
DOC-040-2350 PCB901 Rotating Half Rail Instructions| REV 001
The information in this document is subject to change without notice.
Cleaning Instructions:
WARNING
If cleaning assist bars while still mounted to the bed frame, all bed frame cleaning
instructions must be followed.
•Prior to cleaning unplug power supply cords
•Sanitize and wash all components. DO NOT submerge the assist bars.
•Use standard water pressure. DO NOT power wash or steam clean any parts
•Rinse completely with water (Maximum temperature 110oF or 43oC). Solvents,
alcohol or petroleum should not be used on the bed.
•Make sure all parts are dry before using or storing
NOTE: THIS DEVICE IS NOT COMPATIBLE WITH WASHDOWN TUNNELS
Inspections:
WARNING
Failure to take care of your device may decrease the life of your product and increase
maintenance.
Always inspect and service the device at the required intervals.
INITIAL INSPECTION
•Inspect All Components.
•Check components for obvious damage.
•Verify proper function.
Quarterly Maintenance Check
•Inspect all welds for cracks.
•Ensure proper function of the device.
•Inspect all fasteners for looseness and wear. Replace or tighten as necessary.
•Ensure no tubes are bent.
ADVICE TO RESPONSIBLE ORGANIZATION
•Carry out all adjustment and cleaning procedures specified.
•Assembly of this device and modifications made during the actual service life
require evaluation to the requirements of IEC 60601-1 and IEC 60601-2-52.
•Dispose of this device following all local rules and regulations.