Prem-I-Air EH1436 Bedienungsanleitung

EH1436

2kW Convector Heater with Turbo Fan

Radiateur Convecteur 2 kW

avec Ventilateur Turbo

•3 Heat settings

•Adjustable room

thermostat

•Turbo fan

•Convenient built-in

carrying handle

•Safety overload cut-out

•3 Vitesses

•Thermostat Réglable

•Ventilateur Turbo

•Poignée de Transport

très Pratique

•Coupure de Sécurité

en cas de Surchauffe

Page 1

IMPORTANT

Installer and Users please note:

These instructions should be read carefully and left with the

user of the product for future reference.

INSTALLATION

For free-standing use: attach the feet to the underneath of

the heater using the four 12 mm (½") screws. The feet at

end of the case.

To wall-mount: Referring to the diagram opposite, draw

two horizontal lines on the wall 305 mm (12") apart, the

lower line more than 50 mm (2") from the floor.

On the upper line, drill holes 208 mm (8¼") from the centre

line, using a 6mm (¼") masonry bit, and insert a wall plug.

On the lower line, drill holes 254 mm (10") from the centre

line using a 6mm (¼") masonry bit, and insert a wall-plug.

Fix the two hook-brackets to the upper holes using the 30

mm (1¼") screws.

Fix the two L-shaped brackets to the underside of the

heater using the 12 mm (½") screws through the round hole

in the bracket - the oval hole in the bracket locates over the

screw that fixes the case together,

Hang the heater on the hook-brackets using the two slots.

The L-shaped brackets will now line up with the lower holes

in the wall. Attach to the wall using the other two 30 mm

(1¼") screws.

Page 2

305mm

208mm 208mm

254mm254mm

Page 3

PRODUCT SAFETY

•This appliance can be used by children aged from 8

years and above and persons with reduced physical,

sensory or mental capabilities or lack of experience and

knowledge if they have been given supervision or instruction

concerning use of the appliance in a safe way and

understand the hazards involved.

•

Children shall not play with the appliance.

•Place the appliance on a firm flat surface.

•Ensure that there is at least 300mm (1') between the sides

of the appliance and any flammable materials

•Ensure that there is at least 900mm (3') from the top of the

appliance and any flammable materials.

•Do not place on soft surfaces.

•Do not cover. This symbol shown on the casing of

the appliance means that the appliance should not be

covered.

•Do not use with a programmer, timer, remote control

system or other device that switches the heater on auto

matically (because a fire risk exists if the heater is incorrectly

positioned or covered)

•Do not use outdoors.

•Do not use in a moving vehicle, boat or ship.

•Do not use in the immediate surroundings of a bath, a

shower or a swimming pool.

•Do not use in bathrooms, or in wet locations.

•Do not place the mains lead beneath a carpet or rug.

•Do not use the appliance in locations where paint, petrol or

other flammable liquids are used or stored.

•Do not use the appliance without the feet attached.

•Do not locate the appliance immediately below a socket

outlet

Page 4

PAT TESTING

When used in an office environment, this product must be

safety-tested yearly by a qualified electrician (PAT Tested) in

order to comply with the Electricity at Work Regulations.

It is good practice that appliances are regularly PAT tested

when used in a domestic environment.

GENERAL SAFETY REQUIREMENTS

Domestic wiring must be tested periodically by a qualified

electrician at least once every 10 years or at every change of

occupancy. For office and retail premises, and buildings such

as village halls, the wiring must be inspected at least once

every 5 years.

It is recommended that all building be fitted with smoke

alarms (it is mandatory for new buildings).

OPERATION

Plug the mains lead into a 13 Amp mains socket.

If connecting via an extension lead, make sure that the lead

is rated at 10 Amps or more, and that it is fully unwound.

Switch the unit on at the mains socket.

Use the two switches on the side to select the required

operation:

•750 W switch on = Low Heat (750 W)

•1250W switch on = Medium heat (1250 W)

•Both switches on = High Heat (2000 W)

Do not touch the air output grille when the heater is in

operation, because it will be hot and may cause burns.

Unplug the heater from the mains when not in use.

Page 5

USING THE THERMOSTAT

The thermostat can be use to regulate the room temperature.

Turn both switches on (high heat), and rotate the

temperature control fully clockwise.

The heater will then operate at maximum output. When the

desired temperature is reached, rotate the temperature

control anticlockwise until a click is heard. The heater will

then switch on and off to keep the room at the desired

temperature. The indicator lights in the switches will show

that this is happening. Any of the heat setting may be used.

If the temperature control is rotated fully anticlockwise to the

snowflake symbol, it will operate as a "frost-stat" and switch

the heater on if the temperature drops below 4°C, preventing

damage by frost.

USING THE TURBO FAN

The Turbo Fan assists the natural convection to heat the

room more quickly. Turn on the turbo fan when required

using the switch with the fan symbol.

MAINTENANCE

Before cleaning, turn the heater off, and disconnect from the

mains supply. The heater may then be cleaned using a damp

cloth with a drop of washing-up liquid to remove any dust or

dirt from the case. Do no use stronger detergents or solvents

as these may damage the paint finish.

Using a dry 1" (25mm) paint-brush, remove any dust from the

grilles.

If the mains lead is damaged, it must be replaced by the

manufacturer or and authorised service centre. If the

mains plug needs to be replaced,proceed as follows:

Page 6

•Connect the brown wire to the

terminal labelled "L".

•Connect the blue wire to the

terminal labelled "N".

•Connect the green/yellow wire

to the terminal labelled with the

earth symbol or "E".

•Make sure that the cord-grip is

positioned correctly (over the

outer sheath of the cable) and it

fully tightened.

OPERATING COSTS

At time of going to press, the average cost of electricity is

£0.12 per unit (kilowatt-hour). The amount you are being

charged will be shown on your electricity bill.

At this cost, the EH1436 will cost 10p per hour to run on the

"low heat " setting, 15p per hour to run on the "medium heat"

setting, and 23p per hour to run on the "high heat" setting

with the thermostat set to its maximum.

If the thermostat is used to regulate the temperature the

operating costs will be lower, depending on the room

temperature. Use of the turbo fan makes very little difference

to the operating cost.

FAULT-FINDING

The appliance has an overheat protection switch, which

disconnects the power if the element gets too hot. The usual

reason for this is because the air-flow has been obstructed,

or the grilles have been blocked. If the heater ceases to

operate, leave it for 20 minutes to cool down, then check that

the grilles are not being obstructed.

Switch back on, and check that the unit is operating normally.

If not, contact an authorised service agent for repair.

Page 7

DISPOSAL AND RECYCLING

You must not dispose of this appliance with domestic

household waste.

Most local authorities have specific collection system for

appliances and disposal is free of charge to the end-user.

When replacing an existing appliance with a similar new

appliance your retailer may take the old appliance for

disposal.

TECHNICAL SPECIFICATION

Dimensions (floor standing): 585×425×200 mm

Dimensions (wall mounting): 585×425×108 mm

Weight: 3.3 kg

Power supply: 230 V ~

Power consumption: 2000 W

Operating current: 8.7 A

Page 8

SERVICE WARRANTY

Prem-i-Air guarantees the product free from defects in

materials and workmanship for a period of twelve months.

Should this unit be operated under conditions other than

those recommended, at voltages other than the voltage

indicated on the unit, or any attempts made to service or

modify the unit, then the warranty will be rendered void.

The product you buy may sometimes differ slightly from

illustrations. This warranty is in addition to, and does not

affect, your statutory rights.

If you have any problems with this product, please call our

Help Desk on (0845) 459 4816.

Prem-i-Air Appliances Ltd.,

Lancots Lane,

Sutton Oak,

St. Helens,

Merseyside.

WA9 3EX

website: www.prem-i-air.com

Page 9

IMPORTANT

Installateurs et Utilisateurs, veuillez noter :

Vous devez mire attentivement cette notice et la conserver

pour une éventuelle future consultation.

INSTALLATION

•Pour une utilisation autonome au sol : Fixez les pieds sous

le radiateur en utilisant les quatre vis 12mm. Chaque pied se

place à chaque bout du radiateur.

•Pour une installation murale : En vous référant au schéma

fourni, tracez deux lignes horizontales

•distantes de 305 mm sur le mur, la ligne du bas devant être

tracée à plus de 50 mm du sol.

•Sur la ligne du haut, percez des trous à 208 mm de l'axe

central, en utilisant un foret à maçonnerie de 6 mm puis

insérez une cheville murale.

•Sur la ligne du bas, percez des trous à 254 mm de l'axe

central, en utilisant un foret à maçonnerie de 6 mm puis

insérez une cheville murale.

•Fixez les deux crochets fournis sur les trous supérieurs en

utilisant des vis de 30 mm.

•Fixez les deux supports en forme de L sur la face inférieure

du radiateur à l'aide des vis 12 mm qui passeront au travers

du trou rond du support „ le trou ovale du support qui se

situe au-dessus de la vis maintient le boîtier.

•Accrochez le radiateur sur le support en utilisant les deux

fentes.

•Le support en forme de L doit être aligné avec les trous

inférieurs percés dans le mur.

•Fixez au mur en utilisant les deux autres vis de 30 mm.

Page 10

Inhaltsverzeichnis

Sprachen:

Andere Prem-I-Air Heizung Handbücher

Prem-I-Air

Prem-I-Air EHO154 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1369 Benutzerhandbuch

Prem-I-Air

Prem-I-Air EH1404 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1524 Handbuch

Prem-I-Air

Prem-I-Air EH1558 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1372 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1840 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1710 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH0154 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1688 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1422 Bedienungsanleitung

Prem-I-Air

Prem-I-Air C307 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1890 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH0287 Bedienungsanleitung

Prem-I-Air

Prem-I-Air Elite EH1365 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1530 Bedienungsanleitung

Prem-I-Air

Prem-I-Air N10T24 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1710 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1712 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1846 Bedienungsanleitung

Prem-I-Air

Prem-I-Air HT2007 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH0152 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH1674 Bedienungsanleitung

Prem-I-Air

Prem-I-Air EH0291 Bedienungsanleitung

Beliebte Heizung Handbücher anderer Marken

oventrop

oventrop Regucor Series Bedienungsanleitung

Blaze King

Blaze King CLARITY CL2118.IPI.1 Bedienungsanleitung

ELMEKO

ELMEKO ML 150 Bedienungsanleitung

BN Thermic

BN Thermic 830T Bedienungsanleitung

KING

KING K Series Leitfaden

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Kurzanleitung

Well Straler

Well Straler RC-16B Bedienungsanleitung

EUROM

EUROM 333299 Bedienungsanleitung

Heylo

Heylo K 170 Bedienungsanleitung

Eterna

Eterna TR70W Bedienungsanleitung

Clarke

Clarke GRH15 Bedienungsanleitung

Empire Heating Systems

Empire Heating Systems WCC65 Bedienungsanleitung

Wetekom

Wetekom 92 86 43 Bedienungsanleitung

Desa

Desa SPC170-F Bedienungsanleitung

Watlow

Watlow Watrod Electric Tubular Heaters Bedienungsanleitung

Haverland

Haverland ECO-DRY GPS Series Stücklistenhandbuch

Stelpro

Stelpro ASILVC2060 Series Bedienungsanleitung

iLO

iLO IHP2424 Betriebsanleitung