
P1752/P2000/P2002/15905C Embedded Staff
Control. REV001,Jul y 28th,2015
The information in this document is subject to change without notice.
2. Remove bypass plug from thecontrol box. Bypass plug is the one without a cord to the far right.
NOTE: The bed will not function without the bypass plug or the staff control being plugged into
the control box.
3. Plug the male end of the extension cable into the control box where the bypass plug was
removed.
4. Route the cable over the top of control box inside the wire channel. Secure cable in position with
cables ties.
5. Fasten the female end of the extension cable in the center of the bed on the foot-end frame
tube. Excess cable must be secured to bedframe in the wire channel. Ensure when the
footboard control panel cable is connected to the extension cable it does not create a trip
hazard.