Proaction CJ021 Bedienungsanleitung

Instruction Manual - Please keep for future reference

Proaction 1600W Cylinder Vacuum

CJ021

8-04

"Read all instruction before use" and keep for future reference.

IMPORTANT SAFETY INSTRUCTIONS

Location

• Do not use or keep the item outside.

• Do not store the appliance near hot ovens or heating appliances.

• Store the appliance inside in a dry environment away from accidental damage.

Mains lead

• Do not allow the mains lead to become strained or run this appliance over it.

• If the electrical cable becomes damaged, stop using the machine immediately. The

unit must be returned to a qualified service engineer for repair.

Children

• Children do not understand the dangers associated with operating electrical

appliances. Never allow children to use this appliance.

Other safety considerations

• Never use the appliance without the filter installed.

• Never use the appliance to vacuum hot ashes, broken glass, sharp objects or liquids.

• Never use in the presence of explosive liquids or vapours.

• Never pick up inflammable or poisonous liquids such as petrol, copier toner, or other

volatile substances. Never pick up acids, asbestos or asbestos dust.

• Always disconnect the appliance from the mains supply after use or prior to cleaning

or replacing dust bags.

• The appliance should never be left running unsupervised.

• Never modify the cleaner in any way.

• Repairs to electrical appliances are only to be undertaken by trained personnel.

• Unprofessional repairs can be dangerous.

• Use only genuine Proaction spare parts and accessories.

• Never handle electrical appliances with wet hands.

Electrical requirements

Check that the voltage on the rating plate of your appliance corresponds with your

house electricity supply which must be A.C. (Alternating Current).

If the socket outlets in your home are not suitable for the plug supplied with this

appliance, check with a qualified electrician for replacement.

WARNING: If the plug is removed or the mains cable is severed this unit must

be destroyed as it creates a hazard.

Should the fuse in the 13 amp plug require replacement, a BS1362 13 amp fuse must

be fitted.

Overheating safety device

Your vacuum cleaner is fitted with a safety device that switches off the vacuum cleaner

in the event of overheating. Should the vacuum cleaner stop working, turn the vacuum

cleaner off and inspect for blockage of the air inlet or outlet. Wait at least 15 minutes

for the protection system to reset before attempting to restart the vacuum cleaner. If

the vacuum cleaner fails to operate or the safety device switches the vacuum cleaner

off again, return it to your nearest service center for examination or repair.

1 x Vacuum Hose

1 x Vacuum Cleaner 3

CONTENTS KNOW YOUR MACHINE

1 x Suction Tube

2 x Dust Bag

1 x Floor Head

1 x Crevice Nozzle

1 x Upholstery Head

Know Your Machine ..........................................................................................3

Assembly ...........................................................................................................4

Operation ...........................................................................................................6

Changing the Dust Bag ....................................................................................8

Cleaning the Filter .............................................................................................9

Nozzle Accessories ..........................................................................................11

Trouble Shooting ..............................................................................................11

Specifications ....................................................................................................12

JFloor Type Selector

HExtension Tube

FHose

Handle

GHandle

Suction

Control

CHose

Connector

DFitting Hook

EFlexible

Hose

OPower

Indicator

NOn/Off

Button

RDustbag

Indicator

SHose

Inlet

UCarry Handle

Cover

Button

QPower

Regulator

Button Cable Rewind

Button

IMPORTANT:

Please read the important safety

instructions before use.

fig. 1

fig. 2

fig. 3

fig. 4

ASSEMBLY

NOTE: Always remove the plug

from the mains power before

fitting or removing accessories.

ASSEMBLY

1. Insert the Hose Connector C into

the Hose Inlet S until it clips

securely into position. (To remove

the Vacuum Hose from the

Vacuum Cleaner, press the Fitting

Hook D then pull upwards.)

See fig. 1.

3. Attach the end of the Suction Tube

Ato the Hose Handle F of the

Vacuum Hose B.

See fig. 3.

4. Fit the Floor Head I onto the end

of the Extension Tube H.

See fig. 4.

5. Upholstery Head L and Crevice

Nozzle K are stored inside the

Vacuum Cleaner Body V.

Depending on the cleaning task,

Upholstery Head L and Nozzle K

can either be fitted to the Extension

Tube H or directly onto the

Handle.

2. Rotate the Extension Tube H

clockwise and pull out to desired

length. Lock it by rotate anti-

clockwise ensuring it is securely

located. 

See fig. 2.

Fitting the Heads

CAUTION:

Pull out the cable to the

maximum length indicated with

the yellow mark. Never pull the

cable out to the red mark as the

cable winding mechanism can

be damaged.

fig. 5

fig. 6

fig. 7

fig. 8

fig. 9

OPERATION OPERATION

1. Pull out the cable to the desired

length. Do not over extend.

3. Press On/Off Button N to start

the vacuum cleaner. To stop it

press the On/Off Button N again.

The Power Indicator O will

illuminate when the power is on.

See fig. 5.

2. Plug into the mains socket.

Controlling Suction Power

1 Suction Power can be adjusted

using the Handle Suction Control

G. Keep it closed for full suction

and open for reduced suction.

See fig. 6.

2. Slide the Power Regulator Button

Qto adjust the power of the unit.

See fig. 7.

NStorage

1. When you have switched off and

unplugged the appliance, press

the Cable Rewind Button P to

automatically rewind the cable.

See fig. 8.

2. Hook the Suction Tube A into the

slot provided at the base of the

Cleaner.

See fig. 9.

3. Store according to the Safety

Instructions.

IMPORTANT:

fig. 14

fig. 10

fig. 12

fig. 13

NOTE:

CHANGING THE DUST BAG CLEANING THE FILTER

NOTE: Failure to keep the filters

clean, will result in a loss of

performance.

Cleaning the Motor Filter

Replacing the Dust Bag

1. Unplug the Cleaner from the mains

socket.

3. Open the lid of the dust bag

compartment by pressing the Cover

Button T.

See fig. 11.

4. Carefully remove the Dust Bag M.

Re-insert a new bag and close the

lid so that it locks in place. Ensure

the Dust Bag is securely fitted

inplace.

See fig. 12.

1. Open the lid of the dust bag

compartment by pressing the

Cover Button T.

See fig. 13.

3. Remove the Motor Filter and clean

in warm soapy water. Ensure the

Exhaust Filter is totally dry before

assembly.

See fig. 14.

2. Remove the Bag. See CHANGING

THE DUST BAG on previous page.

See fig. 12.

4. Replace the Motor Filter in the

same way.

2. Remove the Vacuum Hose from

the Vacuum Cleaner by pressing

on the Fitting Hook D then pull

upwards.

See fig. 11.

Never use the appliance without

the motor filter protection and

exhaust filter installed, otherwise

damage to the product may

occur which would not be

covered by the guarantee.

fig. 11

Motor Filter

To obtain the best result from

your cleaner the dust bag needs

to be replaced regularly,

otherwise the airflow and

cleaning power will be reduced.

When the Dustbag Indicator R

shows fully red and

performance deteriorates it is

necessary to replace the dust

bag. Always check if there are

any blockages in the

accessories or tubes and follow

the filter cleaning instructions

for optimum performance.

See fig. 10.

Never replace wet filters in the

machine as this will create an

electrical hazard.

1110

PROBLEM CORRECTION

Machine does not work.

The Suction performance is

reduced.

fig. 15

fig. 16

CLEANING THE FILTER

NOTE: We recommend cleaning

the Motor Filter and Exhaust

Filter at the same time at regular

periods.

NOZZLE ACCESSORIES

Cleaning the Exhaust Filter

1. Remove the Exhaust Filter and

clean in warm soapy water. Ensure

the Exhaust Filter is totally dry

before assembly.

See fig. 15.

2. Replace the Exhaust Filter in the

same way.

See fig. 16.

TROUBLE SHOOTING

- Check that the appliance is correctly

plugged in and that the electrical socket

is working.

- Check fuse or breaker switch.

- Take it to the authorized service centre.

- Stop the appliance and unplug it.

- Check the Tubes, Hose and Cleaning

tools are not blocked.

- Check the Dust Bag is not full.

- Check the Filters and clean them.

Exhaust Filter

Crevice Nozzle

Floor Type

Selector

To vacuum corners and slots.

Upholstery Head

Fit the accessories to match your cleaning requirements

Adjust the selectors to fit your

requirement:

To clean upholstery, curtains, etc.

Floor Head Carpet or rug position:

To clean carpets, rug or smooth

surfaces.

Hard floor position:

To clean tiles, parquet or hard floor.

Exhaust Filter

NOTE:

Never replace wet filters in the

machine as this will create an

electrical hazard.

SPECIFICATIONS

IMPORTANT

The wires in this mains lead are coloured as follows:

Blue-Neutral

Brown-Live

As the colours of the wires in the mains lead of this

apparatus may not correspond with the coloured

markings identifying the terminals in your plug,

proceed as follows:

The wire which is coloured blue must be connected

to the terminal, which is marked with N or coloured blue. The wire which is coloured

brown must be connected to the terminal which is marked L or coloured brown.

Always ensure that the plug cord grip is fastened correctly. If a 13A (BS1363)

fused plug is used it must be fitted with a 13A fuse conforming to BS1362 and

be ASTA approved. If in doubt contact a qualified electrician.

Technical Data

Model no.  CJ021

Voltage 230VAC-50Hz

Power Consumption 1400W nom, 1600W max

If you need to replace the fitted plug.

Plug Replacement

WARNING :

Never connect live or neutral wires to the earth terminal of the plug.

Only fit an approved 13 Amp BS1363/A plug and the correct rated fuse.

If in doubt, consult a qualified electrician.

BROWN

(LIVE)

CABLE

GRIP

BLUE

(NEUTRAL)

Check that the voltage marked on the product corresponds with your supply voltage.

This product is fitted with a 13A plug complying with BS1363. If this plug is unsuitable

or needs to be replaced, please note the following :

Connecting to Power PRODUCT GUARANTEE

This product is guaranteed against manufacturing defects for a period of

This product is guaranteed for twelve months from the date of original purchase. Any

defect that arises due to faulty materials or workmanship will either be replaced,

refunded or repaired free of charge where possible during this period by the dealer

from whom you purchased the unit.

The guarantee is subject to the following provisions:

-  The guarantee does not cover accidental damage, misuse, cabinet parts, knobs

or consumable items.

-  The product must be correctly installed and operated in accordance with the

instructions contained in this manual.

-  It must be used solely for domestic purpose.

-  The guarantee will be rendered invalided if the product is re-sold or has been

damaged by inexpert repair.

-  Specifications are subject to change without notice.

-  The manufacturer disclaims any liability for the incidental or consequential damages.

-  The guarantee is in addition to, and does not diminish your statutory or legal rights.

Guarantor: Argos Ltd

489 - 499 Avebury Boulevard

Central Milton Keynes

MK9 2NW

Year

Inhaltsverzeichnis

Andere Proaction Staubsauger Handbücher

Proaction

Proaction VC9340S-6 Bedienungsanleitung

Beliebte Staubsauger Handbücher anderer Marken

Bissell

Bissell LittleGreen Proheat 1425 Series Bedienungsanleitung

Panasonic

Panasonic MC-YL637S147-AE Bedienungsanleitung

NEFF

NEFF N17XH10 0 Series Bedienungsanleitung

LG A9 Series Bedienungsanleitung

Oreck

Oreck Cordless Captura BK51700 Series Bedienungsanleitung

Kogan

Kogan KAVACROBVWA Bedienungsanleitung

Kränzle

Kränzle VENTOS 50 ID Benutzerhandbuch

EVVO

EVVO Ai35 Bedienungsanleitung

DeWalt

DeWalt DWH200D Bedienungsanleitung

Pontec

Pontec Pondomatic Vacuum Cleaner Bedienungsanleitung

Cleanmaxx

Cleanmaxx PC-P007E Bedienungsanleitung

Exido

Exido 240-114 Bedienungsanleitung

RIDGID

RIDGID WD1685AU0 Bedienungsanleitung

Ezviz

Ezviz RE4P Bedienungsanleitung

STG global

STG global TANVAC HDV3000 Bedienungsanleitung

Shark

Shark ROTATOR PRO COMPLETE NV550 Series Bedienungsanleitung

Factory

Factory M3340 Bedienungsanleitung

Shop-Vac

Shop-Vac VN92 SERIES Bedienungsanleitung