Razor Pocket Mod Bedienungsanleitung
POCKET MOD Electric Scooter Troubleshooting Guide
Issue Symptom(s) Troubleshoot Result(s) Possible Solution(s)
Product Does Not Run Unit shut off while in use
Lights on throttle do NOT light up Remove battery/motor cover & check fuse
located next to battery Fuse burnt out Replace fuse and correct riding
conditions. (Refer to Pg 6 in Owners
Manual)
Lights on throttle do NOT light up
Motor will not engage Remove battery/motor cover to
check for loose connection(s) Loose connection(s) Reconnect Loose Connection(s)
Motor engages, but unit
will not move Check chain & rear wheel Chain is rotating, but rear wheel does not
move Replace Rear Wheel
Secure unit; turn power on & with NO
weight on the unit, lift back end up
& apply the throttle Rear Wheel Spins Freely Replace Battery or Charger
*Unit should be charged 12 hours before
first initial use and up to 8 hours after each
subsequent use Motor engages Replace Brake Lever
Motor does NOT engage Replace Control Module & Throttle
Product Stops Without
Applying Brakes Unit shut off while in use Remove battery/motor cover & check fuse
located next to battery Fuse burnt out Replace fuse and correct riding
conditions. (Refer to Pg 6 in Owners
Manual)
Lights on throttle do NOT light up
Motor will not engage Remove battery/motor cover to
check for loose connection(s) Loose connection(s) Reconnect Loose Connection(s)
Chain too loose Adjust chain
Chain slipped off rear sprocket Check chain for possible damage
[Replace chain if necessary]
(Refer to Pg 5 in Owner's Manual)
Chain is jammed in chain
tensioner
Remove chain from chain tensioner;
check chain & chain tensioner for
possible damage
[Replace part(s) if necessary];
place chain back on rear sprocket
(Refer to Pg 5 in Owners manual)
Turn power off & manually turn gear on
motor shaft with your fingers Gear does NOT turn freely Replace Motor
*Always check to make sure charger is
plugged into charger port correctly & lights
on charger are working properly
Lights on throttle light up Check tension; position & the
condition of chain
Remove battery/motor cover & unplug
brake connector from control module
Secure unit; turn power on
& apply throttle
Lights on throttle light up
Unit worked, but
will not go after charging
12/21/2006 1
POCKET MOD Electric Scooter Troubleshooting Guide
Issue Symptom(s) Troubleshoot Result(s) Possible Solution(s)
Fuse Keeps Burning Out Check riders weight & riding conditions Replace fuse and correct riding
conditions. (Refer to Pg 6 in Owners
Manual)
Loose connection(s) Reconnect Loose Connection(s)
No loose connection(s) or
wire(s) touching Replace Control Module
Product Has Short Ride Time
or
Product Runs Slow
Check riders weight & riding conditions Replace fuse and correct riding
conditions. (Refer to Pg 6 in Owners
Manual)
or
Product Does Not Hold A Charge Air pressure in front & rear tires Tire pressure low Inflate tire(s) to recommended PSI
(Located on tire sidewall)
Check chain tension Chain too tight Adjust chain
and/or Check brake cable Brake lever feels stiff when
squeezed/cable too tight Squeeze brake lever firmly several
times to loosen up the brake cable
Unit runs (very) slow Make sure charger is plugged into charger
port correctly & indicator lights are
working properly
Charger not plugged into
charger port correctly
Correctly plug charger into charger
port & charge unit for 8 hrs. Refer to Pg
3 in Owner's Manual
Secure unit; turn power on & with NO
weight on the unit, lift back end up & apply
the throttle Rear Wheel Spins Freely Replace Battery
Rear wheel barely moves Lift rear end up & manually
spin rear wheel forward
Should spin 3-4 times w/no resistance Wheel does not spin freely Replace Rear Wheel
Product Runs Intermittently Gently wiggle the wires around the throttle
for loose wires(s) Unit will go when wire(s) are
wiggled/Wire(s) loose Replace Throttle
Remove battery/motor cover to
check for loose connection(s) Loose connection(s) Reconnect Loose Connection(s)
Motor engages/Unit runs again Replace Brake Lever
Motor does NOT engage Replace Throttle & Control Module
Battery shows fully charged, but goes
low after only 10-15
minutes of use
Remove battery/motor cover & check for
loose connection(s) and/or wire(s)
Note: Product ride time can be reduced
any where from 10-20 minutes, on a fully
charged battery, depending on riders
weight; various riding conditions and/or
if product has been properly maintained
Remove battery/motor cover & unplug
brake connector from Control Module.
Secure unit; turn power on
& apply throttle
Unit cuts in & out while in use
Power skipped several times while in
use, now will not start
12/21/2006 2
POCKET MOD Electric Scooter Troubleshooting Guide
Issue Symptom(s) Troubleshoot Result(s) Possible Solution(s)
Chain Keeps Coming Off Check chain tension Chain is too loose/too tight Adjust chain
Rear wheel out of alignment
A
djust rear wheel
(Refer to Pg 5 in Owner's Manual)
Gear on motor shaft is bent Replace Motor
Inspect chain tensioner Chain tensioner broken Replace Chain Tensioner
Brakes Do Not Work Properly Remove battery/motor cover to
check for loose connection(s) Loose connection(s) Reconnect Loose Connection(s)
Check for loose wire(s)
around the brake lever(s) Wire(s) loose Replace Brake Lever
Check brake cable(s) for damage Cable damaged Replace Brake Lever
Power Stays On When Unit
Is Turned Off Throttle lights stay on when power
switch is turned off Double check the power switch
is in the off position Power switch is in off position Replace Power Switch
Product Makes 'Grinding' Noise Check that brake is not
rubbing against the rear wheel Brakes are rubbing
A
djust brakes (Refer to
Pg 4 in Owner's Manual)
Dirt & debris found in chain and/or chain
is dry Remove any dirt/debris from chain.
Lubricate chain w/WD40®
Chain tension too tight Adjust chain
Unit runs, but rear wheel
barely moves
Lift rear end up & manually
spin rear wheel forward
Should spin 3-4 times w/no resistance Wheel does not spin freely Replace Rear Wheel
Turn power off & manually turn gear on
motor shaft with your fingers Gear on motor shaft is tight
Does not turn easily Replace Motor
Still makes grinding noise Replace Motor
No grinding noise Replace Rear Wheel
Turn power switch off; remove chain from
rear wheel;
turn power on & apply throttle
Chain does not rotate freely
Unit makes grinding noise
when in use Inspect chain
Unit does not stop when
brakes are applied
Sprocket on rear wheel is aligned properly
with gear on motor shaft
12/21/2006 3
POCKET MOD Electric Scooter Troubleshooting Guide
Issue Symptom(s) Troubleshoot Result(s) Possible Solution(s)
Product Makes 'Clicking' Sound Rear wheel barely moves Lift rear end up & manually
spin rear wheel forward
Should spin 3-4 times w/no resistance Wheel does not spin freely Replace Rear Wheel
Remove battery/motor cover to
check for loose connection(s) Loose connection(s) Reconnect Loose Connection(s)
Secure unit; turn power on & with NO
weight on the unit, lift back end up
& apply the throttle Rear Wheel Spins Freely eplace Battery or Charger
Motor engages/Rear wheel spins Replace Brake Lever
Motor does NOT engage Replace Throttle & Control Module
Throttle Sticks Grip is pressed up against the throttle Slide throttle away from grip
Reminder: Applying the brakes will cut power
to the motor and stop product Grip is NOT pressed against
throttle Replace throttle
Rear Wheel Locked Up
While In Use Lights on throttle light up Check chain for foreign object(s)
and/or debris Foreign object(s) found
in chain
Remove chain guard to clean anything
caught in chain
Check chain; rear sprocket & chain
tensioner for any damage
[Replace part(s) if necessary]
Inspect spring inside brake plate
Brake spring is broken
Replace Rear Wheel
Chain too loose Adjust chain
Chain slipped off rear sprocket Check chain for possible damage
[Replace chain if necessary]
(Refer to Pg 5 in Owner's Manual)
Chain is jammed in chain
tensioner
Remove chain from chain tensioner;
check chain & chain tensioner for
possible damage
[Replace part(s) if necessary];
place chain back on rear sprocket
(Refer to Pg 5 in Owners Manual).
Inspect chain tensioner Chain tensioner broken Replace Chain Tensioner
Check if handlebar grip is
pressing up against throttle
Throttle does not spring
back when released
Check tension; position & the
condition of chain
Remove battery/motor cover & unplug
brake connector from control module.
Secure unit; turn power on & apply throttle
Battery shows fully charged
Lights on throttle light up
Unit does not move
12/21/2006 4
Andere Handbücher für Pocket Mod
4
Inhaltsverzeichnis
Andere Razor Roller Handbücher
Razor
Razor Monster kix Bedienungsanleitung
Razor
Razor FLASHBACK Bedienungsanleitung
Razor
Razor RX200 Bedienungsanleitung
Razor
Razor E Prime Bedienungsanleitung
Razor
Razor Siege Bedienungsanleitung
Razor
Razor E100 series Bedienungsanleitung
Razor
Razor rambler 16 Bedienungsanleitung
Razor
Razor Plegable Bedienungsanleitung
Razor
Razor FOLDING KIDDIE KICK Bedienungsanleitung
Razor
Razor E Prime Bedienungsanleitung
Razor
Razor E Prime III Bedienungsanleitung
Razor
Razor Dirt Rocket MX350 Bedienungsanleitung
Razor
Razor R Tec Bedienungsanleitung
Razor
Razor Pocket Mod Bedienungsanleitung
Razor
Razor Ecosmart metro 13114501 Bedienungsanleitung
Razor
Razor 13111261 Bedienungsanleitung
Razor
Razor E Prime Bedienungsanleitung
Razor
Razor C25 Bedienungsanleitung
Razor
Razor PowerRider 360 Bedienungsanleitung
Razor
Razor A5 DLX Bedienungsanleitung
Beliebte Roller Handbücher anderer Marken
First Choice Mobility
First Choice Mobility Roma Medical Corella S741 Bedienungsanleitung
Carrera
Carrera impel Bedienungsanleitung
Afikim
Afikim Superlight SL-3 Bedienungsanleitung
CareCo
CareCo ZOOM Bedienungsanleitung
Douglas
Douglas Vespa G.S. Bedienungsanleitung
Gazelle
Gazelle with BOSCH System Bedienungsanleitung