Prolon T1000 Series Montageanleitung

HARDWARE GUIDE

Digital Sensor - T1000 Series

Specifications and Operational Guide

REV. 6.2.3

PL-HRDW-T1000-F-EN

www.proloncontrols.com |info@proloncontrols.com

17 510, rue Charles, Suite 100, Mirabel, QC, J7J 1X9

REV. 6.2.3 / PL-HRDW-T1000-F-EN

Table of Contents

General Information............................................................................................................................ 4

Description ..................................................................................................................................................................... 4

Part Number Selection ................................................................................................................................................ 4

Installation ..........................................................................................................................................5

Power and Communication.................................................................................................................6

Auxiliary Analog Input ................................................................................................................................................ 6

Operation.............................................................................................................................................7

Hint Display .................................................................................................................................................................... 7

Changing the Setpoint ........................................................................................................................ 8

Schedule Override...............................................................................................................................8

Navigating Menus ...............................................................................................................................9

Menu Structure.................................................................................................................................. 10

T1000 Options and Visualisation Menus............................................................................................................... 10

VAV Controller: Visualisation Displays ................................................................................................................... 11

VAV Controller: Configuration Menus (Top Level).............................................................................................. 11

VAV Controller: Configuration Menus - Temperature........................................................................................ 12

VAV Controller: Configuration Menus - Damper................................................................................................. 12

VAV Controller: Configuration Menus - Pressure................................................................................................ 13

VAV Controller: Configuration Menus - Outputs ................................................................................................ 13

VAV Controller: Configuration Menus - Radiant Floor.......................................................................................14

VAV Controller: Configuration Menus - Other.....................................................................................................14

VAV Controller: Configuration Menus - Calibration........................................................................................... 15

VAV Controller: Configuration Menus - Network................................................................................................16

Technical Specifications.................................................................................................................... 17

Compliance ........................................................................................................................................ 18

FCC User Information.................................................................................................................................................18

Industry Canada .........................................................................................................................................................18

Overall Dimensions ........................................................................................................................... 19

REV. 6.2.3 / PL-HRDW-T1000-F-EN

Table of Figures

Figure 1 - Opening Tab ..................................................................................................................................................... 5

Figure 2 - Terminal Block Pinout .................................................................................................................................... 5

Figure 3 - Terminal Block.................................................................................................................................................. 6

Figure 5 - Connecting the Auxiliary Input................................................................................................................... 6

Figure 4 - RJ45 Pinout ....................................................................................................................................................... 6

Figure 7 - Touch Pad Feedback....................................................................................................................................... 7

Figure 6 - Touch Pad Controls......................................................................................................................................... 7

Figure 8 - Touch Pad Hint................................................................................................................................................. 7

Figure 9 - T1000 Size Diagram ...................................................................................................................................... 19

REV. 6.2.3 / PL-HRDW-T1000-F-EN

Description

The T1000 digital sensors are designed for operation in conjunction with the ProLon VAV or HPS

controllers, to which they provide zone temperature, setpoint and occupancy override information.

The T1000 digital sensors also provide an access point from which to visualize and configure any

parameter on the connected VAV controller through an on-screen menu system.

The T1000 features a circular capacitive touch pad, graphic LCD screen with backlighting and an auxiliary

analog input.

Part Number Selection

General Information

PL-T1000-WGL

Casing Color:

W = White

B = Black

Label Color

GL = Grey Label

WL = White Label

REV. 6.2.3 / PL-HRDW-T1000-F-EN

1. Open casing to remove back cover by pushing on the tab located underneath the thermostat.

(Figure 1)

2. Pull wire(s) through central hole of back cover.

3. Screw in the back cover to the wall.

4. Connect wires:

•If using twisted pair wires:

- Pull out the screw terminal blocks.

- Remove 1 cm insulation from the end of each wire.

- Connect the wires to the terminal blocks and re-connect the terminal blocks. (Figure 2)

•If using CAT5 cable:

- Plug the cable into the RJ45 jack of the T1000 (if CAT5 cable is opened at the controller, refer to

Figure 4 for pinout of the T1000's RJ45 jack).

5. Reconnect top cover.

Installation

IMPORTANT: Do not install the thermostat under the following conditions:

•Any location exposed to direct sunlight

•On an outside wall

•Near an air discharge grill

•In a location where vertical air circulation is restricted

•Near a dimmer switch

INT A

INT B

Figure 1 - Opening Tab Figure 2 - Terminal Block Pinout

REV. 6.2.3 / PL-HRDW-T1000-F-EN

Power and Communication

The T1000 is typically powered by the same controller it is communicating with. It has two different

connector types available for your choice of preferred wiring method.

• The first is a 4-pin, screw-type terminal block suitable for a 4 wire connection

•The second is an RJ45 connector intended for standard CAT5 cable

Through either of these connection methods, the T1000 is powered (24 VAC Class 2) and communicates

over Modbus RTU (RS485, 57600 bps) as a Modbus Master.

Auxiliary Analog Input

The T1000 has an auxiliary analog input which can be used to connect another thermistor. The T1000 can

be configured to use this alternate temperature reading for a variety of functions, including temperature

averaging or radiant floor slab temperature. The alternate thermistor (10KΩ type 3) can be connected to

the auxiliary input using the “AUX IN” and “COM” pins.

COM

24 VAC

B (-)

A (+)

INT A

INT B

Figure 3 - Terminal Block

Figure 5 - Connecting the Auxiliary Input

Figure 4 - RJ45 Pinout

REV. 6.2.3 / PL-HRDW-T1000-F-EN

The T1000 is controlled using the circular touch pad on the bottom half of the thermostat. The touch

pad uses capacitive sensing technology to detect finger proximity. There are no moving parts to push or

rotate. The T1000 is controlled using simple scrolling, tapping or holding motions, performed around the

circle of the touch pad. The center of the circle is unused.

Hint Display

At the bottom of the screen, a circle representing the touch pad is displayed, with hints on how to

navigate and modify settings, as well as providing feedback as you manipulate the touch pad. Hints are

context-sensitive and will only display where logical.

Operation

Scroll clockwise or

counterclockwise

to adjust or navigate

Tap here to

ENTER

Tap here to

go BACK

Figure 6 - Touch Pad Controls

Figure 7 - Touch Pad Feedback Figure 8 - Touch Pad Hint

The black arc

follows your nger

Hold your nger over

highlighted areas to use

special features

REV. 6.2.3 / PL-HRDW-T1000-F-EN

Changing the Setpoint

Schedule Override

Scroll or tap

(any direction)

Heat SP

Cool SP

Adjust your setpoint

by scrolling clockwise

or counterckwise

View current zone

temperature

Home Screen Setpoint Screen

Tap anywhere

(or simply wait)

return to

Home Screen

The sun icon is

displayed when

overridden

OVERRIDE ACTIVE

(Occupied mode)

The moon icon indicates

unoccupied mode

Scroll clockwise

to override

67.5

79.5

67.5

79.5

First, go to the Setpoint Screen.

REV. 6.2.3 / PL-HRDW-T1000-F-EN

Navigating Menus

75.1

Tap here to

go BACK

SCROLL clockwise or

counterclockwise

to navigate through the

current menu level

Tap here to

ENTER

Active Menu

75.1

Hold left

for 8 sec

Conguration

Hold right

for 5 sec

Options and

Visualisation Menu

Configure

From the Home Screen.

REV. 6.2.3 / PL-HRDW-T1000-F-EN

Menu Structure

The T1000 has two menu systems: The first is dedicated to the general options of the T1000 thermostat

as well as visualization of the status of the controller to which it is connected. The second menu system

is dedicated entirely to the configuration settings of the controller to which it is connected. These menu

structures are outlined below.

T1000 Options and Visualisation Menus

Starting from: T1000

Home Screen

75.1

Hold ‘right’

for 5 sec

Temp Unit

Aux Input

Reset Tstat

Sound

Backlight

Language

Rounding

Type

Software Version

Hardware Version

Status 1

Status 2

Status 3

Device Type

Software Version

Hardware Version

Device #

Device Name

Reset Device

Options

About me

Visualize

Device

Andere Handbücher für T1000 Series

Inhaltsverzeichnis

Andere Prolon Zubehör Handbücher

Prolon

Prolon PL-VC2000 Montageanleitung

Beliebte Zubehör Handbücher anderer Marken

Hillco

Hillco 2810 Bedienungsanleitung

Siemens

Siemens QSA2700D Bedienerhandbuch

Contours

Contours ZY024 Bedienungsanleitung

Saivod

Saivod VS621 Bedienungsanleitung

SCE

SCE ENVIRO-THERM SCE-TE170B24VSS Bedienungsanleitung

Z-Wave

Z-Wave HSD-200Z Bedienungsanleitung

turck

turck FMX-IM-2UPLI63FX Bedienungsanleitung

Decagon Devices

Decagon Devices 10HS Bedienungsanleitung

UPPAbaby

UPPAbaby Cup Holder Bedienungsanleitung

Elko

Elko SmartSensor Leakage Wireless Bedienungsanleitung

Grizzly

Grizzly H8371 Bedienungsanleitung

Panasonic

Panasonic HG-T Series Bedienungsanleitung

IFM Electronic

IFM Electronic Efector 250 Series Referenzhandbuch

Virtuox

Virtuox VirtuCLEAN 2.0 Bedienungsanleitung

DigiDesign

DigiDesign 888/24 I/O Bedienungsanleitung

PROZIS

PROZIS QUAY Bedienungsanleitung

patagonia

patagonia PSI Vest Bedienungsanleitung

SFC Energy

SFC Energy EFOY GO! Bedienungsanleitung