Prem-I-Air EH1668 Bedienungsanleitung

Page 1

EH1668

1.5kW PTC Fan Heater with PIR

Radiateur Soufflant 1.5kW

Page 2

IMPORTANT

Installer and Users please note:

These instructions should be read carefully and left with the user of the product for

future reference.

INSTALLATION

Place the EH1668 on a firm flat surface at least 20cm (8") from a wall. Ensure that

the air inlets (at the back) and the air outlets (on the front) are not obstructed.

This appliance can be used by children aged from 8 years and above

and persons with reduced physical, sensory or mental capabilities or lack of

experience and knowledge if they have been given supervision or instruction

concerning use of the appliance in a safe way and understand the hazards

involved.

Children shall not play with the appliance.

Cleaning and user maintenance shall not be made by children without

supervision

Do not direct the hot air output towards curtains or soft furnishings.

Leave a gap of at least 100mm (4") at the sides of the heater.

Do not place on soft surfaces.

Do not cover. This symbol shown on the casing of the heater

means that the heater should not be covered.

Do not use outdoors.

Do not use in bathrooms, or in wet or damp locations.

Do not place the mains lead beneath a carpet or rug.

Do not use the heater in locations where paint, petrol or other flammable liquids

are used or stored.

Do no insert any object into the heater through the grilles. This may damage

the heater or result in overheating or electric shock.

If the unit is not to be used turn off at the switch at the rear of the unit and

disconnect from the mains supply.

Page 3

OPERATION

Plug the mains lead into a 13 Amp mains socket.

If connecting via an extension lead, make sure that the lead is rated at 13 Amps or

more, and that it is fully unwound.

Switch the unit on at the mains socket.

Turn the power to the unit on at the switch on the rear (Fig

1.) the unit will beep and the display (Fig 4) will show “--“.

The unit is in standby mode, to turn on press the mode

button (Fig 2) on the top of the unit (Fig 3).

When first turned on the heater will be in LO power mode and the

thermostat is set at 23°C (Fig 3.). Repeatedly pressing the mode button will cycle

through the running modes in order LO –HI –ECO –OFF, these

modes are described in detail further below.

Thermostat Setting: As mentioned above the thermostat is set to

the default value of 23°C, to change the desired temperature press

the or buttons (Fig 3) till the desired temperature is

achieved. The value can be between 5°C and 30°C in 1°C

intervals.

Mode Functions:

LO –LO shows on the display Fig 4.

Heater runs at LO Power (750W) till the

desired temperature set on the

thermostat is reached, at this point the

heater and fan will stop for a minimum

of 30 seconds. After this time if the

room temperature has dropped below

the thermostat temperature the unit will

resume at LO power otherwise it will

remain in standby mode till the room temperature drops sufficiently.

HI –HI shows on the display Fig 4. Heater runs at HI Power (1500W) till

the desired temperature set on the thermostat is reached, at this point

the heater and fan will stop for a

minimum of 30 seconds. After this time if

the room temperature has dropped

below the thermostat temperature the

unit will resume at HI power otherwise it

will remain in standby mode till the room

temperature drops sufficiently.

ECO –ECO shows in the display, Fig 4.

In ECO mode the unit has two separate

functions.

1. Temperature Control. The unit selects the appropriate power

according to the differential between the room temperature and

the set thermostat temperature. If the room temperature is more

than 1.5°C lower than the thermostat temperature the unit will

Fig 1

Fig 4

Fig 3

Fig 2

Page 4

operate at HI power (1500W). When the room temperature is

less than 1.5°C lower than the thermostat temperature the unit

will then operate at LO power (750W). When the room is at the

desired temperature the heater and fan will stop for a minimum

of 30 seconds. After this time if the room temperature has

dropped below the thermostat temperature the unit will resume

at LO power otherwise it will remain at standby mode till the

room temperature drops sufficiently for the heater to resume.

2. Room Occupation. In ECO mode the PIR sensor is used to

detect the presence of people within the room. The unit will

operate as normal (see point 1 above) until no movement has

been detected for more than 10 minutes. After 10 minutes with

no movement the thermostat will reduce by 3°C. If after 24

hours there is still no movement the thermostat will reduce to

7°C. If at this point the heater detects movement for more than

1 minute it will beep and the thermostat will return to the set

temperature and continue operation.

Timer setting: The heater has an optional timer, to access the timer press the up

and down buttons simultaneously for more than 3s, the display will show 0.

You can use the arrow buttons to set the operating time for the unit in 1 hour

intervals between 0 - 24hrs. The display will return to normal showing the

thermostat temperature if no button is pressed for more than 5s. Once the

countdown time has elapsed the unit will switch off and return to standby mode.

When the heater is used for the first time you may notice that the unit emits a little

smoke, this is normal and will stop after a few minutes. Do not touch the air output

grille when the heater is in operation, because it will be hot and may cause burns.

Unplug the heater from the mains supply when not in use.

Page 5

OPERATING COSTS

At time of going to press, the average cost of electricity is £0.13 per unit (kilowatt-

hour). The amount you are being charged will be shown on your electricity bill.

At this cost, the EH1668 will cost £0.09 per hour to run at the low setting and £0.19

per hour on the hot air setting. Use of the thermostat and eco function will reduce

this figure.

MAINTENANCE

Before cleaning, turn the heater off, and disconnect from the mains supply. The

heater may then be cleaned using a damp cloth with a drop of washing-up liquid to

remove any dust or dirt from the case. Do no use stronger detergents or solvents

as these may damage the paint finish.

Using a dry 1" (25mm) paint-brush, remove any dust from the grilles.

The EH1668 has a dust filter fitted to

the air intake on the rear of the unit. To

clean follow the instructions below;

1. Remove the 2 screws holding

the filter cover in position

2. Pull cover gently away from

the rear of the unit.

3. Gently clean the foam filter,

this can be done using warm

water with a small amount of

detergent added.

4. Thoroughly air dry the filter

foam and replace in heater.

5. Replace the screws holding

the cover in position.

If the mains lead is damaged, it must be replaced by the

manufacturer or an authorised service centre. If the

mains plug needs to be replaced, proceed as follows:

Connect the brown wire to the terminal labelled "L".

Connect the blue wire to the terminal labelled "N".

Make sure that the cord-grip is positioned correctly

(over the outer sheath of the cable) and it fully tightened.

If the plug is fitted with a 3 A or 5 A fuse, replace it

with a 13A fuse.

13A

Screw

Pull

Page 6

FAULT-FINDING

The EH1668 has an overheat protection switch, which disconnects the power if the

element gets too hot. The usual reason for this is because the air-flow has been

obstructed, or the grilles have been blocked. If the heater ceases to operate, leave

it for 20 minutes to cool down, then check that the grilles are not being obstructed.

If there appears to be excessive dust or dirt build up on the air filter refer to

maintenance section above on how to clean.

Reconnect to the mains supply and operate as per the user instructions for the LO

heatsetting.If the fan operates, then it is safeto select the high heat or ECO setting.

If the fan does not operate, or overheat protection switch operates again, contact

an authorised service agent for repair.

The EH1668 has an additional tilt switch to prevent the unit being powered up in

any other position than upright. If the unit does not operate ensure it is placed on a

firm level surface and is not tilted in any way.

TECHNICAL SPECIFICATION

EH1668

Dimensions

264x120x310mm

Weight

2.6kg

Power Supply

230V ~

Power Consumption

750/1500W

Operating Current

3.2/6.5A

DISPOSAL AND RECYCLING

You must not dispose of this appliance with domestic household waste.

Most local authorities have specific collection system for appliances and disposal

is free of charge to the end-user.

When replacing an existing appliance with a similar newappliance your retailer may

take the old appliance for disposal.

Page 7

SERVICE WARRANTY

Prem-i-Air guarantees this Elite product free from defects in materials and

workmanship for a period of two years. Should this appliance be operated

under conditions other than those recommended, at voltages other than the

voltage indicated on the appliance, or any attempts made to service or modify

the appliance, then the warranty will be rendered void.

The product you buy may sometimes differ slightly from illustrations.

This warranty is in addition to, and does not affect, your statutory rights.

Our guarantee is administered by our retailers.

If your product arrives damaged, you must contact the retailer from whom you

bought it. The retailer's contact details will be on the invoice that arrived with

the product, or on the e-mail you received when you placed the order. Do not

contact Prem-i-air, only your retailer can arrange a replacement.

If your product fails within the guarantee period, firstly read the "fault

finding" section of this manual, because temperature and weather conditions

can affect the performance of certain products. If the product needs to be

repaired or replaced, you must contact the retailer from whom you bought it.

The retailer's contact details will be on the invoice that arrived with the product,

or on the e-mail you received when you placed the order.

If you have just received your product and require technical help in using

it, please call our Help Desk on (0845) 459 4816

If you have any other technical queries about the product, please call our Help

Desk on (0845) 459 4816.

Prem-i-Air Appliances Ltd.,

Lancots Lane, Sutton,

St. Helens, Merseyside.

WA9 3EX

www.prem-i-air.com

Inhaltsverzeichnis

Andere Prem-I-Air Heizung Handbücher

Prem-I-Air

Prem-I-Air EH1442 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1710 Bedienungsanleitung

Prem-I-Air

Prem-I-Air HQH2000H Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH0153 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1842 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH0152 Bedienungsanleitung

Prem-I-Air

Prem-I-Air PCH0501 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH0286 Bedienungsanleitung

Prem-I-Air

Prem-I-Air PFH0130R Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1550 Bedienungsanleitung

Prem-I-Air

Prem-I-Air HT2007 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1710 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1844 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH0287 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1582 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1426 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EHO154 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1644 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1890 Bedienungsanleitung

Prem-I-Air

Prem-I-Air Elite EH1365 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1674 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1688 Bedienungsanleitung

Prem-I-Air

Prem-I-Air N10Turbo Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1436 Bedienungsanleitung

Beliebte Heizung Handbücher anderer Marken

oventrop

oventrop Regucor Series Bedienungsanleitung

Blaze King

Blaze King CLARITY CL2118.IPI.1 Bedienungsanleitung

ELMEKO

ELMEKO ML 150 Bedienungsanleitung

BN Thermic

BN Thermic 830T Bedienungsanleitung

KING

KING K Series Leitfaden

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Kurzanleitung

Well Straler

Well Straler RC-16B Bedienungsanleitung

EUROM

EUROM 333299 Bedienungsanleitung

Heylo

Heylo K 170 Bedienungsanleitung

Eterna

Eterna TR70W Bedienungsanleitung

Clarke

Clarke GRH15 Bedienungsanleitung

Empire Heating Systems

Empire Heating Systems WCC65 Bedienungsanleitung

Wetekom

Wetekom 92 86 43 Bedienungsanleitung

Desa

Desa SPC170-F Bedienungsanleitung

Watlow

Watlow Watrod Electric Tubular Heaters Bedienungsanleitung

Haverland

Haverland ECO-DRY GPS Series Stücklistenhandbuch

Stelpro

Stelpro ASILVC2060 Series Bedienungsanleitung

iLO

iLO IHP2424 Betriebsanleitung