Quantum Internal Storage System Travan 40 GB Bedienungsanleitung
%
7UDYDQ*%,QWHUQDO6WRUDJH6\VWHP
7UDYDQ
8VHU¶V*XLGH8VHU¶V*XLGH8VHU¶V*XLGH8VHU¶V*XLGH8VHU¶V*XLGH8VHU¶V*XLGH
Quantum Travan 40 GB Internal Storage System, P/N 50002765, B01, July 2005
Made in USA.
Quantum Corporation provides this publication “as is” without warranty of any kind, either express or
implied, including but not limited to the implied warranties of merchantability or fitness for a particular
purpose. Quantum Corporation may revise this publication from time to time without notice.
COPYRIGHT STATEMENT
Copyright 2005 by Quantum Corporation. All rights reserved.
Your right to copy this manual is limited by copyright law. Making copies or adaptations without prior
written authorization of Quantum Corporation is prohibited by law and constitutes a punishable violation of
the law.
TRADEMARK STATEMENT
Quantum and the Quantum logo are all registered trademarks of Quantum Corporation. Other trademarks
may be mentioned herein which belong to other companies.
Quantum Travan 40 GB Internal Storage System iii
Contents
Chapter 1 Introduction 1
About This Manual............................................................................................ 1
About Your Travan Tape Drive....................................................................... 2
Chapter 2 Installing the Drive 3
What You Will Need ......................................................................................... 3
Important Precautions....................................................................................... 3
Installation Procedure ....................................................................................... 4
Using The Tape Drive ..................................................................................... 12
Chapter 3 Operation and Maintenance 13
Loading and Unloading Cartridges .............................................................. 13
Handling Travan Cartridges .......................................................................... 14
Setting the Write-Protect Switch.................................................................... 15
Retensioning Tapes.......................................................................................... 16
Cleaning the Tape Drive Mechanism............................................................ 16
Recommended Tape Cartridges .................................................................... 17
iv Quantum Travan 40 GB Internal Storage System
Chapter 4 Troubleshooting 19
Installation troubleshooting............................................................................19
Tape Operations Troubleshooting.................................................................20
Appendix A Disposal of Electrical and Electronic Equipment 21
Quantum Travan 40 GB Internal Storage System 1
Chapter 1
1Introduction
About This Manual 1
This manual describes how to install and operate your new Quantum
Travan 40GB tape drive. The manual also contains information on
troubleshooting and technical support for your new drive.
Note: Wherever a page number is referenced in this online manual,
you can click on the page number to jump to that page. You
can return to the original page by clicking the back button in
your viewer software.
Introduction
About Your Travan Tape Drive
2 Quantum Travan 40 GB Internal Storage System
About Your Travan Tape Drive 1
The Travan 40GB can store up to 40 Gbytes on a single Travan 40
cartridge, and features a data transfer rate of up to 240 Mbytes per
minute.
This drive also includes Quantum FastSense™ technology for optimizing
drive and host data transfer rates.
The Travan 40GB can read and write Travan 40 cartridges. It can read but
not write Travan 20 or NS20 (TR-5) cartridges.
Note: These values are based on 2:1 data compression.
Uncompressed values are one half as high. Capacities, backup
speeds and transfer rates will vary with file type and system
configuration.
Note: This drive cannot use TR-1, TR-2, TR-3, TR-4, or QIC-80
cartridges.
Quantum Travan 40 GB Internal Storage System 3
Chapter 2
2Installing the Drive
What You Will Need 2
You will need a standard flat-bladed screwdriver and a PHILLIPS®
screwdriver to install the tape drive in your computer.
This tape drive must be attached to a secondary IDE port.If your computer
has two IDE ports, and the secondary port is not being used, you may
need to obtain a 40-pin IDE interface cable for your tape drive.
If your computer has only a single IDE port, you will need to obtain a
new ATAPI host adapter that provides a secondary IDE port for the tape
drive. You will also need a second 40-pin IDE interface cable for your
tape drive.
Important Precautions 2
To protect your computer and drive from electrostatic damage, follow
these guidelines:
Before you open your computer or remove the drive from its antistatic
bag, ground yourself by touching the metal chassis of your computer or
Installing the Drive
Installation Procedure
4 Quantum Travan 40 GB Internal Storage System
some other grounded object. For optimal protection, use an electrostatic
grounding strap.
Do not touch any printed circuit boards or electronic chips on your drive
or in your computer.
Installation Procedure 2
Follow the steps below to install the Travan 40GB drive in your
computer.
We recommend that you install your backup software before you install
your tape drive. For more information, see the instructions that came
with the backup software.
1Decide where to attach the tape drive
Before you install your tape drive, you should determine how many
IDE ports your computer has. You may find this information in the
manual for your computer. You can also look inside your computer
and compare your system with figure 1, figure 2, and figure 3.
If your computer has two IDE ports:
Most modern computers have two IDE ports. Each port can support
up to two devices (on a single IDE cable). A hard disk is usually
attached to the primary IDE port, see figure 1. However, the Travan 40
should not be attached to an IDE port that is being used by a hard disc
or a sound card. Thus, you must use the secondary IDE port for your
tape drive.
Note: To be properly grounded, your computer must be plugged into
a grounded electrical outlet.
Installing the Drive
Installation Procedure
Quantum Travan 40 GB Internal Storage System 5
Figure 1 Existing
Computer WithTwo IDE
Ports (Hard Disc
Attached to the Primary
IDE Port)
If no devices or cables are attached to the secondary IDE port (see
figure 1) you will need to obtain a second IDE cable for your tape
drive.
If a CD-ROM or other compatible device is attached to the secondary
IDE port (see figure 2) you can install the tape drive on the same cable
as the CD-ROM.
Computer
Motherboard
Primary
IDE port
Secondary
IDE port
Hard
Disc
Hard
Disc
Attach tape drive and cable her
e
(tape drive must be configured
as "Master")
Installing the Drive
Installation Procedure
6 Quantum Travan 40 GB Internal Storage System
Figure 2 Existing
Computer with Two IDE
Ports (ATAPI Devices on
Both Primary and
Secondary IDE Ports)
Continue to page 7 for instructions on setting the master/slave
jumpers.
If your computer has only one IDE port:
If your computer has only a single IDE port (see figure 3) it is
probably being used by the hard disc drive. You should not attach
your tape drive to an IDE port that is being used by a hard disc or a
sound card.
In this situation, before you can install the tape drive, you must
purchase an ATAPI host adapter that provides a second IDE port.
You will also need a second IDE cable for the tape drive. After
installing the host adapter, set the master/slave jumpers.
Computer
Motherboard
Primary
IDE port
Secondary
IDE port CD-ROM
configured as "Maste
r"
Attach tape drive here
configured as "Slave"
CD-ROM
CD-ROM
Hard
Disc
Hard
Disc
Inhaltsverzeichnis
Andere Quantum Lagerung Handbücher
Quantum
Quantum Scalar i40 Bedienungsanleitung
Quantum
Quantum Scalar 100 Bedienungsanleitung
Quantum
Quantum StorNext QS1200 Bedienungsanleitung
Quantum
Quantum DX100 Bedienungsanleitung
Quantum
Quantum DLTtape DLT 7000 Bedienungsanleitung
Quantum
Quantum SuperLoader DLT Bedienungsanleitung
Quantum
Quantum ValueLoader DLT VS160 Bedienungsanleitung
Quantum
Quantum DXi6701 Bedienerhandbuch
Quantum
Quantum P3000 Series Bedienungsanleitung
Quantum
Quantum P1000 Series Bedienungsanleitung
Quantum
Quantum PX500 Series Bedienungsanleitung
Quantum
Quantum DLTtape DLT 4000 Bedienungsanleitung
Quantum
Quantum DLT 4700 Bedienungsanleitung
Quantum
Quantum DXi2500-D Bedienungsanleitung
Quantum
Quantum Maxtor Fireball lct10 Bedienungsanleitung
Quantum
Quantum StorNext M660 Montageanleitung
Quantum
Quantum ATL M1500 Bedienungsanleitung
Quantum
Quantum StorNext QD7000 Bedienungsanleitung
Quantum
Quantum ValueLoader DLT VS80 Betriebsanleitung
Quantum
Quantum QXS 12G Series Technisches Handbuch
Beliebte Lagerung Handbücher anderer Marken
Spectra Logic
Spectra Logic T-Series Spectra T50e Bedienungsanleitung
Panasonic
Panasonic LKM-F931-1 Bedienungsanleitung
Tabernus
Tabernus Enterprise Erase E2400 Bedienungsanleitung
Rocstor
Rocstor COMMANDER 3F series Bedienungsanleitung
HP
HP P9000 Bedienungsanleitung
Western Digital
Western Digital Ultrastar Data60 Bedienungsanleitung