1110
Battery Replacement
The wireless sensor will notify you via the
PowerTechCS App when the internal battery
voltage is low.
• Remove the wireless sensor from the
mounting bracket.
• Remove the four screws on the back of the
wireless module and remove sensor back.
• Slide the depleted battery out of the battery
holder and replace with a new CR2430 battery
with the positive (+) side facing up.
• Replace the back of the sensor and tighten the
four Phillips screws. Use care when closing up
the wireless module.
• Make sure to tighten the screws and that all
seals and O-rings are secure and in place.
• Place the wireless module back into the
mounting bracket.
Pair Wireless Sensors to
CS Pro Device
• Ensure the battery has been installed in the
wireless sensor (see instructions on page 8).
• Pair the wireless sensors prior to mounting in
its permanent location.
• Go to the Settings page on the PowerTechCS
App and select Add Wireless Sensor.
• Scan the QR Code on the back of your
wireless sensor.
• Select the wireless sensor type.
• In the dialog box, rename the sensor
description and select Add.
• To add additional sensors, repeat above steps.
