Prorack K416 Bedienungs- und Installationshandbuch

K416

Fitting Kit

EN Fitting Instructions for Basic Carrier

x 2 x 1 x 1 x 2

x 1 x 1 x 2 x 2

Revision No: 6F 1

Fitting Kit K416

MAX kgs (lbs)

W/P WHD

Nissan

Tiida Latio , 4dr Sedan 04-+ EU 45 kgs (99 lbs) 45 kgs (99 lbs)

Tiida Latio , 4dr Sedan 04-+ CN 45 kgs (99 lbs) 45 kgs (99 lbs)

Tiida , 4dr Sedan 04-12 NZ 45 kgs (99 lbs) 45 kgs (99 lbs)

Tiida , 4dr Sedan 04-12 ZA 45 kgs (99 lbs) 45 kgs (99 lbs)

Tiida , 4dr Sedan 04-12 AU 45 kgs (99 lbs) 45 kgs (99 lbs)

Tiida , 5dr Hatch 04-12 NZ 45 kgs (99 lbs) 45 kgs (99 lbs)

Tiida , 5dr Hatch 04-12 AU 45 kgs (99 lbs) 45 kgs (99 lbs)

Tiida , 5dr Hatch 05-12 ZA 45 kgs (99 lbs) 45 kgs (99 lbs)

Tiida , 5dr Hatch Jun 07-+ CN 45 kgs (99 lbs) 45 kgs (99 lbs)

Tiida , 5dr Hatch Jun 07-15 EU 45 kgs (99 lbs) 45 kgs (99 lbs)

Versa , 4dr Sedan 07-11 US 45 kgs (99 lbs) 45 kgs (99 lbs)

Versa , 5dr Hatch 07-12 US 45 kgs (99 lbs) 45 kgs (99 lbs)

Fitting Kit EN

K416

First Time Installation

●Remove parts from inside the package and

check. Contact your dealer if any parts are

missing or damaged.

●This kit fits type A, B, C and D.

●These instructions show type A crossbar

fitted. They also apply to type B, C and D.

NOTE: Clamp images in these instructions may

not be representative of the clamps in this kit

Fitting Kit EN

K416

●Use keys to remove covers.

●Use hex screwdriver to reverse adjusting

screw 10 turns.

●Press adjusting screw and pull crossbar

legs out. Refer to the crossbar instructions

for crossbar adjustment method.

●Ensure each end of the crossbar is

adjusted equally.

Fitting Kit EN

K416

●Remove locking screw.

●Apply protective strip as shown.

Trim if required.

●It is important to put the clamps in the

correct position on the vehicle.

●Letters refer to the part numbers stamped

on clamps.

●Clamp Part Number:

A = 560A

B = 562A

C = 561A

Fitting Kit EN

K416

●Attach clamp to each leg. NOTE; clamps

may have labels showing their positions on

the vehicle (For example; "Front Right").

●Refit locking screw so that it goes through

the hole in the clamp. Do not begin to

tighten the locking screw.

●Refer to the underside of the pad for the

part number.

Fitting Kit EN

K416

●It is important to put the pads in the correct

position on the vehicle.

●Letters refer to the pad part numbers and

position.

●Pad Part Number:

A = 11-04-255

B = 11-04-254

C = 11-04-243

●Fit rubber pads (supplied with fitting kit) to

foot. Pad may vary in shape to that shown.

●Make sure the pad fits into the holes

underneath the foot.

Fitting Kit EN

K416

Fitment

●Place crossbar on vehicle. Minimum

recommended spacing between the bars is

700mm (27 1/2") (unless otherwise stated).

●Clamps directly to edge of roof under the

doors

●Please check the rear of this manual for

information relating specifically to your

vehicle.

●Adjust the legs on the crossbar so that they

are positioned equally from the ends of the

crossbar, and the clamps engage firmly on

the body work of the vehicle.

●Tighten adjusting screw to 5 Nm (3.7 ft lb)

hand tight.

Fitting Kit EN

K416

●Tighten locking screw on both legs evenly.

●Check crossbar is securely attached to the

vehicle.

●Use keys to fit and lock covers

Fitting Kit EN

K416

CAUTION: Recheck all fasteners immediately after

a load is applied to the crossbars.

Regularly check screws are tight.

Inhaltsverzeichnis

Andere Prorack Autozubehör Handbücher

Prorack

Prorack K364 Bedienungsanleitung

Prorack

Prorack K182 Bedienungs- und Installationshandbuch

Prorack

Prorack K015 Bedienungsanleitung

Prorack

Prorack K394 Bedienungsanleitung

Prorack

Prorack K031 Bedienungs- und Installationshandbuch

Prorack

Prorack K545 Bedienungsanleitung

Prorack

Prorack K178 Bedienungsanleitung

Prorack

Prorack K992 Bedienungsanleitung

Prorack

Prorack K164 Bedienungsanleitung

Prorack

Prorack K108 Bedienungsanleitung

Prorack

Prorack K002 Bedienungsanleitung

Prorack

Prorack K450 Bedienungsanleitung

Prorack

Prorack K340 Bedienungsanleitung

Prorack

Prorack K067 Bedienungsanleitung

Prorack

Prorack K710 Bedienungsanleitung

Prorack

Prorack K408 Bedienungsanleitung

Prorack

Prorack K070 Bedienungsanleitung

Prorack

Prorack K083 Bedienungsanleitung

Prorack

Prorack K136 Bedienungsanleitung

Prorack

Prorack K595 Bedienungsanleitung

Prorack

Prorack K611 Bedienungsanleitung

Prorack

Prorack K085 Bedienungsanleitung

Prorack

Prorack K1016 Bedienungs- und Installationshandbuch

Prorack

Prorack K104 Bedienungsanleitung

Beliebte Autozubehör Handbücher anderer Marken

James Baroud

James Baroud Odyssey Bedienungsanleitung

Motorola

Motorola i50sx Bedienungsanleitung

Yakima

Yakima 9MM STANDARD BIKE MOUNT Bedienungsanleitung

Feniex

Feniex T3 Bedienungsanleitung

Kia

Kia E8300-4D000 Bedienungsanleitung

Brink

Brink 756843 Bedienungsanleitung

Whispbar

Whispbar K085W Bedienungsanleitung

v.link

v.link CI-VL2-PC-HSD Bedienungsanleitung

Viking

Viking Stack-Rack Kurzanleitung zur Einrichtung

Aries

Aries 203015 Bedienungsanleitung

Choetech

Choetech AT0005 Bedienungsanleitung

ZZ2

ZZ2 ZZAIR-PRO Bedienungsanleitung

Holman

Holman 4A80L Bedienungsanleitung

Thule

Thule 2075 Bedienungsanleitung

Motorola

Motorola T325 Bedienungsanleitung

TAUBENREUTHER

TAUBENREUTHER 16-3950 Installationsanleitung

DV8

DV8 FBJL-02 Bedienungsanleitung

Curt Manufacturing

Curt Manufacturing A25 Bedienungsanleitung