Philips FC9262 Bedienungsanleitung

ServiceManual

Philips Consumer Lifestyle

Published by Philips Consumer Lifestyle Printed in the Netherlands © Copyright reserved Subject to modification

Vacuum cleaner

FC9262

12/01

PRODUCT INFORMATION

- This product meets the requirements regarding

interference suppression on radio and TV

- After the product has been repaired, it should function

properly and has to meet the safety requirements as

officially laid down at this moment

TECHNICAL INFORMATION

- Colour : Dark aubergine

- Power consumption : 2000 W (IEC) 230 V

- Maximum Air displacement : 37 l/s

- Vacuum : 27.5 kPa

- Duststorage capacity : 1.5 L

- Cord length : 9 m

- Motor : Infrared remote controlled

- Fiter system : HEPA cyclone-filtration

auto-clean system

: Permanent motor

protection filter

: Ultra Clean Air HEPA13

washable exhaust filter

- Dimensions of cleaner : 485 x 285 x 335 mm

- Net weight : 9.6 kg

ACCESSORIES

- Nozzle : Tri-Active all purpose nozzle

- Tubes : Metal lacquered telescopic tube with

second handgrip

- Handgrip : Ergonomic handgrip with remote

control

- Accessories : Brush, crevice nozzle and small nozzle

- Accessory storage : Active accessory storage bridge in

handgrip

- Coupling : Button coupling

OPTIONAL (accessories)

- FC 8031 : Super Clean Air HEPA filter

- FC 8038 : Super Clean Air HEPA washable filter

FC9262

DISASSEMBLY- AND RE-ASSEMBLY ADVISE

- To open the appliance, first remove the filter cover

(item 39).

- Remove the can with the filters.

- Then remove the hingecover (2 screws A)

- When the hinge cover is removed, the dustcover can be

removed.

- Now remove the drive coupling (item 13) by turning it

clockwise.

- To remove the housing (9 screws F), for some screws you

will require a screwdriver with 14.5 cm long shrank.

Screwdriver 4322 009 08490 for T15 can be used.

- When the repair is finished, check whether all functions of

the appliance work properly.

- To disassemble the cord winder, use TORX screwdriver no.

T10, which is one of a set consisting of T20; T15; T10; T9;

T8; T7 and T6 (code number 4822 395 50145)

ELECTRICAL DIAGRAM

REPAIR INSTRUCTION

- Due to precisely pre-adjusted belt-tension, rattle drive unit

(item 12) may only be replaced as a complete unit.

Do not disassemble this unit in any way!

- If the reel half spring unit is replaced, shaft (M) must be

lubricated with silicone grease. Do not apply any silicone

grease to or spill any grease on terminals (item 55) or

conductors (item 56).

- The cord winder spring must be tensioned to the maximum

level and the be rewound approx 1.5 turn.

- Item 15, air valve, opens to cool the motor if the air

displacement is too low or if the airflow is blocked.

RATTLE

DRIVE

MOTOR

Black

BlackBlack

Blue

Brown

Red

Blue

IR PCB

Switch

CORD

WINDER

TRANSMITTER

2-8

FC9262

- Appliances from before WK845 have a potential problem

in the cord winder system; the lever of spindle (Pos. 26) can

move out of position.

Symptom:

Cord will not rewind pressing the cord winder button.

Solution:

Remove the Cord winder button as shown in below picture:

Remove the cord winder button by simultaneously operating

the button and putting a screwdriver between the openings

that occur.

Then lift the button by levering the screwdriver.

This has to be done at 2 (two) positions as indicated in the

picture.

Insert a screwdriver (size 1) in the position as shown in below

picture and move it backwards until a “Click” is heard, the

lever of spindle is now back in position. This can be tested by

pressing lever A, the cord should rewind now.

“Click”

REPAIR INSTRUCTION

To prevent lever shifting out of position to re-occur,

CW support (Pos. 70) must be added as shown in below

pictures:

Rotate the part 90 degrees CCW, once it is inside the housing

half way.

90°

CCW

90°

CCW

Then drop the part till it is completely inside the appliance

and push down with a screwdriver untill “Click”.

“Click”

Finally re-assemble the button.

Press it ﬁrmly, until the “Click”.

3-8

FC9262

PARTS LIST

4-8

Pos Service code Description

4322 005 25400

4322 003 34210

4322 003 34200

4322 003 34180

4322 005 25480

4322 003 31520

4322 000 68230

4322 003 31600

4322 001 73910

4322 003 34040

4322 003 35170

4322 005 23140

4322 005 19600

4322 003 35200

4322 005 26540

4322 009 09850

4322 003 32920

4322 005 24040

4322 004 20130

4322 005 24210

4322 003 31400

4322 005 27190

4322 005 27470

4322 006 23530

4322 001 74100

4322 003 31310

4322 003 32870

4322 003 31160

4322 005 25280

4322 000 39120

4322 003 32890

4322 003 32900

4322 003 31410

4322 005 27200

4322 003 31320

Handle assy

Handle side rear

Handle side front

Handle support

Dustcover toppanel

Dustcover Dark Aubergine

Spring

Dustc. lock button Dark Aub.

Dustcover sealing

Dustc. inside incl. seal. Dark Aub.

Choke valve cover Dark Aub.

Rattle drive unit assy

Coupling assy

Hinge cover Dark Aubergine

Choke valve assy

Rattle ﬁlter cyl. assy Dark Aub.

Tower assy

Bucket assy Transp. blue

Filter Brush

Upperh. sidecover assy Blue

Bumper right Dark Aubergine

Cordwinder button Dark Aub.

RMC window assy

PCB assy incl. IR

Cooling tube

Lever of spindle

Front handle Dark Aubergine

Lower housing Dark Aubergine

Caster wheel assy Dark Aubergine

Motor inlet ﬁlter

Inlet sealing 2

Switch lever

Bumper left Dark Aubergine

On/Off button Dark Aubergine

Backpanel Dark Aubergine

Pos Service code Description

38*

4322 006 07750

4322 003 32880

4322 005 27781

4322 005 23090

4322 004 93350

4322 000 38960

4322 000 39020

4322 003 31220

4322 000 39000

4322 000 39010

4322 003 25390

4322 003 31240

4322 001 73440

4322 009 09430

4322 000 39110

4322 003 26030

4322 001 73520

4322 003 31250

4322 009 00040

4322 005 17910

4322 006 07410

4322 006 07390

4322 006 07400

4322 005 25770

4322 009 09890

4322 005 24050

4322 009 09900

4322 005 25790

4322 003 34660

4322 005 25800

4322 004 20580

4322 005 27330

4341 004 20840

4322 003 35650

Switch

Cord outlet Dark Aubergine

Skate wheel assy Left & Right

Exhaust grille assyTempest Grey

HEPA13 ﬁlter washable

Exhaust sealing

Silencer 4

S-class H sealing

Silencer 1 wall

Silencer 2 bottom

Inlet sealing 1

Motorhousing top

Motorbuffer front

Motor 1761 220 - 240 V

Silencer 3 VCM

Motor bracket

Bufferback green

Motorhousing bottom

Cordwinder “no cord“

Contactplate assy

Cordset UK/HK 9.3 m

Cordset Euro 4.8 mm 9.3 m

Cordset Swiss 9.3 m

Battery lid assy

Bend type 3 assy

Hose/conn. assy Dark Aub.

Hose/connection/bend

type 3 assy Dark Aubergine

Accessoiry holder

Crevice nozzle

Small nozzle

Brush tool

3pc Telesc. tube sec. handle assy

Tri-active nozzle

CW Support

* Standardized colour

= changed

FC9262

EXPLODED VIEW

Blue

Red

5-8

FC9262

EXPLODED VIEW

Black Black

Red

Brown

Black

Blue

Black

Blue

6-8

FC9262

EXPLODED VIEW

57 59

Blue

Brown

Black

7-8

FC9262

EXPLODED VIEW

Europe Ø 4.8mm 58

Swiss

57U.K. / H.K. 59

61 62

8-8

Andere Handbücher für FC9262

Inhaltsverzeichnis

Andere Philips Staubsauger Handbücher

Philips

Philips FC9116/01 Bedienungsanleitung

Philips

Philips Bruce FC6093 Bedienungsanleitung

Philips

Philips Marathon FC9219 - FC9200 Bedienungsanleitung

Philips

Philips FC5228 Bedienungsanleitung

Philips

Philips Jack HR6072 Bedienungsanleitung

Philips

Philips FC7020 Bedienungsanleitung

Philips

Philips FC6094 Bedienungsanleitung

Philips

Philips SmallStar FC8286/01 Bedienungsanleitung

Philips

Philips FC8740 Bedienungsanleitung

Philips

Philips FC5828/02 Bedienungsanleitung

Philips

Philips FC9269 Bedienungsanleitung

Philips

Philips FC6723 Bedienungsanleitung

Philips

Philips SpeedPro Max Bedienungsanleitung

Philips

Philips PowerPro Aqua Bedienungsanleitung

Philips

Philips FC9920/09 Betriebsanleitung

Philips

Philips FC9174/01 Bedienungsanleitung

Philips

Philips FC9202 Bedienungsanleitung

Philips

Philips HomeRun Aqua 7000 Series Bedienungsanleitung

Philips

Philips FC8188 Bedienungsanleitung

Philips

Philips FC8452/61 Bedienungsanleitung

Philips

Philips HR 8374 Bedienungsanleitung

Philips

Philips SpeedPro Max Betriebsanleitung

Philips

Philips HR 8572 Bedienungsanleitung

Philips

Philips FC9150 Bedienungsanleitung

Beliebte Staubsauger Handbücher anderer Marken

Bissell

Bissell LittleGreen Proheat 1425 Series Bedienungsanleitung

Panasonic

Panasonic MC-YL637S147-AE Bedienungsanleitung

NEFF

NEFF N17XH10 0 Series Bedienungsanleitung

LG A9 Series Bedienungsanleitung

Oreck

Oreck Cordless Captura BK51700 Series Bedienungsanleitung

Kogan

Kogan KAVACROBVWA Bedienungsanleitung

Kränzle

Kränzle VENTOS 50 ID Benutzerhandbuch

EVVO

EVVO Ai35 Bedienungsanleitung

DeWalt

DeWalt DWH200D Bedienungsanleitung

Pontec

Pontec Pondomatic Vacuum Cleaner Bedienungsanleitung

Cleanmaxx

Cleanmaxx PC-P007E Bedienungsanleitung

Exido

Exido 240-114 Bedienungsanleitung

RIDGID

RIDGID WD1685AU0 Bedienungsanleitung

Ezviz

Ezviz RE4P Bedienungsanleitung

STG global

STG global TANVAC HDV3000 Bedienungsanleitung

Shark

Shark ROTATOR PRO COMPLETE NV550 Series Bedienungsanleitung

Factory

Factory M3340 Bedienungsanleitung

Shop-Vac

Shop-Vac VN92 SERIES Bedienungsanleitung