Prem-I-Air EH1644 Bedienungsanleitung

EH1644 / EH1644EU

2kW Convector Heater

Remote Control

3 Heat settings

Adjustable Digital Thermostat

Free-standing or wall mounting

24 Hour Digital Timer

Safety overload cut-out

IMPORTANT

Installer and Users please note:

These instructions should be read carefully and left with the user of the

product for future reference.

INSTALLATION

For free-standing use: attach the feet to the underneath of the heater using

the four 12mm (½") screws. The feet fit over the pre drilled holes in the

case approximately 95mm from the end of each side.

To wall-mount: Referring to the diagrams below, draw two horizontal lines

on the wall 330mm apart, the lower line more than 50mm from the floor.

On the upper line, drill holes 310mm apart, using a 6mm (¼") masonry bit,

and insert a wall plug in each hole.

On the lower line, drill holes 435mm apart centred directly below the upper

holes using a 6mm (¼") masonry bit, and insert a wall-plug. See Fig 2.

Insert the 30mm screws into the upper holes and tighten to within 8mm of

the wall. See Fig 2.

wall plug

Fig 1

Fig 2

Fig 2.

Slot the 2 hook brackets over the upper 2 screws and tighten to secure to

the wall. See Fig 3.

Fix the two L-shaped brackets to the underside of the heater using the

12mm screws through the round hole in the bracket - the oval hole in the

bracket locates over the screw that fixes the case together approximately

95mm from the case side at the rear of the unit.

Hang the heater on the hook-brackets using the two 25mm slots.

The L-shaped brackets will now line up with the lower holes in the wall.

Attach to the wall using the other two 30mm screws. See Fig 4 below.

Fig 3

Fig 4

PRODUCT SAFETY

•This appliance is not intended for use by persons (including children) with

reduced physical, sensory or mental capabilities, or lack of experience and

knowledge, unless they have been given supervision or instruction

concerning use of the appliance by a person responsible for their safety.

•Children should be supervised to ensure that they do not play with the

appliance

•Place the EH1644/EU on a firm flat surface. Ensure that the air inlets (at

the bottom) and the air outlets (at the top) are not obstructed.

•Ensure that curtains are at least 900mm from the top of the heater.

•Leave a gap of at least 50mm at the sides of the heater.

•If used free-standing, do not operate unless the feet are correctly

attached.

•Do not place on soft surfaces.

•Do not cover. This symbol shown on the casing of the

heater means that the heater should not be covered.

•Do not use outdoors.

•Do not use in bathrooms, or in wet or damp locations.

•Do not place the mains lead beneath a carpet or rug.

•Do not use the heater in locations where paint, petrol or other flammable

liquids are used or stored.

•Do no insert any object into the heater through the grilles. This may

damage the heater or result in overheating or electric shock.

PAT TESTING

When used in an office environment, this product should be safety-tested

yearly by a qualified electrician (PAT Tested).

We recommend that it is PAT tested regularly when used in a domestic

environment.

GENERAL SAFETY REQUIREMENTS

Domestic wiring must be tested periodically by a qualified electrician at

least once every 10 years or at every change of occupancy.

For office and retail premises, and buildings such as village halls, the wiring

must be inspected at least once every 5 years.

It is recommended that all building be fitted with smoke alarms (it is

mandatory for new buildings).

OPERATION

Plug the mains lead into a 13 Amp mains socket.

If connecting via an extension lead, make sure that

the lead is rated at 10 Amps or more, and that it is

fully unwound.

Switch the unit on at the mains socket.

All the following controls can be operated via the

control panel or the remote control.

Switch the unit on by pushing the On/Off button

The unit will beep to show it is powered on and

ready.

The display will show the room temperature.

To set the desired room temperature first press the Temp button

then the Plus or Minus Button to increase or decrease the

desired room temperature. Holding the Plus or Minus buttons for approx.

3s will cause the display to change at a faster rate.

Select the required heating power by pushing the Heat button then

the Plus and Minus buttons. The power options are as follows;

Eco = 750W the unit will beep once.

Comfort = 1250W the unit will beep twice.

Super = 2000W the unit will beep three times.

The fan can be operated at any time by pressing the Fan Button,

Fan Switch

Power

Switches

pressing once will turn the fan on and again will turn it off.

The heater will now operate at the desired power level till the set

temperature is reached, the unit will turn off and only turn on again if the

temperature drops below the set level.

Do not touch the air output grille when the heater is in operation, because

it will be hot and may cause burns.

If the unit is switched off at the panel or the mains supply the settings will

revert to their default values (Temp = 24°C, Timer = OFF, Heater = OFF).

Unplug the heater from the mains when not in use.

USING THE TIMER

To operate the unit on the 24 hour timer the unit must be plugged in and a

power setting, temperature selected. If the unit is turned off at any time

the clock will stop and reset. The timer is a simple count down timer and

will count down from the set time till zero (between 30min and 24 hours)

when it will turn off the heater. To set the timer press the Timer

Button then the Plus or Minus buttons to increase or decrease the required

operating time in 30 minute steps. The unit will then operate for the set

time, the timer on the display will count down to zero then turn off,

USING THE THERMOSTAT

The thermostat can be used to regulate the room temperature between

5°C and 37 °C.

Turn on the heater and set to maximum power and maximum temperature.

The heater will then operate at maximum output. When the desired

temperature is reached reduce the Temperature setting on the display by

pushing the Temp button and then the minus button till a click can be

heard. The heater will then switch on and off to keep the room at the

desired temperature. Either the "Eco-750W", "Comfort-1250W" or the

"Super-2000W" setting may be used.

If the temperature control is set to 5 °C, it will operate as a "frost-stat" and

switch the heater on if the temperature drops below 5°C, preventing

damage by frost.

OPERATING COSTS

At time of going to press, the average cost of electricity is £0.12 per unit

(kilowatt-hour). The amount you are being charged will be shown on your

electricity bill.

At this cost, the EH1644/EU will cost £0.09 per hour to run on the "750W"

setting, £0.12 per hour to run on the "1250W" setting and £0.24 per hour

to run on the "2000W" setting with the thermostat set to its maximum.

If the thermostat is used to regulate the temperature the operating costs

will be lower, depending on the room temperature.

FAULT-FINDING

The EH1644/EU has an overheat protection switch, which disconnects the

power if the element gets too hot. The usual reason for this is because the

air-flow has been obstructed, or the grilles have been blocked. If the heater

ceases to operate, leave it for 20 minutes to cool down, then check that the

grilles are not being obstructed.

Switch back on, and check that the unit is operating normally. If not, contact

an authorised service agent for repair.

If the unit is turned off at any time the thermostat will reset to 24°C, if the

room temperature is above this level the unit will not operate. Adjust the

thermostat to the desired temperature.

MAINTENANCE

Before cleaning, turn the heater off, and disconnect from the mains supply.

The heater may then be cleaned using a damp cloth with a drop of washing-

up liquid to remove any dust or dirt from the case. Do no use stronger

detergents or solvents as these may damage the paint finish.

Using a dry 1" (25mm) paint-brush, remove any dust from the grilles.

If the mains lead is damaged, it must be replaced by the manufacturer or

and authorised service centre. If the mains plug needs to be replaced,

proceed as follows:

•Connect the brown wire to the terminal labelled "L".

•Connect the blue wire to the terminal labelled "N".

•Connect the green/yellow wire to the terminal

labelled with the earth symbol or "E".

•Make sure that the cord-grip is positioned correctly

(over the outer sheath of the cable) and it is fully

tightened.

13A

DISPOSAL AND RECYCLING

You must not dispose of this appliance with domestic household waste.

Most local authorities have specific collection system for appliances and

disposal is free of charge to the end-user. When replacing an existing

appliance with a similar new appliance your retailer may take the old

appliance for disposal.

TECHNICAL SPECIFICATION

Dimensions (wall mounting): 590×335×95mm

Dimensions (floor standing): 590×380×210mm

Weight: 3.7kg

Power supply: 230V ~

Power consumption: 2000W

Operating current: 8.7A

SERVICE WARRANTY

Prem-i-Air guarantees the product free from defects in materials and

workmanship for a period of one year.

Should this appliance be operated under conditions other than those

recommended, at voltages other than the voltage indicated on the

appliance, or any attempts made to service or modify the appliance, then

the warranty will be rendered void.

The product you buy may sometimes differ slightly from illustrations. This

warranty is in addition to, and does not affect, your statutory rights.

If you have any problems with this product, please call our Help Desk on

(0845) 459 4816.

Prem-i-Air Appliances Ltd.,

Lancots Lane,

Sutton,

St. Helens,

Merseyside.

WA9 3EX

www.prem-i-air.com

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Prem-I-Air Heizung Handbücher

Prem-I-Air

Prem-I-Air PFH550 Bedienungsanleitung

Prem-I-Air

Prem-I-Air Elite EH1365 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1422 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1404 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1372 Bedienungsanleitung

Prem-I-Air

Prem-I-Air PCH0501 Bedienungsanleitung

Prem-I-Air

Prem-I-Air HQH2000H Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1890 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1896 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1369 Benutzerhandbuch

Prem-I-Air

Prem-I-Air EH1526 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EHO154 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1668 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1710 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1844 Bedienungsanleitung

Prem-I-Air

Prem-I-Air PECCB3200 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH0286 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH0152 Bedienungsanleitung

Prem-I-Air

Prem-I-Air N10Turbo Bedienungsanleitung

Prem-I-Air

Prem-I-Air N10T24 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1442 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH0154 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1582 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1794 Bedienungsanleitung

Beliebte Heizung Handbücher anderer Marken

oventrop

oventrop Regucor Series Bedienungsanleitung

Blaze King

Blaze King CLARITY CL2118.IPI.1 Bedienungsanleitung

ELMEKO

ELMEKO ML 150 Bedienungsanleitung

BN Thermic

BN Thermic 830T Bedienungsanleitung

KING

KING K Series Leitfaden

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Kurzanleitung

Well Straler

Well Straler RC-16B Bedienungsanleitung

EUROM

EUROM 333299 Bedienungsanleitung

Heylo

Heylo K 170 Bedienungsanleitung

Eterna

Eterna TR70W Bedienungsanleitung

Clarke

Clarke GRH15 Bedienungsanleitung

Empire Heating Systems

Empire Heating Systems WCC65 Bedienungsanleitung

Wetekom

Wetekom 92 86 43 Bedienungsanleitung

Desa

Desa SPC170-F Bedienungsanleitung

Watlow

Watlow Watrod Electric Tubular Heaters Bedienungsanleitung

Haverland

Haverland ECO-DRY GPS Series Stücklistenhandbuch

Stelpro

Stelpro ASILVC2060 Series Bedienungsanleitung

iLO

iLO IHP2424 Betriebsanleitung