Pioneer DRC1227-A Bedienungsanleitung

Thank you for buying this Pioneer product.

Please read through these operating instructions so you will know how to operate your model

properly. After you have finished reading the instructions, put them away in a safe place for

future reference. K015 En

The Generation of Acoustical Noise Is Less Than 70dB.

(ISO7779/DIN45635)

WARNING

This equipment is not waterproof. To prevent a fire

or shock hazard, do not place any container filed

with liquid near this equipment (such as a vase or

flower pot) or expose it to dripping, splashing, rain

or moisture.

D3-4-2-1-3_A_En

CAUTION

This product is a class 1 laser product, but this

product contains a laser diode higher than Class 1.

To ensure continued safety, do not remove any covers

or attempt to gain access to the inside of the product.

Refer all servicing to qualified personnel.

The following caution label appears on your unit.

Location: on top of the cover D3-4-2-1-8_A_En

CLASS 1 LASER PRODUCT

LASER KLASSE 1

IMPORTANT NOTICE – RECORD THE MODEL NUMBER AND SERIAL NUMBERS OF THIS EQUIPMENT BELOW.

THE NUMBERS ARE ON THE REAR.

MODEL NO.

SERIAL NO.

KEEP THESE NUMBERS FOR FUTURE USE. D1-4-2-6-2_En

DVR-A08XLA, DVR-A08XLB, DVR-A08XLC

WARNING: Handling the cord on this product or

cords associated with accessories sold with the

product will expose you to lead, a chemical known to

the State of California and other governmental

entities to cause cancer and birth defects or other

reproductive harm.

D36-P4_En

Wash hands after handling

is a trademark of DVD Format/Logo Licensing Corporation.

English

SAFETY INSTRUCTIONS

To ensure your personal safety and to maximize the full operating potential of your Drive, read and follow

these safety precautions:

ENVIRONMENT - Avoid installing the unit in a location that is exposed to high temperatures, high humidity,

large quantities of dust, or subject to excessive vibrations and shocks.

POWER - Turn off the system before installing this unit or any other hardware device.

READ AND RETAIN INSTRUCTIONS - Read all safety and operating instructions before operating the unit.

CLEANING - Use a damp cloth to clean the exterior housing. Avoid using any fluids including aerosol, liquid,

or alcohol-based cleaning products.

WATER AND MOISTURE - DO NOT use this product near open containers or other possible sources of liquid.

POWER SOURCES - Operate this product only from the recommended power sources. If you are unsure of the

type of power available, consult an Authorized Pioneer Dealer.

OVERLOADING - DO NOT overload wall outlets and extension cords. Doing so can result in fire or electric

shock.

OBJECT AND LIQUID ENTRY - Never push objects of any kind into this product. Touching dangerous voltage

points may cause a short resulting in fire or electric shock. Do not spill any type of liquid on this product.

CONDENSATION - Moisture can form inside of the unit if it is moved between cool surroundings and a warm

environment. If you are moving the unit to a different room, leave the product disconnected in the new location

for up to 2 hours before installing the unit or turning it back on.

SERVICING - Do not attempt to repair this product yourself. Opening or removing covers may expose you to

dangerous voltage or other hazards. Refer all servicing to qualified service personnel. (Refer to the enclosed

Service and Support Card.)

÷Remove dust or lint from the disc with a soft cloth by

wiping from the inside to the outside edge rather than in

a circular motion.

÷Do not use record-cleaning or anti-static agents as the

solutions may damage a disc.

Always store discs in proper DVD-R storage cases when

not in use. Check for dirt, dust, or fingerprints on a disc's

recording side before inserting in to the unit.

÷Avoid touching or scratching the signal surface (shiny

side) of the disc.

÷Hold the disc by the edges or by the center hold and one

edge.

÷Do not affix paper or labels to the disc.

÷Discard warped or cracked discs as they may cause

damage to the drive.

÷Avoid specially shaped discs such as hearts or polygons.

English

ABOUT REGION CODES

The region code can only be changed 5 times, including the initial setting. Please be

aware that the fifth change becomes PERMANENT. Therefore, avoid changing the

region code unless absolutely necessary.

÷Region codes are part of the DVD Standard. However, Region codes on DVD

discs are optional. DVD discs with no specified Region code can be played on all

players.

INTERFACE

FRONT VIEW

1Forced Ejection Hole

If the tray fails to eject when the Eject button is pressed, insert a stiff rod into the hole and

push to eject the tray. During normal operation, the eject button should be used to unload the

tray. Make sure the power to the drive is turned off and wait at least one minute until the disc

stops spinning when forcing the tray to eject using the eject hole.

2BUSY Indicator

Operation status is indicated as follows.

During reading Lights

During writing Lights

3Eject Button (0)

To unload /load the disc, press the button.

4Disc Tray

Open the loading tray by pressing the eject button, then place a CD or DVD disc onto the tray

with the label facing up.

Press the eject button or push the front tray panel to load the disc.

Do not attempt to pull out the disc tray forcibly.

Precautions on playing 8 cm (3.15") Discs

An 8 cm (3.15") disc cannot be played when the drive isverticaleven ifan adapter is attached.

INTERFACE

REAR VIEW

Pin Name Function

1 L Left channel audio output.

2 G Ground.

3 G Ground.

4 R Right channel audio output.

Pin Name Function

1 MA on The drive is used in master mode.

2 SL on The drive is used in slave mode.

3 CS on Using Cable Select function.

4 Reserved.

5 Reserved.

5Audio Output

This connector outputsanalog audio.

This connector is compatible with `Molex 70553`, choose a suitable connection cable.

Pin Name Function

1 +12 Power supply input for DC +12 V.

2 G Ground.

3 G Ground.

4 +5 Power supply input for DC +5 V.

6Device Configuration Jumper

Switch becomes ON when a jumper is added.

Make sure the power of the drive is OFF before changing the jumper setting.

Pin # 1 is ON when shipped from the factory.

7Host IDE Interface

This is a 40 pin I/O connector according to the ATA specifications.

8DC Input

5 6 7

ANLOG AUDIO

CABLE SELECT

SLAVE

MASTER

5V G G 12V

ALS

SC IDE INTERFACE

DC INPUT

English

1Turn OFF the computer's power and remove the power cord from the wall outlet

before removing the front panel cover.

2Remove the blank panel from the front of the 5.25" bay slot.

3Install the fixing slide rails on the drive. (When slide rails are required, please contact

the store where the drive was purchased.)

4Insert the drive into the slot.

5When anchoring is required, please refer to the computer's instruction manual.

÷Please use screws measuring 5mm (3/16 in.) or less for mounting. Using

longer screws may damage the drive.

÷When the mounting screws are loose, the vibrations from a spinning disc may

generate ripping noise. To prevent this noise, tighten the screws.

INSTALLATION

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Sprachen:

Andere Pioneer DVD-Recorder Handbücher

Pioneer

Pioneer D V D R E C O R D E R S A N D P L A Y E R S Bedienungsanleitung

Pioneer

Pioneer DVR-310-S Bedienungsanleitung

Pioneer

Pioneer PRV-LX1 Bedienungsanleitung

Pioneer

Pioneer BDR-2206 Bedienungsanleitung

Pioneer

Pioneer DVD / CD WRITER Bedienungsanleitung

Pioneer

Pioneer DVR-65H-S Einrichtungshandbuch

Pioneer

Pioneer PRV-LX1 Handbuch

Pioneer

Pioneer DVR-212 Bedienungsanleitung

Pioneer

Pioneer DVR-R100 Bedienungsanleitung

Pioneer

Pioneer DVR-630H-S Bedienungsanleitung

Pioneer

Pioneer DVR-320 Bedienungsanleitung

Pioneer

Pioneer DVR-640H-S Bedienungsanleitung

Pioneer

Pioneer DVR-RT500-S Bedienungsanleitung

Pioneer

Pioneer DVR-610 Bedienungsanleitung

Pioneer

Pioneer BDR-S07XLT Bedienungsanleitung

Pioneer

Pioneer DVR-RT501-S Bedienungsanleitung

Pioneer

Pioneer DVR-231-S Bedienungsanleitung

Pioneer

Pioneer DVD Recorder Bedienungsanleitung

Pioneer

Pioneer DVR-112D Bedienungsanleitung

Pioneer

Pioneer DVR-533H-S Bedienungsanleitung

Pioneer

Pioneer RCS-404H Bedienungsanleitung

Pioneer

Pioneer PRV-LX1 Kurzanleitung

Pioneer

Pioneer DVR-X162Q Bedienungsanleitung

Pioneer

Pioneer DVR-5100H-S Bedienungsanleitung

Beliebte DVD-Recorder Handbücher anderer Marken

Sony

Sony RDR-VX525 - DVDr/ VCR Combo Bedienungsanleitung

Daewoo

Daewoo DHD-4000D Bedienungsanleitung

Medion

Medion MD 40570 Bedienungsanleitung

Philips

Philips ShowView DVDR3460H Bedienungsanleitung

Sony

Sony RDR-GX355 - Tunerless DVD Recorder Bedienungsanleitung

Sony

Sony DVDirect VRD-MC3 Bedienungsanleitung

Samsung

Samsung DVD-R130/XAA Bedienungsanleitung

FUNAI

FUNAI HD-B2735 Bedienungsanleitung

Panasonic

Panasonic DMR-EH54DEG Bedienungsanleitung

Sanyo

Sanyo DRW-1000 Bedienungsanleitung

Philips

Philips DVDR610/05 Bedienungsanleitung

JVC

JVC DR-M10 Bedienungsanleitung

Samsung

Samsung SV-DVD40 Bedienungsanleitung

Philips

Philips DVDR3355 Bedienungsanleitung

FUNAI

FUNAI FDR-90E Bedienungsanleitung

LG RC298 Bedienungsanleitung

Samsung

Samsung DVD-R130 Bedienungsanleitung

Philips

Philips DD-A110GX Bedienungsanleitung