
Philips
Philips HP6390/50 Bedienungsanleitung
Philips
Philips HQ 7240 Bedienungsanleitung
Philips
Philips MG7770 Bedienungsanleitung
Philips
Philips HQ9190 Bedienungsanleitung
Philips
Philips HQG267 Bedienungsanleitung
Philips
Philips NORELCO MG7750/59 Bedienungsanleitung
Philips
Philips Lumea SC2004 Bedienungsanleitung
Philips
Philips Norelco 8020X Bedienungsanleitung
Philips
Philips QT4014 Bedienungsanleitung
Philips
Philips TT2040 Bedienungsanleitung
Philips
Philips HQ7890/22 Bedienungsanleitung
Philips
Philips Lumea Prestige BRI954 Bedienungsanleitung
Philips
Philips SmartClick YS527 Bedienungsanleitung
Philips
Philips S91xx Bedienungsanleitung
Philips
Philips CoolSkin HS8040 Bedienungsanleitung
Philips
Philips HS8460 Bedienungsanleitung
